Disclaimer
How to change front door handle on NISSAN Pathfinder III (R51) – replacement guide
downloads:
30
Views:
521
Important!
This replacement procedure can be used for:
NISSAN Pathfinder III (R51) 2.5 dCi 4WD, NISSAN Pathfinder III (R51) 4.0 4WD, NISSAN Pathfinder III (R51) 2.5 dCi 4WD, NISSAN Pathfinder III (R51) 2.5 dCi 4WD, NISSAN Pathfinder III (R51) 3.0 dCi, NISSAN Pathfinder III (R51) 2.5 dCi 4WD … View more
The steps may slightly vary depending on the car design.
NISSAN Pathfinder III (R51) 2.5 dCi 4WD, NISSAN Pathfinder III (R51) 4.0 4WD, NISSAN Pathfinder III (R51) 2.5 dCi 4WD, NISSAN Pathfinder III (R51) 2.5 dCi 4WD, NISSAN Pathfinder III (R51) 3.0 dCi, NISSAN Pathfinder III (R51) 2.5 dCi 4WD … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Door Handles for Pathfinder III (R51) and other NISSAN models
Alternative products

Torque wrench
Torx bit T20
Drive socket # 10
Ratchet wrench
Flat Screwdriver
Round-nose pliers
Plastic trim tool
Replacement: door handle – NISSAN PATHFINDER (R51). AUTODOC experts recommend:
- The replacement procedure is identical for the left and right door handles.
- All work should be done with the engine stopped.
Carry out replacement in the following order:
- Step 1
Open the car door. - Step 2
Detach the door handle trim panel. Use a plastic trim tool. - Step 3
Unscrew the door handle fastener. Use a drive socket #10. Use a ratchet wrench. - Step 4
Remove the door handle.AUTODOC recommends:Replacement: door handle – NISSAN PATHFINDER (R51). Do not use excessive force when removing the part as this may damage it. - Step 5
Detach the door card. Use a plastic trim tool.Replacement: door handle – NISSAN PATHFINDER (R51). Tip:Do not apply excessive force when removing the part. Otherwise you may damage it. - Step 6
Detach the power window connector from the switch module. - Step 7
Remove the power window switch module. - Step 8
Attach the power window connector to the switch module. - Step 9
Switch on the ignition. - Step 10Remove the covers from the window raiser fasteners.Step 11
Lower the window glass.Replacement: door handle – NISSAN PATHFINDER (R51). AUTODOC recommends:Continue lowering the window glass until its fasteners become visible. - Step 12
Switch off the ignition. - Step 13
Unscrew the window glass fasteners. Use a drive socket #10. Use a ratchet wrench. - Step 14
Raise the glass a little and remove it.Replacement: door handle – NISSAN PATHFINDER (R51). Tip from AUTODOC:To avoid injury, hold the glass when raising it. - Step 15
Unscrew the fastener of the interior door handle. Use a drive socket #10. Use a ratchet wrench. - Step 16
Remove the interior door handle. - Step 17
Unscrew the door panel fasteners. Use a drive socket #10. Use a ratchet wrench. - Step 18
Detach the power window wiring harness. - Step 19
Detach the power window connector. Use round-nose pliers. - Step 20
Unscrew the door panel fasteners. Use a drive socket #10. Use a ratchet wrench. - Step 21
Remove the door panel together with the window regulator linkage.Replacement: door handle – NISSAN PATHFINDER (R51). Professionals recommend:Do not apply excessive force when removing the part. Otherwise you may damage it. - Step 22
Remove the cover from the exterior door handle fastener. Use a flat screwdriver. - Step 23
Unscrew the fastener of the exterior door handle. Use Torx T20. Use a ratchet wrench. - Step 24
Remove the exterior door handle.Replacement: door handle – NISSAN PATHFINDER (R51). Tip from AUTODOC experts:Do not apply excessive force when removing the part. Otherwise you may damage it. - Step 25
Remove the exterior door handle gaskets. - Step 26
Release the exterior door handle actuator. Use a flat screwdriver. - Step 27
Detach the exterior door handle actuator cable. - Step 28
Attach the exterior door handle actuator cable. - Step 29
Install the exterior door handle actuator. - Step 30
Install the exterior door handle gaskets. - Step 31
Install the new exterior door handle.Replacement: door handle – NISSAN PATHFINDER (R51). Tip:When installing, do not use excessive force to avoid damage to the part.Check if the handle works correctly.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the NISSAN Pathfinder III (R51) model
Popular maintenance tutorials for Nissan Pathfinder r51
Complete guides for changing the Door handles on different NISSAN PATHFINDER models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your NISSAN Pathfinder III (R51)
View more
How to Make a DIY Foam Sprayer | AUTODOC tips
Regain Your Confidence on the Road: Easy Headlight Restoration Tips
5 mistakes when replacing consumables
How to get your motorcycle ready for spring
Most commonly replaced car parts on NISSAN PATHFINDER
Time to replace parts? Get even better deals in our Shop app.

SCAN ME








































