
Disclaimer
How to change front brake discs on CITROËN Xantia Hatchback (X1_, X2_) – replacement guide
downloads:
1
Views:
14

Recommended replacement interval for the part category Brake disc : 50000 km
Important!
This replacement procedure can be used for:
CITROËN Xantia Hatchback (X1_, X2_) 1.6 i, CITROËN Xantia Hatchback (X1_, X2_) 1.8 i, CITROËN Xantia Hatchback (X1_, X2_) 2.0 i, CITROËN Xantia Hatchback (X1_, X2_) 1.9 Turbo D, CITROËN Xantia Hatchback (X1_, X2_) 1.9 D, CITROËN Xantia Hatchback (X1_, X2_) 1.9 D, CITROËN Xantia Hatchback (X1_, X2_) 1.8 i 16V, CITROËN Xantia Hatchback (X1_, X2_) 1.9 SD, CITROËN Xantia Hatchback (X1_, X2_) 1.8 i … View more
The steps may slightly vary depending on the car design.
CITROËN Xantia Hatchback (X1_, X2_) 1.6 i, CITROËN Xantia Hatchback (X1_, X2_) 1.8 i, CITROËN Xantia Hatchback (X1_, X2_) 2.0 i, CITROËN Xantia Hatchback (X1_, X2_) 1.9 Turbo D, CITROËN Xantia Hatchback (X1_, X2_) 1.9 D, CITROËN Xantia Hatchback (X1_, X2_) 1.9 D, CITROËN Xantia Hatchback (X1_, X2_) 1.8 i 16V, CITROËN Xantia Hatchback (X1_, X2_) 1.9 SD, CITROËN Xantia Hatchback (X1_, X2_) 1.8 i … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Brake Discs for Xantia Hatchback (X1_, X2_) and other CITROËN models
Brake disc
Alternative products

Wire brush
WD-40 spray
Brake cleaner
Copper grease
Combination spanner #13
Combination spanner #15
Torx bit T55
Wheel impact socket #19
Brake caliper wind back tool
Torque wrench
Phillips screwdriver
Impact screwdriver
Rubber mallet
Tap wrench
Crow bar
Wheel chock
Replacement: brake discs – CITROËN XANTIA (X1). AUTODOC recommends:
- Replace the brake disks on the car CITROËN XANTIA (X1) in complete set for each axis. Regardless of the state of components. This will ensure even braking.
- The replacement procedure is identical for both brake disks on the same axle.
- When changing the brake discs, always replace the brake pads.
- All work should be done with the engine stopped.
Replacement: brake discs – CITROËN XANTIA (X1). Use the following procedure:
- Step 1Open the bonnet. Unscrew the brake fluid reservoir cap.Step 2Secure the wheels with chocks.
- Step 3Loosen the wheel mounting bolts. Use wheel impact socket #19.
- Step 4Raise the front of the car and secure on supports.Step 5Unscrew the wheel bolts.Replacement: brake discs – CITROËN XANTIA (X1). Tip from AUTODOC:To avoid injury, hold up the wheel when unscrewing the bolts.
- Step 6Remove the wheel.
- Step 7Clean the brake caliper fasteners. Use a wire brush. Use WD-40 spray.
- Step 8Unscrew the brake caliper fastening. Use a combination spanner #13. Use a combination spanner #15.
- Step 9Spread the brake pads. Use a crowbar.
- Step 10Remove the brake caliper.Replacement: brake discs – CITROËN XANTIA (X1). Professionals recommend:Tie the caliper to the suspension or to the body with a wire without disconnecting from the brake hose to prevent depressurization of the brake system.Make sure that the brake caliper is not hanging on the brake hose.Don't press the brake pedal after the brake caliper has been removed. As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur. Check the brake caliper bracket, brake caliper guide pins and boots. Clean them. Replace, if necessary.
- Step 11Remove the brake pads.
- Step 12Clean the brake caliper bracket fasteners. Use a wire brush. Use WD-40 spray.
- Step 13Unscrew the caliper bracket fastening. Use Torx T55. Use a tap wrench.
- Step 14Remove the caliper bracket.
- Step 15Clean the brake disc fasteners. Use a wire brush. Use WD-40 spray.Step 16Unscrew the brake disc fastening. Use a Phillips screwdriver. Use an impact screwdriver.Step 17Remove the brake disc. Use a rubber mallet.
- Step 18Clean the hub. Use a wire brush. Treat the contacting surface. Use copper grease.
- Step 19Install the brake disc.
- Step 20Tighten the brake disc fastening. Use a Phillips screwdriver. Use a torque wrench. Tighten it to 9 Nm torque.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the CITROËN Xantia Hatchback (X1, X2) model
Popular maintenance tutorials for Citroen Xantia X1
Complete guides for changing the Brake rotors on different CITROËN XANTIA models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your CITROËN Xantia Hatchback (X1_, X2_)
View more
- How to Swap an M50 Engine in a BMW E30 Turbo | AUTODOC Project
- #TPMS Explained: Why Your Light is On and How to Respond Safely
- Top 5 possible reasons your car is shaking or vibrating
- How to make an injector test bench yourself
Most commonly replaced car parts on CITROËN XANTIA
Time to replace parts? Get even better deals in our Shop app.

SCAN ME