Recommended replacement interval for the part category Brake pad set : 30000 km

Important!

This replacement procedure can be used for:
HONDA Accord VII Tourer (CM, CN) 2.2 i-CTDi (CN2) … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Brake Pads for Accord VII Tourer (CM, CN) and other HONDA models

Brake pad set

Brake pad set for Accord VII Tourer (CM, CN) Diesel (140 hp)

Replacement: brake pads – HONDA ACCORD VII Tourer (CM). Tools you might need:

                        Wire brush
                      
                        WD-40 spray
                      
                        Brake cleaner
                      
                        Anti-squeal paste
                      
                        Copper grease
                      
                        Combination spanner #17
                      
                        Drive socket # 12
                      
                        Wheel impact socket #19
                      
                        Ratchet wrench
                      
                        Torque wrench
                      
                        Brake caliper wind back tool
                      
                        Crow bar
                      
                        Wheel chock

Buy tools

AUTODOC recommends:

Replace the brake disks on the car HONDA ACCORD VII Tourer (CM) in complete set for each axis. Regardless of the state of components. This will ensure even braking.
The replacement procedure is identical for both brake disks on the same axle.
When changing the brake discs, always replace the brake pads.
Please note: all work on the car – HONDA ACCORD VII Tourer (CM) – should be done with the engine switched off.

Carry out replacement in the following order:

Step 1

Open the bonnet. Unscrew the brake fluid reservoir cap.
Step 2

Secure the wheels with chocks.
Step 3

Loosen the wheel mounting bolts. Use wheel impact socket #19.
Step 4

Raise the rear of the car and secure on supports.

Step 5

Unscrew the wheel bolts.

AUTODOC recommends:
Warning! To avoid injury, hold the wheel while unscrewing the fastening bolts. HONDA ACCORD VII Tourer (CM)
Step 6

Remove the wheel.
Step 7

Clean the brake caliper fasteners. Use a wire brush. Use WD-40 spray.
Step 8

Unscrew the brake caliper fastening. Use a combination spanner #17. Use a drive socket #12. Use a ratchet wrench.
Step 9

Spread the brake pads. Use a crowbar.
Step 10

Remove the brake caliper. Use a crowbar.

Replacement: brake pads – HONDA ACCORD VII Tourer (CM). AUTODOC experts recommend:
Tie the caliper to the suspension or to the body with a wire without disconnecting from the brake hose to prevent depressurization of the brake system.Make sure that the brake caliper is not hanging on the brake hose.Don't press the brake pedal after the brake caliper has been removed. As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur. Check the brake caliper bracket, brake caliper guide pins and boots. Clean them. Replace, if necessary.
Step 11

Remove the brake pads. Use a crowbar.

Replacement: brake pads – HONDA ACCORD VII Tourer (CM). AUTODOC recommends:
Measure the brake disc thickness. Upon reaching the wear limit the part must be replaced.
Step 12

Clean the brake caliper bracket from dirt and dust. Use a wire brush. Use a brake cleaner.

AUTODOC recommends:
Replacement: brake pads – HONDA ACCORD VII Tourer (CM). After applying the spray, wait a few minutes.
Step 13

Treat the brake caliper piston. Use a brake cleaner.

AUTODOC recommends:
After applying the spray, wait a few minutes.
Step 14

Press in the brake caliper piston. Use brake caliper wind back tool.
Step 15

Treat the brake pads in the area where their surface comes into contact with the brake caliper bracket. Use anti-squeal paste.

Replacement: brake pads – HONDA ACCORD VII Tourer (CM). Tip from AUTODOC:
Make sure the disc surface is clean before installing the pads.
Step 16

Install new brake pads.

AUTODOC recommends:
Make sure the pads are installed with linings facing the disc.
Step 17.1

Install the brake caliper and fix it.

Step 17.2

Use a combination spanner #17. Use a drive socket #12. Use a torque wrench. Tighten it to 22 Nm torque.
Step 18

Treat the surface where the brake disc contacts the wheel rim. Use copper grease.
Step 19

Clean the brake disk surface. Use a brake cleaner.

AUTODOC recommends:
Replacement: brake pads – HONDA ACCORD VII Tourer (CM). After applying the spray, wait a few minutes.
Step 20

Install the wheel.

AUTODOC recommends:
Warning! To avoid injury, hold the wheel while screwing in the fastening bolts on the car. HONDA ACCORD VII Tourer (CM)
Step 21

Screw in the wheel bolts. Use wheel impact socket #19.
Step 22

Lower the car and working in a cross order, tighten the wheel bolts. Use wheel impact socket #19. Use a torque wrench. Tighten it to 108 nm torque.
Step 23

Remove the jacks and chocks.

Replacement: brake pads – HONDA ACCORD VII Tourer (CM). AUTODOC experts recommend:
Check the brake fluid level in the expansion tank and refill if necessary.
Step 24

Tighten the brake fluid reservoir cap. Close the hood.

Replacement: brake pads – HONDA ACCORD VII Tourer (CM). Tip from AUTODOC experts:
Without starting the engine, press the brake pedal several times until you feel significant resistance.Slow down smoothly for first 150-200 km after the brake pads replacement. Avoid unneccessary and sharp braking to a stop.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

Searching for the right tyres?

Find out which tyre and wheel sizes are compatible with the HONDA Accord VII Tourer (CM, CN) model.

Browse tyres

How to change front brake pads on HONDA Accord VII Tourer (CM, CN) – replacement guide

Free download PDF
1.66 MB
How to change front windshield wipers on HONDA Accord VII Tourer (CM, CN) – replacement guide

Free download PDF
583.68 KB
How to change engine oil and filter on HONDA Accord VII Tourer (CM, CN) – replacement guide

Free download PDF
1.98 MB
How to change pollen filter on HONDA Accord VII Tourer (CM, CN) – replacement guide

Free download PDF
747.52 KB
How to replace rear brake pads of disc brake on Honda CR-V III

Free download PDF
1.18 MB
How to replace the front brake pads of disc brake on Honda CR-V III

Free download PDF
1.26 MB

How to change rear brake pads on HONDA Accord VII Saloon (CL, CN) – replacement guide

Free download PDF
1.47 MB
How to change front brake pads on HONDA Accord VII Saloon (CL, CN) – replacement guide

Free download PDF
1.66 MB
How to change front brake pads on Honda Accord VIII CU – replacement guide

Free download PDF
1.58 MB
How to change front brake pads on HONDA ACCORD VIII Estate – replacement guide

Free download PDF
1.23 MB
How to change front brake pads on HONDA Accord VII Tourer (CM, CN) – replacement guide

Free download PDF
1.66 MB
How to change rear brake pads on HONDA Accord VI Saloon (CK, CG, CH, CF8) – replacement guide

Free download PDF
1.46 MB

Your profile is your personal assistant.

It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents

Install the AUTODOC CLUB app!

Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.

Scan

To download the app:

- scan the QR code
- download from App Store
- download from Google Play

How to swap the engine on a BMW E30 Turbo | SUPERCAR AUTODOC

2K views

Published on: 15/02/2021
How to choose the right engine oil for your car | AUTODOC

8K views

Published on: 01/07/2020
5 tools that make car repair incredibly simple | AUTODOC tips

36K views

Published on: 25/01/2024
How to restore a steering wheel | AUTODOC tips

32K views

Published on: 17/02/2022