Disclaimer
How to change spark plugs on VAUXHALL Ampera (R12) – replacement guide
downloads:
7
Views:
49
Recommended replacement interval for the part category Spark plug : 10 year / 160000 km
Important!
This replacement procedure can be used for:
VAUXHALL Ampera (R12) EV 150 (D1JOI) … View more
The steps may slightly vary depending on the car design.
VAUXHALL Ampera (R12) EV 150 (D1JOI) … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Spark Plug for Ampera (R12) and other VAUXHALL models
Alternative products

Electronic spray
High-temperature anti-seize lubricant
Spark plug socket # 16
Torx bit T40
Ratchet wrench
Torque wrench
Flat Screwdriver
Telescoping magnet
Crow bar
Fender cover
Replacement: spark plugs – VAUXHALL AMPERA. Tip from AUTODOC:
- The replacement procedure is the same for all spark plugs.
- All work should be done with the engine stopped.
Replacement: spark plugs – VAUXHALL AMPERA. Use the following procedure:
- Step 1Open the hood.Step 2Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.Step 3
Remove the engine cover.Replacement: spark plugs – VAUXHALL AMPERA. Tip:Raise the engine cover, holding it on two sides simultaneously. - Step 4
Detach the connector from the ignition coil. - Step 5
Unscrew the ignition coil bracket. Use Torx T40. Use a ratchet wrench. - Step 6
Pry up the ignition coil. Use a crowbar. Take out the ignition coil from the spark plug well. - Step 7
Clean dirt, dust and debris from inside the spark plug wells. - Step 8
Unscrew the spark plugs. Use the spark plug socket #16. Use a ratchet wrench. - Step 9
Take out the spark plugs. Use a telescoping magnet. - Step 10
Apply a thin layer of a special high temperature anti-seize lubricant to the threads of the new spark plugs. - Step 11
Install the new spark plugs into their mounting seats. Use the spark plug socket #16. - Step 12
Screw new spark plugs and tighten them. Use the spark plug socket #16. Use a torque wrench. Tighten it to 25 nm torque.Replacement: spark plugs – VAUXHALL AMPERA. AUTODOC experts recommend:Don't tighten the plugs with excessive force. Exceeding tightening torque can damage the thread connection. Be careful when working with a spark plug wrench. Its skewing can cause damage to the threaded connection. - Step 13
Treat the ignition coil tips. Use high-temperature grease. Use a flat screwdriver.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the VAUXHALL Ampera (R12) model
Popular maintenance tutorials for VAUXHALL AMPERA
Complete guides for changing the Engine spark plug on different VAUXHALL AMPERA models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your VAUXHALL Ampera (R12)
View more
Engine Overheating? Replace Your Cooling Fan to Fix It
How to remove rust | AUTODOC tips
Checking the starter without removing it | AUTODOC tips
#DIY Guide: How to Fix a Cracked Windscreen Without a Garage Visit
Most commonly replaced car parts on VAUXHALL AMPERA
Time to replace parts? Get even better deals in our Shop app.

SCAN ME

























