Recommended replacement interval for the part category Brake pad set : 30000 km

Important!

This replacement procedure can be used for:
AUDI TT Roadster (8J9) 2.0 TFSI, AUDI TT Roadster (8J9) 2.0 TFSI quattro, AUDI TT Roadster (8J9) 2.0 TFSI, AUDI TT Roadster (8J9) 3.2 V6 quattro, AUDI TT Roadster (8J9) 1.8 TFSI, AUDI TT Roadster (8J9) 2.0 TDI quattro, AUDI TT Roadster (8J9) 2.0 TFSI quattro … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Brake Pads for TT Roadster (8J9) and other AUDI models

Alternative products

Brake pad set

Replacement: brake pads – AUDI TT Roadster (8J9). Tools you need:

                      Wire brush
                    
                      Nylon cleaning brush
                    
                      Brake cleaner 
                    
                      Anti-squeal paste
                    
                      Copper grease 
                    
                      Torque wrench
                    
                      HEX bit No.H7
                    
                      Torx bit T27
                    
                      Wheel impact socket #17
                    
                      Ratchet wrench
                    
                      Brake caliper wind back tool
                    
                      Crow bar
                    
                      Wheel chock

Buy tools

Replacement: brake pads – AUDI TT Roadster (8J9). AUTODOC recommends:

Perform the replacement of brake pads in complete set for each axis. This provides effective braking.
The replacement procedure is identical for all brake pads on the same axle.
Please note: all work on the car – AUDI TT Roadster (8J9) – should be done with the engine switched off.

Carry out replacement in the following order:

Step 1

Open the hood.

Step 2

Clean the brake fluid reservoir cap. Use a brake cleaner.

AUTODOC recommends:
Replacement: brake pads – AUDI TT Roadster (8J9). After applying the spray, wait a few minutes.
Step 3

Unscrew the engine solenoid valve bracket. Use Torx T27. Use a ratchet wrench.
Step 4

Unscrew the brake fluid reservoir cap.
Step 5

Secure the wheels with chocks.

Step 6

Loosen the wheel mounting bolts. Use wheel impact socket #17.
Step 7

Raise the front of the car and secure on supports.

Step 8

Unscrew the wheel bolts.

AUTODOC recommends:
Warning! To avoid injury, hold the wheel while unscrewing the fastening bolts. AUDI TT Roadster (8J9)
Step 9

Remove the wheel.
Step 10

Spread the brake pads. Use a crowbar.
Step 11

Remove the dust boot caps of the brake caliper guide pins. Use a crowbar.
Step 12

Unscrew the brake caliper fastening. Use HEX No.H7. Use a ratchet wrench.
Step 13

Detach the brake caliper retaining spring. Use a crowbar.
Step 14

Remove the brake caliper.

Replacement: brake pads – AUDI TT Roadster (8J9). AUTODOC recommends:
Tie the caliper to the suspension or to the body with a wire without disconnecting from the brake hose to prevent depressurization of the brake system.Make sure that the brake caliper is not hanging on the brake hose.Don't press the brake pedal after the brake caliper has been removed. As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur. Check the brake caliper bracket, brake caliper guide pins and boots. Clean them. Replace, if necessary.
Step 15

Remove the brake pads.

AUTODOC recommends:
Measure the brake disc thickness. Upon reaching the wear limit the part must be replaced.
Step 16

Clean the brake caliper bracket from dirt and dust. Use a wire brush. Use a brake cleaner.

AUTODOC recommends:
Replacement: brake pads – AUDI TT Roadster (8J9). After applying the spray, wait a few minutes.
Step 17

Treat the brake caliper piston. Use a nylon cleaning brush. Use a brake cleaner.

Replacement: brake pads – AUDI TT Roadster (8J9). Tip from AUTODOC:
After applying the spray, wait a few minutes.
Step 18

Press in the brake caliper piston. Use brake caliper wind back tool.
Step 19

Treat the brake pads in the area where their surface comes into contact with the brake caliper bracket. Use anti-squeal paste.

