How to change front suspension strut on Opel Corsa C – replacement guide
downloads:
17
Views:
320
5
Users voted – 1
Important!
This replacement procedure can be used for:
OPEL Corsa C Hatchback (X01) 1.0 (F08, F68),
OPEL Corsa C Hatchback (X01) 1.2 (F08, F68),
OPEL Corsa C Hatchback (X01) 1.8 (F08, F68),
OPEL Corsa C Hatchback (X01) 1.7 DTI (F08, F68),
OPEL Corsa C Hatchback (X01) 1.7 DI (F08, F68),
OPEL Corsa C Hatchback (X01) 1.4 (F08, F68),
OPEL Corsa C Hatchback (X01) 1.0 (F08, F68),
OPEL Corsa C Hatchback (X01) 1.7 CDTI (F08, F68),
OPEL Corsa C Hatchback (X01) 1.2 Twinport (F08, F68),
OPEL Corsa C Hatchback (X01) 1.4 Twinport (F08, F68)
…
View more
The steps may slightly vary depending on the car design.
How to change a front shock strut on OPEL CORSA C (F08, F68) [TUTORIAL AUTODOC]
All the parts you need to replace – Shock Absorber for Corsa C Hatchback (X01) and other OPEL models
Replacement: suspension strut – Opel Corsa C. Tip from AUTODOC:
Both shock struts of the front suspension should be replaced simultaneously.
The replacement procedure is identical for the left and right shock struts of the front suspension.
All work should be done with the engine stopped.
Replacement: suspension strut – Opel Corsa C. Take the following steps:
Step 1
Open the bonnet.
Step 2
Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.
Step 3
Remove the shock strut mount cap. Use a flat screwdriver.
Step 4
Treat the shock strut rod. Use a wire brush. Use WD-40 spray.
Step 5
Loosen the upper fastener of the shock strut mount. Use a shock absorber socket DD№8. Use a drive socket #18. Use a ratchet wrench.
Step 6
Secure the wheels with chocks.
Step 7
Loosen the wheel mounting bolts. Use wheel impact socket #17.
Step 8
Raise the front of the car and secure on supports.
Step 9
Unscrew the wheel bolts.
AUTODOC recommends:
Important! Hold the wheel while unscrewing the fastening bolts. Opel Corsa C
Step 10
Remove the wheel.
Step 11
Clean the stabiliser link fasteners. Use a wire brush. Use WD-40 spray.
Step 12
Unscrew the fastener connecting the stabilizer link to the shock strut. Use a combination spanner #18. Use a drive socket #8. Use a ratchet wrench.
Step 13
Remove the stabilizer rod.
Replacement: suspension strut – Opel Corsa C. AUTODOC recommends:
Examine stabiliser bushes. Replace them if needed.
Step 14
Clean the fasteners connecting the shock strut to the steering knuckle. Use a wire brush. Use WD-40 spray.
Step 15
Disconnect the fastener of the ABS sensor cable from the shock absorber strut.
Step 16
Unscrew the lower fastener connecting the shock strut to the steering knuckle. Use a combination spanner #18. Use a drive socket #18. Use a tap wrench.
Step 17
Remove the fastening bolt.
Step 18
Prop up the steering knuckle. Use a hydraulic transmission jack.
Step 19
Remove the fastening bolt.
Step 20
Disconnect the steering knuckle from the shock absorber strut. Use a crowbar.
Step 21
Unscrew the top fastening of the shock strut mount.
Replacement: suspension strut – Opel Corsa C. Professionals recommend:
To avoid injuries, hold the shock strut when undoing the fastening bolts.
Step 22
Remove the suspension strut.
Step 23
Set the shock absorber strut on the spring compressor tool.
Replacement: suspension strut – Opel Corsa C. AUTODOC experts recommend:
Note that when using a spring compressor, spring coils need to be securely gripped, compressing the spring on the opposite sides.Ensure the correct position of the spring in the retainer.Make sure that the spring coils tightly entered the lock handles.
Step 24
Compress the spring.
Step 25
Remove the strut piston rod nut. Use a drive socket #19. Use a shock absorber socket DD№8. Use a ratchet wrench.
Step 26
Remove the shock absorber mount, boot and bump stop.
AUTODOC recommends:
Replacement: suspension strut – Opel Corsa C. Carefully inspect the mount, the boot, and the bump stop of the shock absorber. Replace if necessary.
