Disclaimer
How to change rear brake pads on SEAT Ateca (KH7) – replacement guide
downloads:
99
Views:
862
Recommended replacement interval for the part category Brake pad set : 30000 km
Important!
This replacement procedure can be used for:
SEAT Ateca (KH7) 1.0 TSI, SEAT Ateca (KH7) 1.4 TSI, SEAT Ateca (KH7) 1.4 TSI 4Drive, SEAT Ateca (KH7) 1.6 TDI, SEAT Ateca (KH7) 2.0 TDI, SEAT Ateca (KH7) 2.0 TDI 4Drive, SEAT Ateca (KH7) 2.0 TDI 4Drive, SEAT Ateca (KH7) 2.0 TDI, SEAT Ateca (KH7) 2.0 TDI, SEAT Ateca (KH7) 2.0 TSI 4Drive, SEAT Ateca (KH7) 1.5 TSI, SEAT Ateca (KH7) 1.5 TSI 4Drive, SEAT Ateca (KH7) 1.0 TSI, SEAT Ateca (KH7) 2.0 TDI … View more
The steps may slightly vary depending on the car design.
SEAT Ateca (KH7) 1.0 TSI, SEAT Ateca (KH7) 1.4 TSI, SEAT Ateca (KH7) 1.4 TSI 4Drive, SEAT Ateca (KH7) 1.6 TDI, SEAT Ateca (KH7) 2.0 TDI, SEAT Ateca (KH7) 2.0 TDI 4Drive, SEAT Ateca (KH7) 2.0 TDI 4Drive, SEAT Ateca (KH7) 2.0 TDI, SEAT Ateca (KH7) 2.0 TDI, SEAT Ateca (KH7) 2.0 TSI 4Drive, SEAT Ateca (KH7) 1.5 TSI, SEAT Ateca (KH7) 1.5 TSI 4Drive, SEAT Ateca (KH7) 1.0 TSI, SEAT Ateca (KH7) 2.0 TDI … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Brake Pads for Ateca (KH7) and other SEAT models
Alternative products

Wire brush
Nylon cleaning brush
Brake cleaner
Anti-squeal paste
Ceramic grease
Torque wrench
Combination spanner #13
Combination spanner #17
Drive socket # 13
Wheel impact socket #17
Brake caliper wind back tool
Crow bar
Wheel chock
Replacement: brake pads – SEAT ATECA (KH7). Tip from AUTODOC:
- Perform the replacement of brake pads in complete set for each axis. This provides effective braking.
- The replacement procedure is identical for all brake pads on the same axle.
- Please note: all work on the car – SEAT ATECA (KH7) – should be done with the engine switched off.
Carry out replacement in the following order:
- Step 1
Open the bonnet. Unscrew the brake fluid reservoir cap. - Step 2Secure the wheels with chocks.Step 3
Loosen the wheel mounting bolts. Use wheel impact socket #17. - Step 4Raise the car.Replacement: brake pads – SEAT ATECA (KH7). Tip from AUTODOC:If you are using a jack, make sure it rests on a flat surface without any unevenness.Be sure to additionally secure the car with jack stands.Step 5
Unscrew the wheel bolts.AUTODOC recommends:Warning! To avoid injury, hold the wheel while unscrewing the fastening bolts. SEAT ATECA (KH7) - Step 6
Remove the wheel. - Step 7
Clean the brake caliper fasteners. Use a wire brush. Use a brake cleaner.AUTODOC recommends:Replacement: brake pads – SEAT ATECA (KH7). After applying the spray, wait a few minutes. - Step 8
Unscrew the brake caliper fasteners. Use a combination spanner #13. Use a combination spanner #17. - Step 9
Remove the fastening bolts. - Step 10
Remove the brake caliper. Use a crowbar.Replacement: brake pads – SEAT ATECA (KH7). AUTODOC experts recommend:Tie the caliper to the suspension or to the body with a wire without disconnecting from the brake hose to prevent depressurization of the brake system.Make sure that the brake caliper is not hanging on the brake hose.Don't press the brake pedal after the brake caliper has been removed. As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur. - Step 11
Remove the brake pads. Use a crowbar.Replacement: brake pads – SEAT ATECA (KH7). Tip from AUTODOC:Measure the brake disc thickness. Upon reaching the wear limit the part must be replaced. - Step 12
Treat the brake caliper piston. Use a nylon cleaning brush. Use a brake cleaner.AUTODOC recommends:Replacement: brake pads – SEAT ATECA (KH7). After applying the spray, wait a few minutes. - Step 13
Press in the brake caliper piston. Use brake caliper wind back tool. - Step 14
Clean the brake caliper bracket from dirt and dust. Use a wire brush. Use a brake cleaner.AUTODOC recommends:After applying the spray, wait a few minutes. - Step 15
Treat the brake pads in the area where their surface comes into contact with the brake caliper bracket. Use anti-squeal paste.AUTODOC recommends:Make sure the disc surface is clean before installing the pads. - Step 16
Install new brake pads.Replacement: brake pads – SEAT ATECA (KH7). AUTODOC recommends:Check the brake caliper bracket, brake caliper guide pins and boots. Clean them. Replace, if necessary.
Comments –
2
- @user_227888526.02.2024 16:50MemberCan you still wind back the calipers if you have an electric hand brake or do you need a computer?
@Jessica_L27.02.2024 08:35@user_ModeratorThe parking brake must be set to service mode and there is no way to do this without diagnostic equipment.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the SEAT Ateca (KH7) model
Popular maintenance tutorials for Seat Ateca kh7
Complete guides for changing the Brake pad set on different SEAT ATECA models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your SEAT Ateca (KH7)
View more
How to inspect and troubleshoot your car heater when it’s not working
Revive Your Tyres: Expert Tips for a Lasting Shine | AUTODOC Guide
Top 5 brake repair mistakes | AUTODOC tips
What causes engine misfire? | AUTODOC
Most commonly replaced car parts on SEAT ATECA
Time to replace parts? Get even better deals in our Shop app.

SCAN ME

