Replacement: brake pads – AUDI TT Roadster (8J9). Tip from AUTODOC experts:
Make sure the disc surface is clean before installing the pads.
Step 20

Install new brake pads.

AUTODOC recommends:
Make sure the pads are installed with linings facing the disc.
Step 21

Install the brake caliper and fix it. Use HEX No.H7. Use a torque wrench. Tighten it to 30 Nm torque.
Step 22

Install the dust boot caps of the brake caliper guide pins.
Step 23

Install the brake caliper retaining spring. Use a crowbar.
Step 24

Treat the surface where the brake disc contacts the wheel rim. Use copper grease.
Step 25

Clean the brake disk surface. Use a brake cleaner.

AUTODOC recommends:
Replacement: brake pads – AUDI TT Roadster (8J9). After applying the spray, wait a few minutes.
Step 26

Install the wheel.

AUTODOC recommends:
To avoid injury, hold up the wheel when screwing in the fastening bolts.
Step 27

Screw in the wheel bolts. Use wheel impact socket #17.
Step 28

Lower the car and working in a cross order, tighten the wheel bolts. Use wheel impact socket #17. Use a torque wrench. Tighten it to 120 Nm torque.
Step 29

Remove the jacks and chocks.

Replacement: brake pads – AUDI TT Roadster (8J9). Tip from AUTODOC:
Check the brake fluid level in the expansion tank and refill if necessary.Without starting the engine, press the brake pedal several times until you feel significant resistance.
Step 30

Tighten the brake fluid reservoir cap.
Step 31

Install the engine solenoid valve bracket. Use Torx T27. Use a ratchet wrench.

Step 32

Close the hood.

Replacement: brake pads – AUDI TT Roadster (8J9). AUTODOC recommends:
Slow down smoothly for first 150-200 km after the brake pads replacement. Avoid unneccessary and sharp braking to a stop.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

Need New Tyres?

Find out which tyre and wheel sizes are compatible with the AUDI TT Roadster (8J9) model

Audi TT Roadster tyre size

How to change front brake caliper on AUDI TT Roadster (8J9) – replacement guide

Free download PDF
2.25 MB
How to change rear brake caliper on AUDI TT Roadster (8J9) – replacement guide

Free download PDF
2.14 MB
How to change rear brake pads on AUDI TT Roadster (8J9) – replacement guide

Free download PDF
1.43 MB
How to change front ABS sensor on AUDI TT Roadster (8J9) – replacement guide

Free download PDF
1.28 MB
How to change front brake discs on AUDI TT Roadster (8J9) – replacement guide

Free download PDF
2.18 MB
How to change rear wheel bearing on AUDI TT Roadster (8J9) – replacement guide

Free download PDF
2.23 MB

How to change rear brake pads on AUDI TT Coupe (8J3) – replacement guide

Free download PDF
1.43 MB
How to change front brake pads on AUDI TT Coupe (8J3) – replacement guide

Free download PDF
1.63 MB
How to change rear brake pads on AUDI TT Coupe (8N3) – replacement guide

Free download PDF
1.53 MB
How to change front brake pads on AUDI TT Coupe (FV3, FVP) – replacement guide

Free download PDF
1.64 MB
How to change rear brake pads on AUDI TT Coupe (FV3, FVP) – replacement guide

Free download PDF
1.52 MB
How to change rear brake pads on AUDI TT Roadster (8N9) – replacement guide

Free download PDF
1.53 MB

Unlock your car maintenance assistant!

Track expenses, manage logs, schedule replacements, and more.

5 Essential Tips for beginner drivers: Avoid Common Mistakes

4K views

Published on: 31/01/2023
How to Fix P0401 ✅ error code Insufficient EGR flow

4K views

Published on: 08/05/2025
#DIY Wheel Rim Restoration: Revive Scratches and Chips Easily!

7K views

Published on: 18/07/2024
How to restore a steering wheel | AUTODOC tips

56K views

Published on: 17/02/2022