Important!

This replacement procedure can be used for:
VW T-Cross (C11_) 1.6 TDi, VW T-Cross (C11_) 1.0 TSi, VW T-Cross (C11_) 1.0 TSi … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Strut Mount for T-Cross (C11_) and other VW models

Top Strut Mounting

Repair Kit, suspension strut

Anti-Friction Bearing, suspension strut support mounting

        Top Strut Mounting for VW T-Cross (C11_) 1.0 TSi Petrol (95 hp)
      
        Top Strut Mounting for VW T-Cross (C11_) 1.0 TSi Petrol (116 hp)
      
        Top Strut Mounting for VW T-Cross (C11_) 1.6 TDi Diesel (95 hp)

Replacement: strut mount – VW T-Cross (C11_). Tools you might need:

                        Wire brush
                      
                        WD-40 spray
                      
                        Brake cleaner 
                      
                        Ceramic grease
                      
                        Copper grease 
                      
                        Torque wrench
                      
                        Combination spanner #18
                      
                        Drive socket # 13
                      
                        Drive socket # 16
                      
                        Drive socket # 18
                      
                        Shock absorber socket DD#5,2
                      
                        Shock absorber socket DD#6
                      
                        Torx bit T25
                      
                        Wheel impact socket #17
                      
                        Ratchet wrench
                      
                        Vice
                      
                        Crow bar
                      
                        Hydraulic transmission jack
                      
                        Wheel chock

Buy tools

Replacement: strut mount – VW T-Cross (C11_). Tip from AUTODOC experts:

The replacement procedure is identical for the mounts of the right and left shock absorbers of the rear suspension.
Both mounts of the rear shock struts should be replaced simultaneously.
Please note: all work on the car – VW T-Cross (C11_) – should be done with the engine switched off.

Carry out replacement in the following order:

Step 1

Secure the wheels with chocks.

Step 2

Loosen the wheel mounting bolts.Use wheel impact socket #17.
Step 3

Raise the car.

Replacement: strut mount – VW T-Cross (C11_). Tip from AUTODOC experts:

If you are using a jack, make sure it rests on a flat surface without any unevenness.Be sure to additionally secure the car with jack stands.

Step 4

Unscrew the wheel bolts.

AUTODOC recommends:

Warning! To avoid injury, hold the wheel while unscrewing the fastening bolts. VW T-Cross (C11_)
Step 5

Remove the wheel.
Step 6

Clean the lower shock absorber fastener.Use a wire brush.Use WD-40 spray.
Step 7

Support the rear knuckle.Use a hydraulic transmission jack.
Step 8

Unscrew the lower fastener of the shock absorber.Use a combination spanner #18.Use a drive socket #18.Use a ratchet wrench.
Step 9

Clean the locker fasteners.Use a wire brush.
Step 10

Unscrew the locker fasteners.Use Torx T25.Use a ratchet wrench.
Step 11

Move the locker aside to gain access to the upper shock absorber fasteners.
Step 12

Clean the charcoal canister fastener.Use a wire brush.Use WD-40 spray.
Step 13

Unscrew the charcoal canister fastener.Use a drive socket #13.Use a ratchet wrench.
Step 14

Move the charcoal canister aside to gain access to the upper shock absorber fasteners.
Step 15

Clean the fasteners of the shock absorber upper mount.Use a wire brush.Use WD-40 spray.
Step 16

Unscrew the shock absorber mount fasteners.Use a drive socket #16.Use a ratchet wrench.
Step 17

Remove the fastening bolts.
Step 18

Lower the hydraulic transmission jack by 10-15 cm.
Step 19

Remove the fastening bolt.
Step 20

Remove the shock absorber.
Step 21

Clean the shock absorber mounting seats.Use a wire brush.Use WD-40 spray.
Step 22

Grip the shock absorber in a vice.
Step 23

Remove the shock absorber mount cap.Use a crowbar.
Step 24

Clean the shock absorber rod fastener.Use a wire brush.Use WD-40 spray.
Step 25

Remove the fastener of the shock absorber piston rod.Use a drive socket #16.Use a shock absorber socket DD№5,2.Use a ratchet wrench.
Step 26

Remove the shock absorber mount, boot and bump stop.

