Important!

This replacement procedure can be used for:
VW load up! Van (121, 122, BL1, BL2) e-Load Up, VW load up! Van (121, 122, BL1, BL2) 1.0 EcoFuel, VW load up! Van (121, 122, BL1, BL2) 1.0, VW load up! Van (121, 122, BL1, BL2) 1.0 BlueMotion, VW load up! Van (121, 122, BL1, BL2) 1.0 TSi BlueMotion … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Strut Mount for load up! Van (121, 122, BL1, BL2) and other VW models

Repair kit, suspension strut

        Repair kit, suspension strut for load up! Van (121, 122, BL1, BL2) Electric (82 hp)
      
        Repair kit, suspension strut for load up! Van (121, 122, BL1, BL2) Petrol/Natural Gas (CNG) (68 hp)
      
        Repair kit, suspension strut for load up! Van (121, 122, BL1, BL2) Petrol (60 hp)
      
        Repair kit, suspension strut for load up! Van (121, 122, BL1, BL2) Petrol (75 hp)
      
        Repair kit, suspension strut for load up! Van (121, 122, BL1, BL2) Petrol (90 hp)

Replacement: strut mount – VW LOAD UP. Tools you'll need:

                        Wire brush
                      
                        WD-40 spray
                      
                        Copper grease 
                      
                        Drive socket # 16 
                      
                        Combination spanner #16
                      
                        Torque wrench
                      
                        Adjustable wrench
                      
                        Wheel impact socket #17
                      
                        Hydraulic transmission jack
                      
                        Wheel chock

Buy tools

Replacement: strut mount – VW LOAD UP. AUTODOC recommends:

All work should be done with the engine stopped.
The replacement procedure is identical for the mounts of the right and left shock absorbers of the rear suspension.
Both mounts of the rear shock struts should be replaced simultaneously.
Be sure to replace all self-locking nuts and bolts during installation.

Replacement: strut mount – VW LOAD UP. Recommended sequence of steps:

Step 1

Secure the wheels with chocks.
Step 2

Loosen the wheel mounting bolts. Use wheel impact socket #17.
Step 3

Raise the rear of the car and secure on supports.

Step 4

Unscrew the wheel bolts.

Replacement: strut mount – VW LOAD UP. Tip:
To avoid injury, hold up the wheel when unscrewing the bolts.
Step 5

Remove the wheel.
Step 6

Clean the shock absorber fasteners. Use a wire brush. Use WD-40 spray.
Step 7

Support the arm. Use a hydraulic transmission jack.
Step 8

Unscrew the lower fastener of the shock absorber. Use a combination spanner #16. Use a drive socket #16.
Step 9

Unscrew the upper fastener of the shock absorber. Use a drive socket #16.

AUTODOC recommends:
Important! Hold the shock absorber while unscrewing the fastening bolts. VW LOAD UP
Step 10

Remove the support from under the rear arm.
Step 11

Remove the shock absorber.
Step 12

Remove the protective cap of the shock absorber mount.
Step 13

Clean the shock absorber rod fastener. Use a wire brush. Use WD-40 spray.
Step 14

Remove the shock absorber piston rod fastening. Use a combination spanner #16. Use an adjustable wrench.
Step 15

Remove the shock absorber mount, boot and bump stop.

AUTODOC recommends:
Τhoroughly examine the shock absorber mount, dust boot, bump stop. Replace them if necessary.
Step 16

Install the boot and a bump stop onto the shock absorber.
Step 17

Install the new shock absorber mount.
Step 18

Tighten the shock absorber mount fasteners. Use a combination spanner #16. Use an adjustable wrench. Use a torque wrench. Tighten it to 25 Nm torque.
Step 19

Place the shock absorber in the wheel arch and secure it.
Step 20

Install the shock absorber mount using the center hole as a guide.
Step 21

Tighten the top shock absorber fastening. Important! Be sure to use new fasteners. Use a drive socket #16. Use a torque wrench. Tighten it to 30 Nm torque.+90°
Step 22

Support the arm. Use a hydraulic transmission jack.
Step 23

Tighten the lower fastener of the shock absorber. Important! Be sure to use new fasteners. Use a combination spanner #16. Use a drive socket #16. Use a torque wrench. Tighten it to 40 Nm torque.+90°
Step 24

Remove the support from under the rear arm.
Step 25

Clean the wheel rim mounting seat. Use a wire brush. Treat the contacting surface. Use copper grease.
Step 26

Install the wheel.

AUTODOC recommends:
Warning! To avoid injury, hold the wheel while screwing in the fastening bolts on the car. VW LOAD UP
Step 27

Screw in the wheel bolts. Use wheel impact socket #17.
Step 28

Lower the car and working in a cross order, tighten the wheel bolts. Use a torque wrench. Tighten it to 120 Nm torque.
Step 29

Remove the jacks and chocks.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

Searching for the right tyres?

Find out which tyre and wheel sizes are compatible with the VW load up! Van (121, 122, BL1, BL2) model.

Browse tyres

How to change front strut mount on VW load up! Van (121, 122, BL1, BL2) – replacement guide

Free download PDF
1.76 MB
How to change front anti roll bar links on VW load up! Van (121, 122, BL1, BL2) – replacement guide

Free download PDF
1.24 MB
How to change front brake pads on VW load up! Van (121, 122, BL1, BL2) – replacement guide

Free download PDF
1.73 MB
How to change serpentine belt on VW load up! Van (121, 122, BL1, BL2) – replacement guide

Free download PDF
1.46 MB
How to change front windshield wipers on VW load up! Van (121, 122, BL1, BL2) – replacement guide

Free download PDF
1.29 MB
How to change front brake caliper on VW load up! Van (121, 122, BL1, BL2) – replacement guide

Free download PDF
2.71 MB

How to change rear strut mount on VW up! Hatchback (121, 122, BL1, BL2) – replacement guide

Free download PDF
1.9 MB
How to change front strut mount on VW up! Hatchback (121, 122, BL1, BL2) – replacement guide

Free download PDF
2.79 MB
How to change front strut mount on VW load up! Van (121, 122, BL1, BL2) – replacement guide

Free download PDF
1.76 MB
How to change strut mount on a car – replacement tutorial

Universal

Free download PDF
1.04 MB
How to change front strut mount on VW Golf 5 – replacement guide

Free download PDF
3.07 MB
How to change front strut mount on VW Golf 6 – replacement guide

Free download PDF
4.01 MB

Your profile is your personal assistant.

It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents

Install the AUTODOC CLUB app!

Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.

Scan

To download the app:

- scan the QR code
- download from App Store
- download from Google Play

How to easily repair a punctured tyre | AUTODOC tips

3K views

Published on: 25/02/2021
DIY alternator repair | AUTODOC tips

1M views

Published on: 30/11/2022
Car checks you need to carry out on your car after the winter | AUTODOC tips

3K views

Published on: 23/03/2023
DIY car soundproofing | AUTODOC tips

76K views

Published on: 15/04/2021