
Disclaimer
How to change brake drum on VW DERBY (86) – replacement guide
downloads:
1
Views:
7

Recommended replacement interval for the part category Brake drum : 100000 km
Important!
This replacement procedure can be used for:
VW DERBY (86) 1.3, VW DERBY (86) 1.3, VW DERBY (86) 1.1, VW DERBY (86) 0.9 … View more
The steps may slightly vary depending on the car design.
VW DERBY (86) 1.3, VW DERBY (86) 1.3, VW DERBY (86) 1.1, VW DERBY (86) 0.9 … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Brake Drum for DERBY (86) and other VW models
Brake drum
Alternative products

All-purpose cleaning spray
Copper grease
Torque wrench
Drive socket # 30
Wheel impact socket #17
Ratchet wrench
Flat screwdriver
Hammer
Pliers
Crow bar
Rubber mallet
Wheel chock
Replacement: brake drum – VW DERBY (86). AUTODOC experts recommend:
- Replace the brake drums on VW DERBY (86) in pair for the rear axle. Disregarding the parts state. It ensures even braking.
- The replacement procedure is identical for the right and left brake drums on the same axle.
- When replacing the brake drums, be sure to also change the brake shoes.
- Please note: all work on the car – VW DERBY (86) – should be done with the engine switched off.
Carry out replacement in the following order:
- Step 1Secure the wheels with chocks.Step 2Loosen the wheel mounting bolts. Use wheel impact socket #17.
- Step 3Raise the rear of the car and secure on supports.Step 4Unscrew the wheel bolts.AUTODOC recommends:Warning! To avoid injury, hold the wheel while unscrewing the fastening bolts. VW DERBY (86)
- Step 5Remove the wheel.
- Step 6Remove the wheel hub nut cap. Use a crowbar. Use a hammer.
- Step 7Remove the cotter pin securing the hub nut. Use a crowbar. Use a flat screwdriver.
- Step 8Unscrew the hub nut. Use a drive socket #30. Use a ratchet wrench.
- Step 9Remove the fastening nut.
- Step 10Remove the brake drum assembled with the wheel hub bearing.
- Step 11Clean the hub bearing mounting seat. Use all-purpose cleaning spray.
- Step 12Install the new brake drum assembled with the wheel hub bearing.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the VW Derby I (86) model
Popular maintenance tutorials for VW Derby 86
Complete guides for changing the Drum brakes on different VW DERBY models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your VW DERBY (86)
View more
- How to inspect and troubleshoot your car heater when it’s not working
- Kolbenschmidt plastic gauge overview
- 3 essential tips for choosing summer tyres | Get ready for warmer weather
- 5 Essential Tips for beginner drivers: Avoid Common Mistakes
Most commonly replaced car parts on VW DERBY
Time to replace parts? Get even better deals in our Shop app.

SCAN ME