
Disclaimer
How to change rear wheel bearing on OPEL Astra G Coupe (T98) – replacement guide
downloads:
0
Views:
7
Important!
This replacement procedure can be used for:
OPEL Astra G Coupe (T98) 1.6 16V (F07), OPEL Astra G Coupe (T98) 1.8 16V (F07), OPEL Astra G Coupe (T98) 2.0 16V Turbo (F07), OPEL Astra G Coupe (T98) 1.8 16V (F07), OPEL Astra G Coupe (T98) 2.2 16V (F07), OPEL Astra G Coupe (T98) 2.2 DTI (F07), OPEL Astra G Coupe (T98) 2.0 16V Turbo (F07), OPEL Astra G Coupe (T98) 2.0 16V Turbo (F07), OPEL Astra G Coupe (T98) 1.6 16V (F07) … View more
The steps may slightly vary depending on the car design.
OPEL Astra G Coupe (T98) 1.6 16V (F07), OPEL Astra G Coupe (T98) 1.8 16V (F07), OPEL Astra G Coupe (T98) 2.0 16V Turbo (F07), OPEL Astra G Coupe (T98) 1.8 16V (F07), OPEL Astra G Coupe (T98) 2.2 16V (F07), OPEL Astra G Coupe (T98) 2.2 DTI (F07), OPEL Astra G Coupe (T98) 2.0 16V Turbo (F07), OPEL Astra G Coupe (T98) 2.0 16V Turbo (F07), OPEL Astra G Coupe (T98) 1.6 16V (F07) … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Wheel Bearing for Astra G Coupe (T98) and other OPEL models
Wheel bearing kit
Alternative products

Wire brush
WD-40 spray
Brake cleaner
Electronic spray
Copper grease
Torque wrench
Combination spanner #13
Combination spanner #17
Drive socket # E8
Drive socket # 13
Drive socket # 16
Drive socket # E20
Torx bit T30
Wheel impact socket #17
Ratchet wrench
Tap wrench
Hammer
Water pump pliers
Crow bar
Wheel chock
Replacement: wheel bearing – OPEL ASTRA G Coupe (F07_). AUTODOC experts recommend:
- Do not re-use the bearing assembly of your OPEL ASTRA G Coupe (F07_) car.
- The wheel hub bearing replacement procedure is identical for both wheels on the same axle.
- Please note: all work on the car – OPEL ASTRA G Coupe (F07_) – should be done with the engine switched off.
Carry out replacement in the following order:
- Step 1Secure the wheels with chocks.Step 2Loosen the wheel mounting bolts. Use wheel impact socket #17.
- Step 3Raise the rear of the car and secure on supports.Step 4Unscrew the wheel bolts.AUTODOC recommends:Warning! To avoid injury, hold the wheel while unscrewing the fastening bolts. OPEL ASTRA G Coupe (F07_)
- Step 5Remove the wheel.
- Step 6Clean the brake caliper fasteners. Use a wire brush. Use WD-40 spray.
- Step 7Release the parking brake cable. Use water pump pliers. Use a crowbar.
- Step 8Unscrew the brake caliper fastening. Use a combination spanner #13. Use a combination spanner #17.
- Step 9Spread the brake pads. Use a crowbar.
- Step 10Remove the brake caliper.Replacement: wheel bearing – OPEL ASTRA G Coupe (F07_). Tip from AUTODOC:Tie the caliper to the suspension or to the body with a wire without disconnecting from the brake hose to prevent depressurization of the brake system.Make sure that the brake caliper is not hanging on the brake hose.Don't press the brake pedal after the brake caliper has been removed. As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur. Check the brake caliper bracket, brake caliper guide pins and boots. Clean them. Replace, if necessary.
- Step 11Remove the brake pads. Use a crowbar.
- Step 12Clean the brake caliper bracket fasteners. Use a wire brush. Use a brake cleaner.AUTODOC recommends:Replacement: wheel bearing – OPEL ASTRA G Coupe (F07_). After applying the spray, wait a few minutes.
- Step 13Unscrew the caliper bracket fastening. Use a drive socket #Е20. Use a tap wrench.
- Step 14Remove the caliper bracket.
- Step 15Clean the brake disc fasteners. Use a wire brush. Use WD-40 spray.
- Step 16Unscrew the brake disc fastening. Use Torx T30. Use a ratchet wrench.
- Step 17Remove the brake disc. Use a hammer.
- Step 18Disconnect the ABS sensor wiring.
- Step 19Detach the ABS sensor connector. Use a crowbar.
- Step 20Clean the fasteners of the wheel hub bearing. Use a wire brush. Use WD-40 spray.
- Step 21Unscrew the hub bearing nuts. Use a drive socket #16. Use a ratchet wrench.
- Step 22Unscrew the fastener of the ABS wiring harness bracket. Use a drive socket #Е8. Use a ratchet wrench.
- Step 23Remove the ABS wiring harness bracket.Step 24Remove the hub bearing together with the brake disc protection plate.
- Step 25Clean the hub bearing mounting seat. Use a wire brush. Use WD-40 spray.
- Step 26Detach the hub bearing from the brake disc protection plate. Use a hammer.
- Step 27Treat the fasteners of the wheel hub bearing. Use copper grease.
- Step 28Install a new wheel hub bearing.Step 29Install the hub bearing together with the brake disc protection plate.
- Step 30Screw in the hub bearing nuts. Use a drive socket #16. Use a ratchet wrench.
- Step 31Tighten the hub bearing nuts. Use a drive socket #16. Use a torque wrench. Tighten it to 50 Nm torque.+45°AUTODOC recommends:Important! Be sure to use new fasteners.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the OPEL Astra G Coupe (T98) model
Popular maintenance tutorials for Opel Astra G Coupe
Complete guides for changing the Wheel bearings on different OPEL ASTRA models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your OPEL Astra G Coupe (T98)
View more
- How to Use Sandblasting Equipment: Step-by-Step Guide | AUTODOC Tips
- How to Fix P0401 ✅ error code Insufficient EGR flow
- 5 possible reasons why your car heater isn't working
- How do EGR valves work? | AUTODOC
Most commonly replaced car parts on OPEL ASTRA
Time to replace parts? Get even better deals in our Shop app.

SCAN ME