Recommended replacement interval for the part category Glow plug : 30000 km

Important!

This replacement procedure can be used for:
DACIA LOGAN MCV II 1.5 dCi, DACIA LOGAN MCV II 1.5 dCi, DACIA LOGAN MCV II 1.5 dCi … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Glow Plugs for LOGAN MCV II and other DACIA models

Alternative products

Glow plug

Replacement: glow plugs – DACIA LOGAN MCV II. Tools you might need:

                      Injector & glow plug grease

                      Torque wrench
                    
                      Drive socket # 10 
                    
                      Spark plug socket # 10
                    
                      Ratchet wrench
                    
                      Flat Screwdriver
                    
                      Combination pliers
                    
                      Crow bar
                    
                      Microfibre towel
                    
                      Fender cover

Buy tools

Replacement: glow plugs – DACIA LOGAN MCV II. AUTODOC recommends:

The replacement procedure is identical for all glow plugs.
Before getting down to work, start the engine and let it warm up to operating temperature.
Wear gloves to protect your hands from hot surfaces.
All work should be done with the engine stopped.

Carry out replacement in the following order:

Step 1

Open the bonnet.

Step 2

Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.

Step 3

Disconnect the air intake pipe fastening. Use a drive socket #10. Use a ratchet wrench.
Step 4

Detach the air intake hose clamp. Use combination pliers. Use a crowbar.
Step 5

Remove the air intake pipe.
Step 6

Cover the air intake hose with a microfibre towel to prevent dust and dirt from getting into the system.
Step 7

Detach the engine wiring harness. Use a flat screwdriver.
Step 8

Unscrew the engine cover fastener. Use a drive socket #10. Use a ratchet wrench.
Step 9

Remove the engine cover.

Replacement: glow plugs – DACIA LOGAN MCV II. Tip from AUTODOC experts:
Do not apply excessive force when removing the part. Otherwise you may damage it.
Step 10

Clean dirt, dust and debris from inside the spark plug wells.
Step 11

Detach the glow plug wiring connectors.
Step 12

Unscrew the glow plugs. Use the spark plug socket #10. Use a ratchet wrench.
Step 13

Remove the glow plugs.
Step 14

Treat the glow plugs. Use the injector & glow plug grease.

Please note!
Do not touch the heating element as fingerprints may cause malfunction.
Step 15

Install new glow plugs to their mounting seats.
Step 16

Tighten the glow plugs. Use the spark plug socket #10. Use a torque wrench. Tighten it to 15 nm torque.

Replacement: glow plugs – DACIA LOGAN MCV II. Tip from AUTODOC:
Don't tighten the plugs with excessive force. Exceeding tightening torque can damage the thread connection. Be careful when working with a spark plug wrench. Its skewing can cause damage to the threaded connection.
Step 17

Attach the glow plug wiring connectors.
Step 18

Install the engine cover and secure it.

AUTODOC recommends:
Replacement: glow plugs – DACIA LOGAN MCV II. Do not use excessive force during installation. This may damage the part.
Step 19

Screw in the engine cover fasteners. Use a drive socket #10. Use a ratchet wrench.
Step 20

Attach the engine wiring harness. Use a flat screwdriver.
Step 21

Remove the microfibre towel from the air intake hose.
Step 22

Install the air intake pipe and secure it.
Step 23

Fasten the clamp on the air intake hose. Use combination pliers.
Step 24

Screw in the fastener of the air intake pipe. Use a drive socket #10. Use a ratchet wrench.

Step 25

Remove the fender protection cover.

Step 26

Close the hood.

Step 27

Run the engine for a few minutes. This is necessary in order to make sure that the component operates properly.

Step 28

Shut off the engine.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

Need New Tyres?

Find out which tyre and wheel sizes are compatible with the DACIA Logan II MCV (L8) model

Dacia Logan MCV 2 tyre size

How to change serpentine belt on DACIA LOGAN MCV II – replacement guide

Free download PDF
1.65 MB
How to change spark plugs on DACIA LOGAN MCV II – replacement guide

Free download PDF
880.64 KB
How to change front brake discs on DACIA LOGAN MCV II – replacement guide

Free download PDF
1.94 MB
How to change front wheel bearing on DACIA LOGAN MCV II – replacement guide

Free download PDF
3.39 MB
How to change engine oil and filter on DACIA LOGAN MCV II – replacement guide

Free download PDF
1.17 MB
How to change fuel filter on DACIA LOGAN MCV II – replacement guide

Free download PDF
962.56 KB

How to change glow plugs on DACIA LOGAN MCV (KS_) – replacement guide

Free download PDF
1.55 MB
How to change glow plugs on DACIA LOGAN (LS_) – replacement guide

Free download PDF
1.55 MB
How to change glow plugs on DACIA LOGAN II – replacement guide

Free download PDF
1.55 MB
How to change glow plugs on DACIA LOGAN Pickup (US_) – replacement guide

Free download PDF
1.55 MB
How to change glow plugs on DACIA LOGAN EXPRESS (FS_) – replacement guide

Free download PDF
1.55 MB
How to change glow plugs on a car – replacement tutorial

Universal

Free download PDF
1.62 MB

Unlock your car maintenance assistant!

Track expenses, manage logs, schedule replacements, and more.

Revive Your Vehicle's Look | How to Restore Wheel Rims Yourself!

6K views

Published on: 13/05/2021
Easy Steps to Paint Brake Calipers Without Special Skills or High Costs

10K views

Published on: 08/04/2021
Top 5 reasons why your car squeals | AUTODOC Tips

9K views

Published on: 26/10/2023
Drive with Care: 8 Common Bad Driving Habits Explained | AUTODOC

4K views

Published on: 01/04/2021