
Disclaimer
How to change rear strut mount on VW Golf IV Variant (1J5) – replacement guide
downloads:
1
Views:
13
Important!
This replacement procedure can be used for:
VW Golf IV Variant (1J5) 1.4 16V, VW Golf IV Variant (1J5) 1.6, VW Golf IV Variant (1J5) 2.0, VW Golf IV Variant (1J5) 1.9 SDI, VW Golf IV Variant (1J5) 1.9 TDI, VW Golf IV Variant (1J5) 1.9 TDI, VW Golf IV Variant (1J5) 1.9 TDI, VW Golf IV Variant (1J5) 2.3 V5, VW Golf IV Variant (1J5) 1.6 16V, VW Golf IV Variant (1J5) 1.9 TDI, VW Golf IV Variant (1J5) 1.6, VW Golf IV Variant (1J5) 1.9 TDI, VW Golf IV Variant (1J5) 1.8 T, VW Golf IV Variant (1J5) 2.3 V5 … View more
The steps may slightly vary depending on the car design.
VW Golf IV Variant (1J5) 1.4 16V, VW Golf IV Variant (1J5) 1.6, VW Golf IV Variant (1J5) 2.0, VW Golf IV Variant (1J5) 1.9 SDI, VW Golf IV Variant (1J5) 1.9 TDI, VW Golf IV Variant (1J5) 1.9 TDI, VW Golf IV Variant (1J5) 1.9 TDI, VW Golf IV Variant (1J5) 2.3 V5, VW Golf IV Variant (1J5) 1.6 16V, VW Golf IV Variant (1J5) 1.9 TDI, VW Golf IV Variant (1J5) 1.6, VW Golf IV Variant (1J5) 1.9 TDI, VW Golf IV Variant (1J5) 1.8 T, VW Golf IV Variant (1J5) 2.3 V5 … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Strut Mount for Golf IV Variant (1J5) and other VW models
Top strut mount
Alternative products

Wire brush
WD-40 spray
Copper grease
Torque wrench
Combination spanner #16
Drive socket # 16
Wheel impact socket #17
Ratchet wrench
Shock absorber socket #DD6
Vice
Hydraulic transmission jack
Wheel chock
Replacement: strut mount – VW GOLF IV Variant (1J5). Tip from AUTODOC experts:
- The replacement procedure is identical for the mounts of the right and left shock absorbers of the rear suspension.
- Both mounts of the rear shock struts should be replaced simultaneously.
- Be sure to replace all self-locking nuts and bolts during installation.
- Please note: all work on the car – VW GOLF IV Variant (1J5) – should be done with the engine switched off.
Carry out replacement in the following order:
- Step 1Secure the wheels with chocks.
- Step 2Loosen the wheel mounting bolts. Use wheel impact socket #17.
- Step 3Raise the rear of the car and secure on supports.Step 4Unscrew the wheel bolts.AUTODOC recommends:Important! Hold the wheel while unscrewing the fastening bolts. VW GOLF IV Variant (1J5)
- Step 5Remove the wheel.
- Step 6Clean the shock absorber fasteners. Use a wire brush. Use WD-40 spray.
- Step 7Support the rear suspension beam. Use a hydraulic transmission jack.
- Step 8Unscrew the lower fastener of the shock absorber. Use a combination spanner #16. Use a drive socket #16. Use a ratchet wrench.
- Step 9Unscrew the upper fastener of the shock absorber. Use a drive socket #16. Use a ratchet wrench.
- Step 10Remove the fastening bolt.
- Step 11Remove the mounting from under the rear axle beam.Replacement: strut mount – VW GOLF IV Variant (1J5). Professionals recommend:Lower the hydraulic transmission jack smoothly, without jerks, to avoid damaging assemblies and mechanisms.Step 12Remove the shock absorber.
- Step 13Remove the protective cap of the shock absorber mount.
- Step 14Grip the shock absorber in a vice.
- Step 15Clean the shock absorber rod fastener. Use a wire brush. Use WD-40 spray.
- Step 16Remove the shock absorber piston rod fastening. Use a drive socket #16. Use a shock absorber socket DD№6. Use a ratchet wrench.
- Step 17Remove the shock absorber mount, boot and bump stop.Replacement: strut mount – VW GOLF IV Variant (1J5). Tip from AUTODOC:Examine the shock absorber dust cap and the bump stop. Replace them if necessary.
- Step 18Install the new mount, boot, and bump stop on the shock absorber.
- Step 19Tighten the shock absorber rod nut. Use a drive socket #16. Use a shock absorber socket DD№6. Use a torque wrench. Tighten it to 25 nm torque.
- Step 20Treat the shock absorber rod fastener. Use copper grease.
- Step 21Release the vice and take out the shock absorber.
- Step 22Install the protective cap of the shock absorber mount.
- Step 23Clean the shock absorber mounting seats. Use a wire brush. Use WD-40 spray.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the VW Golf IV Variant (1J5) model
Popular maintenance tutorials for Golf 1j5
Complete guides for changing the Strut mount on different VW GOLF models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your VW Golf IV Variant (1J5)
View more
- The Fast and Easy Way to Fix a Broken Wheel Stud | AUTODOC tips
- Initial Car Inspection: What to Check Before You Buy
- How to restore a steering wheel | AUTODOC tips
- DIY brake caliper restoration | AUTODOC tips
Most commonly replaced car parts on VW GOLF
Time to replace parts? Get even better deals in our Shop app.

SCAN ME