Step 27
Release the coil spring.
Step 28
Remove the spring.
Step 29
Remove the old shock absorber from the hydraulic coil spring compressor.
Replacement: suspension strut – Opel Corsa C. AUTODOC experts recommend:
Before installing a new shock absorber you should pump it manually 3-5 times.
Step 30
Install the new shock absorber on the hydraulic coil spring compressor.
Step 31
Install the spring on the shock absorber.
Step 32
Compress the spring.
Step 33
Install the mount, the boot and the bump stop on the shock absorber.
Step 34
Tighten the shock strut piston rod nut. Use a drive socket #19. Use a shock absorber socket DD№8. Use a torque wrench. Tighten it to 55 Nm torque.
Replacement: suspension strut – Opel Corsa C. Tip from AUTODOC experts:
Check to make sure the spring is positioned correctly. Avoid its misalignment.
Step 35
Decompress the spring.
Step 36
Remove the assembled shock strut.
Step 37
Install the shock strut into the wheel arch.
Step 38
Screw the top fastening of the shock strut mount. Do not tighten it.
AUTODOC recommends:
Important! Hold the suspension strut while screwing in the fastening bolts. Opel Corsa C
Step 39
Treat the shock strut mounting seat on the steering knuckle. Use a wire brush. Use WD-40 spray.
Step 40
Fix the shock absorber strut on the steering knuckle.
Step 41
Install the fastening bolts.
Step 42
Screw in the fastener that connects the shock strut to the steering knuckle. Use a combination spanner #18. Use a drive socket #18.
Step 43
Remove the support from under the steering knuckle.
AUTODOC recommends:
Replacement: suspension strut – Opel Corsa C. Lower the transmission jack smoothly, without jerks, to avoid damaging components and mechanisms.
Step 44
Connect the fastener of the ABS sensor cable to the shock absorber strut.
Step 45
Ιnstall the transverse stabilizer link.
Step 46
Tighten the fastener connecting the stabilizer link to the shock strut. Use a combination spanner #18. Use a drive socket #8. Use a torque wrench. Tighten it to 60 Nm torque.
Step 47
Tighten the lower fasteners connecting the shock strut to the steering knuckle. Use a combination spanner #18. Use a drive socket #18. Use a torque wrench. Tighten it to 80 Nm torque.+60°
AUTODOC recommends:
Important! Be sure to use new fasteners.
Step 48
Treat the surface where the brake disc contacts the wheel rim. Use copper grease.
Step 49
Clean the brake disk surface. Use a brake cleaner.
Replacement: suspension strut – Opel Corsa C. Tip from AUTODOC:
After applying the spray, wait a few minutes.
Step 50
Install the wheel.
AUTODOC recommends:
Important! Hold the wheel while screwing in the fastening bolts. Opel Corsa C
Step 51
Screw in the wheel bolts. Use wheel impact socket #17.
Step 52
Lower the car.
Step 53
Tighten the upper fastener of the shock absorber strut mount. Use a combination spanner #18. Use a drive socket #18. Use a shock absorber socket DD№8. Use a ratchet wrench. Use a torque wrench. Tighten it to 55 Nm torque.
Step 54
Treat the fasteners of the shock strut mount. Use copper grease.
Step 55
Install the shock strut mount cap.
Step 56
Tighten the wheel bolts using a criss-cross pattern. Use a torque wrench. Tighten it to 110 Nm torque.
Step 57
Remove the fender protection cover.
Step 58
Close the hood.
Step 59
Remove the jacks and chocks.
Comments –
1
B. S.
06.05.2024 19:50
Member
Very useful. Thank you!
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 1
Searching for the right tyres?
Find out which tyre and wheel sizes are compatible with the OPEL Corsa C Hatchback (X01) model.
It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents
Install the AUTODOC CLUB app!
Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.
Scan
To download the app:
- scan the QR code
- download from App Store
- download from Google Play
Tips & tricks for your OPEL Corsa C Hatchback (X01)
View more
BMW E30 Turbo Suspension Swap: Boost Your Handling | AUTODOC project
5 Essential Tips to Prepare Your Car for Winter | AUTODOC tips
DIY starter repair | AUTODOC tips
Can You Hear Your Brakes Squeaking? Learn the Causes and DIY Solutions! | AUTODOC Tips