When to replace the Oil Filter on your ALFA ROMEO BRERA
Recommended replacement interval for the part category Oil filter : 2 year / 30000 km
Important!
This replacement procedure can be used for:
ALFA ROMEO Brera (939_) 2.2 JTS (939.DXB11) View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Oil Filter for Brera (939_) and other ALFA ROMEO models
Tools
Replacement: engine oil and filter – ALFA ROMEO BRERA. Tools you'll need:
All-purpose cleaning spray
Drive socket # 17
Drive socket # 36
Ratchet wrench
Torque wrench
Flat Screwdriver
Oil drain pan
Funnel
Fender cover
Replacement: engine oil and filter – ALFA ROMEO BRERA. AUTODOC recommends:
  • Replace the oil filter every time when changing motor oil.
  • All work should be done with the engine stopped.
  • Wear gloves to prevent contact with hot liquid.
Replacement: engine oil and filter – ALFA ROMEO BRERA. Take the following steps:
  1. Step 1
    Open the hood.
    Step 2
    Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.
    Step 3
    How to change Oil Filter on Alfa Romeo Brera 2006 - free PDF and video manuals
    Unscrew the oil filler plug.
  2. Step 4
    Lift the car using a jack or place it over an inspection pit.
    Replacement: engine oil and filter – ALFA ROMEO BRERA. AUTODOC recommends:
    The vehicle must be on even keel, and if it is at an angle, the drain plug must be at the lowest point.
    Step 5
    How to replace ALFA ROMEO Brera (939_) 2.4 JTDM 20V (939DXD1B, 939DXD12) 2007 Oil Filter - step-by-step manuals and video guides
    Put a waste oil container with at least 5 l capacity under the drainage hole.
  3. Step 6
    Alfa Romeo Brera 2.4 JTDM 20V (939DXD1B, 939DXM1B) 2008 Oil Filter replacement: free workshop manuals
    Clean the area of the oil pan drainage hole. Use all-purpose cleaning spray.
  4. Step 7
    Changing Oil Filter on ALFA ROMEO Brera (939_) 3.2 JTS Q4 (939.DXG22) 2009 by yourself
    Unscrew the drain plug. Use a drive socket #17. Use a ratchet wrench.
  5. Step 8
    How to remove ALFA ROMEO BRERA 2.0 JTDM (939DXP1B) 2010 Oil Filter - online easy-to-follow instructions
    Drain the used oil.
    Replacement: engine oil and filter – ALFA ROMEO BRERA. AUTODOC experts recommend:
    Caution! The oil may be hot.
  6. Step 9
    How to replace Oil Filter on ALFA ROMEO Brera (939_) 2011: download PDF manuals and video instructions
    Unscrew the filter housing cap together with the old filter element. Use a drive socket #36. Use a ratchet wrench.
  7. Step 10
    How hard is it to do yourself: Oil Filter replacement on Alfa Romeo Brera 3.2 JTS (939DXG2B, 939DXG1B) 2006 - download illustrated guide
    Prepare a container for the old oil filter.
  8. Step 11
    Need to know how to renew Oil Filter on ALFA ROMEO BRERA 2007? This free workshop manual will help you to do it yourself
    Put the old oil filter in the container.
    AUTODOC recommends:
    Move up the container. The oil starts to drain out of the drainage hole immediately after you have removed the oil filter.
  9. Step 12
    Changing of Oil Filter on Alfa Romeo Brera 2008 won't be an issue if you follow this illustrated step-by-step guide
    Detach the oil filter from the filter cover.
  10. Step 13
    ALFA ROMEO BRERA 2.4 JTDM 20V (939DXD1B, 939DXD12) Oil Filter replacement: online guides and video tutorials
    Remove the oil filter cover O-ring. Use a flat screwdriver.
  11. Step 14
    Replacing Oil Filter on Alfa Romeo Brera 2010 2.4 JTDM 20V (939DXD1B, 939DXD12) by yourself
    Clean the oil filter housing cap. Use all-purpose cleaning spray.
  12. Step 15
    Brera (939_) 2.0 JTDM (939DXP1B) 2011 Oil Filter DIY replacement workshop manual
    Install a new O-ring to its mounting seat on the filter cover.
  13. Step 16
    How to change Oil Filter on ALFA ROMEO Brera (939_) 2006 - tips and tricks
    Install the new oil filter to the mounting seat on the filter cover.
    Please note!
    Make sure to install the filter correctly. Don't mix up the sides of the part.Wait until the oil has completely drained from the drainage hole.
  14. Step 17
    Screw the new filter into its place.
    Step 18
    Step-by-step recommendations for DIY replacement Alfa Romeo Brera 2007 2.0 JTDM (939DXP1B) Oil Filter
    Lubricate the rubber seal of the new filter with a little amount of fresh oil.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Searching for the right tyres?

Find out which tyre and wheel sizes are compatible with the ALFA ROMEO Brera (939) model.

Your profile is your personal assistant.

It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents

Install the AUTODOC CLUB app!
Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.
ALFA ROMEO Brera (939_) Oil Filter replace by yourself - Scan QR-code and download AUTODOC CLUB app
Scan

To download the app:

  • - scan the QR code
  • - download from App Store
  • - download from Google Play
DIY ALFA ROMEO Brera (939_) Oil Filter replacement - online guide
Tips & tricks for your ALFA ROMEO Brera (939_)
View more
  • How to change Oil filters on ALFA ROMEO Brera (939_) 2.2 JTS (939.DXB11) - replacement tricks
    How to swap the engine on a BMW E30 Turbo | SUPERCAR AUTODOC
  • Changing Engine oil filter Alfa Romeo Brera 2.4 JTDM 20V (939DXD1B, 939DXD12) - Replacement Tips
    5 Tips for New Drivers | AUTODOC tips
  • Maintenance Hacks - ALFA ROMEO Brera (939_) 2.4 JTDM 20V (939DXD1B, 939DXM1B) Oil filters replacement guide
    How to unlock your car without a key | AUTODOC tips
  • Replace Engine oil filter on Alfa Romeo Brera - free video tips
    Top 5 mistakes when working in the engine bay | AUTODOC tips

Professional manuals for the most common ALFA ROMEO models