Disclaimer
How to change rear coil springs on VW Jetta IV (162, 163, AV3, AV2) – replacement guide
downloads:
3
Views:
52
Important!
This replacement procedure can be used for:
VW Jetta IV (162, 163, AV3, AV2) 1.2 TSI, VW Jetta IV (162, 163, AV3, AV2) 1.6 TDI, VW Jetta IV (162, 163, AV3, AV2) 2.0 TDI, VW Jetta IV (162, 163, AV3, AV2) 1.4 TSI, VW Jetta IV (162, 163, AV3, AV2) 2.0 TFSI, VW Jetta IV (162, 163, AV3, AV2) 2.5, VW Jetta IV (162, 163, AV3, AV2) 2.0 TDI, VW Jetta IV (162, 163, AV3, AV2) 2.0, VW Jetta IV (162, 163, AV3, AV2) 1.4 TSI, VW Jetta IV (162, 163, AV3, AV2) 1.4 TSI, VW Jetta IV (162, 163, AV3, AV2) 1.4 TSI Hybrid, VW Jetta IV (162, 163, AV3, AV2) 1.6, VW Jetta IV (162, 163, AV3, AV2) 2.0 TSI, VW Jetta IV (162, 163, AV3, AV2) 1.4 TSI, VW Jetta IV (162, 163, AV3, AV2) 2.0 TDI, VW Jetta IV (162, 163, AV3, AV2) 1.4 TSI, VW Jetta IV (162, 163, AV3, AV2) 1.8 TSI, VW Jetta IV (162, 163, AV3, AV2) 1.2 TSI 16V … View more
The steps may slightly vary depending on the car design.
VW Jetta IV (162, 163, AV3, AV2) 1.2 TSI, VW Jetta IV (162, 163, AV3, AV2) 1.6 TDI, VW Jetta IV (162, 163, AV3, AV2) 2.0 TDI, VW Jetta IV (162, 163, AV3, AV2) 1.4 TSI, VW Jetta IV (162, 163, AV3, AV2) 2.0 TFSI, VW Jetta IV (162, 163, AV3, AV2) 2.5, VW Jetta IV (162, 163, AV3, AV2) 2.0 TDI, VW Jetta IV (162, 163, AV3, AV2) 2.0, VW Jetta IV (162, 163, AV3, AV2) 1.4 TSI, VW Jetta IV (162, 163, AV3, AV2) 1.4 TSI, VW Jetta IV (162, 163, AV3, AV2) 1.4 TSI Hybrid, VW Jetta IV (162, 163, AV3, AV2) 1.6, VW Jetta IV (162, 163, AV3, AV2) 2.0 TSI, VW Jetta IV (162, 163, AV3, AV2) 1.4 TSI, VW Jetta IV (162, 163, AV3, AV2) 2.0 TDI, VW Jetta IV (162, 163, AV3, AV2) 1.4 TSI, VW Jetta IV (162, 163, AV3, AV2) 1.8 TSI, VW Jetta IV (162, 163, AV3, AV2) 1.2 TSI 16V … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Springs for Jetta IV (162, 163, AV3, AV2) and other VW models
Alternative products

Wire brush
WD-40 spray
Brake cleaner
Copper grease
Combination spanner #18
Drive socket # 18
Wheel impact socket #17
Ratchet wrench
Torque wrench
Crow bar
Hydraulic transmission jack
Wheel chock
Replacement: coil springs – VW JETTA IV (162, 163). AUTODOC recommends:
- Both coil springs of the rear suspension should be replaced simultaneously.
- The replacement procedure is identical for the left and right coil springs of the rear suspension.
- All work should be done with the engine stopped.
Replacement: coil springs – VW JETTA IV (162, 163). Recommended sequence of steps:
- Step 1
Secure the wheels with chocks. - Step 2
Loosen the wheel mounting bolts. Use wheel impact socket #17. - Step 3Raise the rear of the car and secure on supports.Step 4
Unscrew the wheel bolts.Replacement: coil springs – VW JETTA IV (162, 163). Tip:To avoid injury, hold up the wheel when unscrewing the bolts. - Step 5
Remove the wheel. - Step 6
Clean all joints of the arm. Use a wire brush. Use WD-40 spray. - Step 7
Make a mark on the camber adjustment bolt. - Step 8
Unscrew the arm fastening to the beam. Use a combination spanner #18. Use a drive socket #18. Use a ratchet wrench. - Step 9
Clean all joints of the arm. Use a wire brush. Use WD-40 spray. - Step 10
Unscrew the fastener connecting the control arm to the rear knuckle. Use a combination spanner #18 (2 pieces). - Step 11
Support the arm. Use a hydraulic transmission jack. - Step 12
Remove the fastening bolt. Use a combination spanner #18. Use a crowbar. - Step 13
Remove the support from under the arm. Use a crowbar.AUTODOC recommends:Replacement: coil springs – VW JETTA IV (162, 163). Lower the transmission jack smoothly, without jerks, to avoid damaging components and mechanisms. - Step 14
Pull down the suspension control arm. Take out the spring. - Step 15
Remove the rubber spring spacer. - Step 16
Clean the coil spring mounting seats. Use a wire brush. Use WD-40 spray. - Step 17
Install the rubber spacer on the new coil spring. - Step 18
Install the coil spring together with the rubber mounts into the mounting seats. - Step 19
Clean the mounting seats and the thread of the suspension arm. Use a wire brush. Use WD-40 spray. - Step 20
Support the arm. Use a hydraulic transmission jack. Use a crowbar. - Step 21
Install the fastening bolt. - Step 22
Adjust the position of the alignment bolt according to the mark.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the VW Jetta Mk6 (162, 163, AV3, AV2) model
Popular maintenance tutorials for VW Jetta mk6
Complete guides for changing the Springs on different VW JETTA models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your VW Jetta IV (162, 163, AV3, AV2)
View more
DIY brake caliper restoration | AUTODOC tips
Which Coolant is Best? Comparison Test | AUTODOC
Save Money on Fuel with These Easy Tips | AUTODOC
Top 5 Car Interior Cleaning Mistakes You Should Avoid | AUTODOC Tips
Most commonly replaced car parts on VW JETTA
Time to replace parts? Get even better deals in our Shop app.

SCAN ME
































