Important!
This replacement procedure can be used for:
CITROËN XM (Y4) 2.1 D12 VSX, CITROËN XM (Y4) 2.1 TD 12V, CITROËN XM (Y4) 3.0 V6 24V, CITROËN XM (Y4) 3.0 V6, CITROËN XM (Y4) 3.0 V6, CITROËN XM (Y4) 2.5 TD, CITROËN XM (Y4) 2.0 Turbo, CITROËN XM (Y4) 2.0 i 16V View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

Tools
Replacement: track rod end – CITROËN XM (Y4). Tools you need:
Wire brush
WD-40 spray
Brake cleaner
Copper grease
Combination spanner #20
Combination spanner #22
Drive socket # 17
Wheel impact socket #19
Ratchet wrench
Torque wrench
Vernier caliper
Tap wrench
Hammer
Pin punch
Wheel chock
Replacement: track rod end – CITROËN XM (Y4). AUTODOC recommends:
  • Replace tie rod ends in pairs.
  • The replacement procedure is identical for the right and left tie rod ends.
  • Please note: all work on the car – CITROËN XM (Y4) – should be done with the engine switched off.
Carry out replacement in the following order:
  1. Step 1
    How to change Track Rod End on Citroën XM Y4 1994 - free PDF and video manuals
    Secure the wheels with chocks.
  2. Step 2
    How to replace CITROËN XM (Y4) 2.1 TD 12V 1995 Track Rod End - step-by-step manuals and video guides
    Loosen the wheel mounting bolts. Use wheel impact socket #19.
  3. Step 3
    Raise the front of the car and secure on supports.
    Step 4
    Citroën XM Y4 2.5 TD 1996 Track Rod End replacement: free workshop manuals
    Unscrew the wheel bolts.
    Replacement: track rod end – CITROËN XM (Y4). Tip:
    To avoid injury, hold up the wheel when unscrewing the bolts.
  4. Step 5
    Changing Track Rod End on CITROËN XM (Y4) 3.0 V6 1997 by yourself
    Remove the wheel.
  5. Step 6
    How to remove CITROËN XM 2.0 i 16V 1998 Track Rod End - online easy-to-follow instructions
    When deinstalling, mark or measure the precise position of the ball joint on the track rod, or count the number of turns in order to prevent misalignment afterward. Use a vernier caliper.
  6. Step 7
    How to replace Track Rod End on CITROËN XM (Y4) 1999: download PDF manuals and video instructions
    Loosen the lock nut securing the tie rod end to the tie rod. Use a combination spanner #22.
  7. Step 8
    How hard is it to do yourself: Track Rod End replacement on Citroën XM Y4 3.0 V6 24V 2000 - download illustrated guide
    Clean the fastener connecting the tie rod end to the steering knuckle. Use a wire brush. Use WD-40 spray.
  8. Step 9
    Need to know how to renew Track Rod End on CITROËN XM 1994? This free workshop manual will help you to do it yourself
    Unscrew the end fastening nut to the steering knuckle. Use a drive socket #17. Use a tap wrench.
  9. Step 10
    Changing of Track Rod End on Citroën XM Y4 1995 won't be an issue if you follow this illustrated step-by-step guide
    Disconnect the tie rod end from the steering knuckle. Use a pin punch. Use a hammer.
  10. Step 11
    CITROËN XM 3.0 V6 (SFZ (ZPJ/Z)) Track Rod End replacement: online guides and video tutorials
    Screw the end out of the tie rod.
  11. Step 12
    Replacing Track Rod End on Citroën XM Y4 1997 2.1 TD 12V by yourself
    Clean the mounting seats of the tie rod end. Use a wire brush. Use WD-40 spray.
  12. Step 13
    XM (Y4) 2.0 i 16V 1998 Track Rod End DIY replacement workshop manual
    Screw on a new tie rod end.
    Replacement: track rod end – CITROËN XM (Y4). AUTODOC experts recommend:
    While installing the steering rod end remember to make the same number of turns or to leave the same length of thread showing as per your measurements.
  13. Step 14
    How to change Track Rod End on CITROËN XM (Y4) 1999 - tips and tricks
    Connect the tie rod end to the steering knuckle.
  14. Step 15
    Step-by-step recommendations for DIY replacement Citroën XM Y4 2000 2.0 i 16V Track Rod End
    When deinstalling, mark or measure the precise position of the ball joint on the track rod, or count the number of turns in order to prevent misalignment afterward. Use a vernier caliper.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Searching for the right tyres?

Find out which tyre and wheel sizes are compatible with the CITROËN XM II Hatchback (Y4) model.

Your profile is your personal assistant.

It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents

Install the AUTODOC CLUB app!
Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.
CITROËN XM (Y4) Track Rod End replace by yourself - Scan QR-code and download AUTODOC CLUB app
Scan

To download the app:

  • - scan the QR code
  • - download from App Store
  • - download from Google Play
DIY CITROËN XM (Y4) Track Rod End replacement - online guide
Tips & tricks for your CITROËN XM (Y4)
View more
  • How to change Tie rod end on CITROËN XM (Y4) 2.0 Turbo - replacement tricks
    How to restore a steering wheel | AUTODOC tips
  • Changing Outer tie rod Citroën XM Y4 2.1 TD 12V - Replacement Tips
    How to check your head gasket | AUTODOC
  • Maintenance Hacks - CITROËN XM (Y4) 2.5 TD Track rod end ball joint replacement guide
    5 tools that make car repair incredibly simple | AUTODOC tips
  • Replace Outer tie rod end on Citroën XM Y4 - free video tips
    How to unlock your car without a key | AUTODOC tips