AUTODOC recommends:

Replacement: strut mount – VW T-Cross (C11_). Carefully inspect the mount, the boot, and the bump stop of the shock absorber. Replace if necessary.
Step 27

Install the new mount, boot, and bump stop on the shock absorber.
Step 28

Tighten the shock absorber rod nut.Use a drive socket #16.Use a shock absorber socket DD№6.Use a torque wrench.Tighten it to 25 Nm torque.
Step 29

Treat the shock absorber rod fastener.Use copper grease.
Step 30

Install the shock absorber mount cap.
Step 31

Release the vice and take out the shock absorber.
Step 32

Place the shock absorber in the wheel arch and secure it.
Step 33

Install the fastening bolt.
Step 34

Raise the hydraulic transmission jack by 10-15 cm.
Step 35

Install the fastening bolts.
Step 36

Tighten the shock absorber mount fasteners.Use a drive socket #16.Use a torque wrench.Tighten it to 50 Nm torque.+45°
Step 37

Treat the shock absorber mount fasteners.Use copper grease.
Step 38

Reinstall the charcoal canister.
Step 39

Tighten the charcoal canister fastener.Use a drive socket #13.Use a torque wrench.Tighten it to 12 Nm torque.
Step 40

Treat the charcoal canister fastener.Use copper grease.
Step 41

Install the wheel arch cover to its mounting seat.
Step 42

Screw in the locker fasteners.Use Torx T25.Use a ratchet wrench.

AUTODOC recommends:

For tightening the fasteners correctly, you have to jack up the suspension components to their working position.
Step 43

Tighten the lower fastener of the shock absorber. Use a combination spanner #18.Use a drive socket #18.Use a torque wrench.Tighten it to 180 Nm torque.
Step 44

Remove the support from under the rear knuckle.

AUTODOC recommends:

Replacement: strut mount – VW T-Cross (C11_). Lower the transmission jack smoothly, without jerks, to avoid damaging components and mechanisms.
Step 45

Treat the shock absorber fasteners. Use copper grease.
Step 46

Clean the wheel rim mounting seat.Use a wire brush.
Step 47

Treat the surface where the brake disc contacts the wheel rim. Use ceramic grease.
Step 48

Clean the brake disk surface.Use a brake cleaner.

AUTODOC recommends:

Replacement: strut mount – VW T-Cross (C11_). After applying the spray, wait a few minutes.
Step 49

Install the wheel.

AUTODOC recommends:

Warning! To avoid injury, hold the wheel while screwing in the fastening bolts on the car. VW T-Cross (C11_)
Step 50

Screw in the wheel bolts.Use wheel impact socket #17.
Step 51

Lower the car and working in a cross order, tighten the wheel bolts.Use wheel impact socket #17.Use a torque wrench.Tighten it to 120 Nm torque.
Step 52

Remove the jacks and chocks.

Comment

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

How to change track rod end on VW T-Cross (C11_) – replacement guide

Free download PDF

1.44 MB
How to change front anti roll bar links on VW T-Cross (C11_) – replacement guide

Free download PDF

2.05 MB
How to change front strut mount on VW T-Cross (C11_) – replacement guide

Free download PDF

3.6 MB
How to change rear brake pads on VW T-Cross (C11_) – replacement guide

Free download PDF

2.34 MB
How to change rear brake discs on VW T-Cross (C11_) – replacement guide

Free download PDF

2.29 MB
How to change front windshield wipers on VW T-Cross (C11_) – replacement guide

Free download PDF

1.54 MB

How to change front strut mount on VW T-Cross (C11_) – replacement guide

Free download PDF

3.6 MB
How to change front strut mount on VW Polo 9N – replacement guide

Free download PDF

9.28 MB
How to change rear strut mount on VW Polo 9N – replacement guide

Free download PDF

7.27 MB
How to change front strut mount on VW Golf 5 – replacement guide

Free download PDF

13.05 MB
How to change front strut mount on VW Passat 3C B6 Variant – replacement guide

Free download PDF

16.16 MB
How to change front strut mount on VW Sharan 1 – replacement guide

Free download PDF

11.72 MB

Your profile is your personal assistant.

It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents

Install the AUTODOC CLUB app!

Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.

Scan

To download the app:

- scan the QR code
- download from App Store
- download from Google Play

Tips & tricks for your VW T-Cross (C11_)

How to check a fuel pump | AUTODOC tips

5K views

Published on: 29/07/2021
5 car interior cleaning mistakes | AUTODOC tips

3K views

Published on: 26/05/2022
3 things that cause engine damage | AUTODOC

5K views

Published on: 07/10/2021
TOP 4 car cleaning products | AUTODOC

2K views

Published on: 26/08/2021