Important!

This replacement procedure can be used for:
SKODA Octavia I Box Body / Estate (1U5) 1.9 TDI … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Strut Mount for Octavia I Box Body / Estate (1U5) and other SKODA models

Top strut mount

Repair kit, suspension strut

Anti-Friction Bearing, suspension strut support mounting

How to change Top strut mount on SKODA Octavia I Box Body / Estate (1U5) 1.9 TDI – tips for proper car maintenance

Top strut mount for SKODA Octavia I Box Body / Estate (1U5) 1.9 TDI Diesel (90 hp)

Replacement: strut mount – SKODA Octavia I Kasten / Kombi (1U5). List of the tools you'll need:

                        Wire brush
                      
                        WD-40 spray
                      
                        Copper grease 
                      
                        Combination spanner #16
                      
                        Combination spanner #17
                      
                        Drive socket # 16 
                      
                        Torx bit T25
                      
                        Wheel impact socket #17
                      
                        Ratchet wrench
                      
                        Torque wrench
                      
                        Adjustable wrench
                      
                        Vice
                      
                        Hydraulic transmission jack
                      
                        Wheel chock

Buy tools

Replacement: strut mount – SKODA Octavia I Kasten / Kombi (1U5). AUTODOC experts recommend:

The replacement procedure is identical for the mounts of the right and left shock absorbers of the rear suspension.
Both mounts of the rear shock struts should be replaced simultaneously.
Be sure to replace all self-locking nuts and bolts during installation.
All work should be done with the engine stopped.

Replacement: strut mount – SKODA Octavia I Kasten / Kombi (1U5). Take the following steps:

Step 1

Secure the wheels with chocks.
Step 2

Loosen the wheel mounting bolts. Use wheel impact socket #17.
Step 3

Raise the rear of the car and secure on supports.

Step 4

Unscrew the wheel bolts.

AUTODOC recommends:
Important! Hold the wheel while unscrewing the fastening bolts. SKODA Octavia I Kasten / Kombi (1U5)
Step 5

Remove the wheel.
Step 6

Unscrew and remove the wheel arch cover fasteners. Use Torx T25.
Step 7

Remove the wheel arch cover.
Step 8

Secure the rear axle beam. Use a hydraulic transmission jack.
Step 9

Clean the shock absorber fasteners. Use a wire brush. Use WD-40 spray.
Step 10

Unscrew the lower fastener of the shock absorber. Use a combination spanner #16. Use a drive socket #16. Use a ratchet wrench.
Step 11

Unscrew the upper fastener of the shock absorber. Use a drive socket #16. Use a ratchet wrench.

AUTODOC recommends:
SKODA Octavia I Kasten / Kombi (1U5) – To avoid injury, hold the shock absorber while unscrewing the fastening bolts.
Step 12

Remove the shock absorber.
Step 13

Clean the shock absorber rod fastener. Use a wire brush. Use WD-40 spray.
Step 14

Grip the shock absorber in a vice.
Step 15

Remove the shock absorber piston rod fastening. Use a combination spanner #17. Use an adjustable wrench.
Step 16

Release the vice and take out the shock absorber.
Step 17

Remove the shock absorber mount, boot and bump stop.

Replacement: strut mount – SKODA Octavia I Kasten / Kombi (1U5). Tip from AUTODOC experts:
Examine the shock absorber dust cap and the bump stop. Replace them if necessary.
Step 18

Install the new mount, boot, and bump stop on the shock absorber.
Step 19

Grip the shock absorber in a vice.
Step 20

Screw the shock strut piston rod upper fastening. Use a combination spanner #17. Use an adjustable wrench. Use a torque wrench. Tighten it to 25 Nm torque.
Step 21

Release the vice and take out the shock absorber.
Step 22

Clean the shock absorber mounting seats. Use a wire brush. Use WD-40 spray.
Step 23

Treat the shock absorber mounting seats. Use copper grease.
Step 24

Place the shock absorber in the wheel arch and secure it.

