Important!
This replacement procedure can be used for:
VW Jetta Mk5 (1K) 1.6, VW Jetta Mk5 (1K) 1.6 FSI, VW Jetta Mk5 (1K) 2.0 FSI, VW Jetta Mk5 (1K) 1.9 TDI, VW Jetta Mk5 (1K) 2.0 TDI 16V, VW Jetta Mk5 (1K) 2.0 TFSI, VW Jetta Mk5 (1K) 2.0 TDI, VW Jetta Mk5 (1K) 1.4 TSI, VW Jetta Mk5 (1K) 1.4 TSI, VW Jetta Mk5 (1K) 2.0 TDI, VW Jetta Mk5 (1K) 2.0 TDI, VW Jetta Mk5 (1K) 1.4 TSI, VW Jetta Mk5 (1K) 2.5, VW Jetta Mk5 (1K) 2.5, VW Jetta Mk5 (1K) 1.4 TSI, VW Jetta Mk5 (1K) 1.6 TDI, VW Jetta Mk5 (1K) 1.6 MultiFuel View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Control Arm for Jetta Mk5 (1K) and other VW models
Tools
Replacement: front lower arm – VW JETTA III (1K2). Tools you'll need:
Wire brush
WD-40 spray
Drive socket # 16
Drive socket # 18
Combination spanner #18
Copper grease
Torque wrench
Wheel impact socket #17
Ball joint puller
Crow bar
Hydraulic transmission jack
Wheel chock
Replacement: front lower arm – VW JETTA III (1K2). AUTODOC recommends:
  • The replacement procedure is identical for the left and right lower control arms.
  • Replacement of the independent suspension lower arm in some cars requires a part of the outlet piping of the additional heater to be removed.
  • Please note: all work on the car – VW JETTA III (1K2) – should be done with the engine switched off.
Carry out replacement in the following order:
  1. Step 1
    Secure the wheels with chocks.
    Step 2
    How to change Control Arm on VW Jetta 1k2 2005 - free PDF and video manuals
    Loosen the wheel mounting bolts. Use wheel impact socket #17.
  2. Step 3
    Raise the front of the car and secure on supports.
    Step 4
    How to replace VW Jetta Mk5 (1K) 1.9 TDI 2006 Control Arm - step-by-step manuals and video guides
    Unscrew the wheel bolts.
    Replacement: front lower arm – VW JETTA III (1K2). Tip:
    To avoid injury, hold up the wheel when unscrewing the bolts.
  3. Step 5
    VW Jetta 1k2 1.6 2007 Control Arm replacement: free workshop manuals
    Remove the wheel.
  4. Step 6
    Remove the lower sound insulation.
    Please note!
    Some cars are not equipped with the lower sound insulation.
    Step 7
    Changing Control Arm on VW Jetta Mk5 (1K) 1.6 FSI 2008 by yourself
    Clean all joints of the arm. Use a wire brush. Treat all joints of the arm. Use WD-40 spray.
    AUTODOC recommends:
    Replacement: front lower arm – VW JETTA III (1K2). After applying the spray, wait a few minutes.Wear protective goggles.
  5. Step 8
    How to remove VW JETTA 2.0 TDI 2009 Control Arm - online easy-to-follow instructions
    Unscrew the ball joint fastening nut. Use a combination spanner #18.
  6. Step 9
    How to replace Control Arm on VW Jetta Mk5 (1K) 2010: download PDF manuals and video instructions
    Loosen the fastening nut, remove the arm from the steering knuckle using a ball joint puller. If necessary, use a crowbar.
  7. Step 10
    How hard is it to do yourself: Control Arm replacement on VW Jetta 1k2 1.6 TDI 2005 - download illustrated guide
    Unscrew the front arm fastener. Use a drive socket No.18 or ring spanner No.18.
  8. Step 11
    Need to know how to renew Control Arm on VW JETTA 2006? This free workshop manual will help you to do it yourself
    Unscrew the rear arm fastener. Use a drive socket #16, #18.
  9. Step 12
    Changing of Control Arm on VW Jetta 1k2 2007 won't be an issue if you follow this illustrated step-by-step guide
    Remove the arm. Use a crowbar.
  10. Step 13
    Clean the mounting seats and the thread of the suspension arm. Use a wire brush. Use WD-40 spray.
    Step 14
    VW JETTA 2.0 TFSI Control Arm replacement: online guides and video tutorials
    Install a new arm. Insert the ball joint into the steering knuckle and fix it with a new nut.
    AUTODOC recommends:
    Do not damage the ball joint cover.
  11. Step 15
    Replacing Control Arm on VW Jetta 1k2 2009 1.9 TDI by yourself
    Install the front fastener of the arm. Do not tighten it.
  12. Step 16
    Jetta Mk5 (1K) 2.0 TDI 2010 Control Arm DIY replacement workshop manual
    Install the rear fastener of the arm.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Searching for the right tyres?

Find out which tyre and wheel sizes are compatible with the VW Jetta Mk5 (1K) model.

Your profile is your personal assistant.

It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents

Install the AUTODOC CLUB app!
Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.
VW Jetta Mk5 (1K) Control Arm replace by yourself - Scan QR-code and download AUTODOC CLUB app
Scan

To download the app:

  • - scan the QR code
  • - download from App Store
  • - download from Google Play
DIY VW Jetta Mk5 (1K) Control Arm replacement - online guide
Tips & tricks for your VW Jetta Mk5 (1K)
View more
  • How to change Control arm on VW Jetta Mk5 (1K) 2.0 TDI 16V - replacement tricks
    What causes engine misfire? | AUTODOC
  • Changing Wishbone VW Jetta 1k2 1.9 TDI - Replacement Tips
    Coolant comparison test | AUTODOC
  • Maintenance Hacks - VW Jetta Mk5 (1K) 1.6 Control arms replacement guide
    How to polish your car | AUTODOC tips
  • Replace Trailing arm on VW Jetta 1k2 - free video tips
    How to fix your car with AUTODOC CLUB