
Disclaimer
How to change rear brake pads on CITROËN SAXO (S0, S1) – replacement guide
downloads:
20
Views:
262

Recommended replacement interval for the part category Brake pad set : 30000 km
Important!
This replacement procedure can be used for:
CITROËN SAXO (S0, S1) 1.6 VTL, VTR, CITROËN SAXO (S0, S1) 1.6 VTS, CITROËN SAXO (S0, S1) 1.6 VTS, CITROËN SAXO (S0, S1) 1.6, CITROËN SAXO (S0, S1) 1.6, CITROËN SAXO (S0, S1) 1.6 … View more
The steps may slightly vary depending on the car design.
CITROËN SAXO (S0, S1) 1.6 VTL, VTR, CITROËN SAXO (S0, S1) 1.6 VTS, CITROËN SAXO (S0, S1) 1.6 VTS, CITROËN SAXO (S0, S1) 1.6, CITROËN SAXO (S0, S1) 1.6, CITROËN SAXO (S0, S1) 1.6 … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Brake Pads for SAXO (S0, S1) and other CITROËN models
Brake pad set
Alternative products

Wire brush
WD-40 spray
Brake cleaner
Copper grease
Anti-squeal paste
Wheel impact socket #19
Brake caliper wind back tool
Torque wrench
Rubber mallet
Round-nose pliers
Crow bar
Wheel chock
Replacement: brake pads – CITROËN SAXO (S0, S1). AUTODOC experts recommend:
- Perform the replacement of brake pads in complete set for each axis. This provides effective braking.
- The replacement procedure is identical for all brake pads on the same axle.
- Replacement: brake pads – CITROËN SAXO (S0, S1). Use the following procedure:
Carry out replacement in the following order:
- Step 1Open the bonnet. Unscrew the brake fluid reservoir cap.Step 2Secure the wheels with chocks.
- Step 3Loosen the wheel mounting bolts. Use wheel impact socket #19.
- Step 4Raise the rear of the car and secure on supports.Step 5Unscrew the wheel bolts.Replacement: brake pads – CITROËN SAXO (S0, S1). Tip:To avoid injury, hold up the wheel when unscrewing the bolts.
- Step 6Remove the wheel.
- Step 7Remove the retaining springs of the brake pads. Use a crowbar.
- Step 8Remove the brake pad retaining pin. Use round-nose pliers.
- Step 9Clean the brake caliper fasteners. Use a wire brush. Use WD-40 spray.
- Step 10Remove the retainer of the brake pads. Use a crowbar. Use a rubber mallet.
- Step 11Remove the brake pads. Use a crowbar.Replacement: brake pads – CITROËN SAXO (S0, S1). Tip from AUTODOC experts:Measure the brake disc thickness. Upon reaching the wear limit the part must be replaced.
- Step 12Treat the brake pads in the area where their surface comes into contact with the brake caliper bracket. Use anti-squeal paste.Replacement: brake pads – CITROËN SAXO (S0, S1). AUTODOC recommends:Make sure the disc surface is clean before installing the pads.
- Step 13Install new brake pads.Replacement: brake pads – CITROËN SAXO (S0, S1). Tip:Make sure the pads are installed with linings facing the disc.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the CITROËN Saxo Hatchback model
Popular maintenance tutorials for CITROËN SAXO (S0, S1)
Complete guides for changing the Brake pad set on different CITROËN SAXO models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your CITROËN SAXO (S0, S1)
View more
- Initial Car Inspection: What to Check Before You Buy
- 5 mistakes when replacing consumables
- How to make an injector test bench yourself
- How to inspect and troubleshoot your car heater when it’s not working
Most commonly replaced car parts on CITROËN SAXO
Time to replace parts? Get even better deals in our Shop app.

SCAN ME