AUTODOC recommends:
Important! Hold the shock absorber while screwing in the fastening bolts. SKODA Octavia I Kasten / Kombi (1U5)
Step 25

Tighten the top shock absorber fastening. Use a drive socket #16. Use a torque wrench. Tighten it to 30 Nm torque.+90°

AUTODOC recommends:
Important! Be sure to use new fasteners.
Step 26

Treat the shock absorber fasteners. Use copper grease.
Step 27

Clean the shock absorber mounting seats. Use WD-40 spray.

Step 28

Tighten the lower fastener of the shock absorber. Use a drive socket #16. Use a combination spanner #16. Use a torque wrench. Tighten it to 40 Nm torque.+90°

AUTODOC recommends:
Important! Be sure to use new fasteners.
Step 29

Remove the mounting from under the rear axle beam.

AUTODOC recommends:
Replacement: strut mount – SKODA Octavia I Kasten / Kombi (1U5). Lower the transmission jack smoothly, without jerks, to avoid damaging components and mechanisms.
Step 30

Install the wheel arch cover to its mounting seat.
Step 31

Install and tighten the wheel arch cover fasteners. Use Torx T25.
Step 32

Clean the wheel rim mounting seat. Use a wire brush. Treat the contacting surface. Use copper grease.
Step 33

Install the wheel.

Replacement: strut mount – SKODA Octavia I Kasten / Kombi (1U5). Tip from AUTODOC experts:
To avoid injury, hold up the wheel when screwing in the fastening bolts.
Step 34

Screw in the wheel bolts. Use wheel impact socket #17.
Step 35

Lower the car and working in a cross order, tighten the wheel bolts. Use a torque wrench. Tighten it to 120 nm torque.
Step 36

Remove the jacks and chocks.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

How to change front lower arm on SKODA Octavia I Box Body / Estate (1U5) – replacement guide

Free download PDF
1.74 MB
How to change front strut mount on SKODA Octavia I Box Body / Estate (1U5) – replacement guide

Free download PDF
1.76 MB
How to change front anti roll bar links on SKODA Octavia I Box Body / Estate (1U5) – replacement guide

Free download PDF
1.12 MB
How to change track rod end on SKODA Octavia I Box Body / Estate (1U5) – replacement guide

Free download PDF
2.3 MB
How to change rear brake pads on SKODA Octavia I Box Body / Estate (1U5) – replacement guide

Free download PDF
1.54 MB
How to change front brake pads on SKODA Octavia I Box Body / Estate (1U5) – replacement guide

Free download PDF
1.38 MB

How to change front strut mount on SKODA Octavia III Hatchback (5E3, NL3, NR3) – replacement guide

Free download PDF
3.41 MB
How to change front strut mount on SKODA Octavia III Combi (5E5) – replacement guide

Free download PDF
3.41 MB
How to change front strut mount on SKODA OCTAVIA (1Z3) – replacement guide

Free download PDF
3.87 MB
How to change rear strut mount on SKODA OCTAVIA (1Z3) – replacement guide

Free download PDF
1.69 MB
How to change front strut mount on SKODA Octavia II Combi (1Z5) – replacement guide

Free download PDF
3.88 MB
How to change rear strut mount on SKODA Octavia II Combi (1Z5) – replacement guide

Free download PDF
1.69 MB

Your profile is your personal assistant.

It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents

Install the AUTODOC CLUB app!

Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.

Scan

To download the app:

- scan the QR code
- download from App Store
- download from Google Play

3 things that cause engine damage | AUTODOC tips

9K views

Published on: 07/10/2021
How to paint a car with a spray can | AUTODOC tips

5K views

Published on: 25/03/2021
Top 5 reasons why your car squeals | AUTODOC Tips

6K views

Published on: 26/10/2023
Coolant comparison test | AUTODOC

11K views

Published on: 18/02/2021