Disclaimer
How to change rear brake pads on AUDI TT Roadster (FV9, FVR) – replacement guide
downloads:
3
Views:
31
Recommended replacement interval for the part category Brake pad set : 30000 km
Important!
This replacement procedure can be used for:
AUDI TT Roadster (FV9, FVR) 2.0 TFSI, AUDI TT Roadster (FV9, FVR) 2.0 TFSI quattro, AUDI TT Roadster (FV9, FVR) 2.0 TDI, AUDI TT Roadster (FV9, FVR) 2.0 TTS quattro, AUDI TT Roadster (FV9, FVR) 1.8 TFSI, AUDI TT Roadster (FV9, FVR) 2.0 TTS quattro, AUDI TT Roadster (FV9, FVR) 2.0 TDI quattro, AUDI TT Roadster (FV9, FVR) 40 TFSI, AUDI TT Roadster (FV9, FVR) 45 TFSI, AUDI TT Roadster (FV9, FVR) 45 TFSI quattro, AUDI TT Roadster (FV9, FVR) 2.0 TTS quattro … View more
The steps may slightly vary depending on the car design.
AUDI TT Roadster (FV9, FVR) 2.0 TFSI, AUDI TT Roadster (FV9, FVR) 2.0 TFSI quattro, AUDI TT Roadster (FV9, FVR) 2.0 TDI, AUDI TT Roadster (FV9, FVR) 2.0 TTS quattro, AUDI TT Roadster (FV9, FVR) 1.8 TFSI, AUDI TT Roadster (FV9, FVR) 2.0 TTS quattro, AUDI TT Roadster (FV9, FVR) 2.0 TDI quattro, AUDI TT Roadster (FV9, FVR) 40 TFSI, AUDI TT Roadster (FV9, FVR) 45 TFSI, AUDI TT Roadster (FV9, FVR) 45 TFSI quattro, AUDI TT Roadster (FV9, FVR) 2.0 TTS quattro … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Brake Pads for TT Roadster (FV9, FVR) and other AUDI models
Alternative products

Wire brush
Nylon cleaning brush
Brake cleaner
Anti-squeal paste
Ceramic grease
Torque wrench
Combination spanner #13
Combination spanner #17
Drive socket # 13
Wheel impact socket #17
Brake caliper wind back tool
Crow bar
Wheel chock
Replacement: brake pads – AUDI TT Roadster (FV9). Tip from AUTODOC:
- Perform the replacement of brake pads in complete set for each axis. This provides effective braking.
- The replacement procedure is identical for all brake pads on the same axle.
- Please note: all work on the car – AUDI TT Roadster (FV9) – should be done with the engine switched off.
Carry out replacement in the following order:
- Step 1
Open the bonnet. Unscrew the brake fluid reservoir cap. - Step 2Secure the wheels with chocks.Step 3
Loosen the wheel mounting bolts. Use wheel impact socket #17. - Step 4Raise the car.Replacement: brake pads – AUDI TT Roadster (FV9). Tip from AUTODOC:If you are using a jack, make sure it rests on a flat surface without any unevenness.Be sure to additionally secure the car with jack stands.Step 5
Unscrew the wheel bolts.AUTODOC recommends:Warning! To avoid injury, hold the wheel while unscrewing the fastening bolts. AUDI TT Roadster (FV9) - Step 6
Remove the wheel. - Step 7
Clean the brake caliper fasteners. Use a wire brush. Use a brake cleaner.AUTODOC recommends:Replacement: brake pads – AUDI TT Roadster (FV9). After applying the spray, wait a few minutes. - Step 8
Unscrew the brake caliper fasteners. Use a combination spanner #13. Use a combination spanner #17. - Step 9
Remove the fastening bolts. - Step 10
Remove the brake caliper. Use a crowbar.Replacement: brake pads – AUDI TT Roadster (FV9). AUTODOC experts recommend:Tie the caliper to the suspension or to the body with a wire without disconnecting from the brake hose to prevent depressurization of the brake system.Make sure that the brake caliper is not hanging on the brake hose.Don't press the brake pedal after the brake caliper has been removed. As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur. - Step 11
Remove the brake pads. Use a crowbar.Replacement: brake pads – AUDI TT Roadster (FV9). Tip from AUTODOC:Measure the brake disc thickness. Upon reaching the wear limit the part must be replaced. - Step 12
Treat the brake caliper piston. Use a nylon cleaning brush. Use a brake cleaner.AUTODOC recommends:Replacement: brake pads – AUDI TT Roadster (FV9). After applying the spray, wait a few minutes. - Step 13
Press in the brake caliper piston. Use brake caliper wind back tool. - Step 14
Clean the brake caliper bracket from dirt and dust. Use a wire brush. Use a brake cleaner.AUTODOC recommends:After applying the spray, wait a few minutes. - Step 15
Treat the brake pads in the area where their surface comes into contact with the brake caliper bracket. Use anti-squeal paste.AUTODOC recommends:Make sure the disc surface is clean before installing the pads. - Step 16
Install new brake pads.Replacement: brake pads – AUDI TT Roadster (FV9). AUTODOC recommends:Check the brake caliper bracket, brake caliper guide pins and boots. Clean them. Replace, if necessary.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the AUDI TT Roadster (FV9, FVR) model
Popular maintenance tutorials for Audi TT FV
Complete guides for changing the Brake pad set on different AUDI TT models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your AUDI TT Roadster (FV9, FVR)
View more
DIY rear axle restoration | Drivetrain restoration – Part 2
How to Make a DIY Foam Sprayer | AUTODOC tips
CHECK ENGINE light turned on – step-by-step guide on what to do
Extend your engine's life: Avoid these 3 damaging factors | AUTODOC tips
Most commonly replaced car parts on AUDI TT
Time to replace parts? Get even better deals in our Shop app.

SCAN ME
































