Disclaimer
How to change engine oil and filter on VW Iltis (183) – replacement guide
downloads:
1
Views:
19
Recommended replacement interval for the part category Oil filter : 12 month / 15000 km
Important!
This replacement procedure can be used for:
VW ILTIS (183) 1.7 … View more
The steps may slightly vary depending on the car design.
VW ILTIS (183) 1.7 … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Oil Filter for ILTIS (183) and other VW models
Alternative products

Wire brush
All-purpose cleaning spray
Oil filter cup socket 76-14F
Drive socket # 19
Torx bit T20
Combination spanner #19
Ratchet wrench
Torque wrench
Oil drain pan
Funnel
Fender cover
Replacement: engine oil and filter – VW ILTIS (183). Tip from AUTODOC experts:
- Replace the oil filter every time when changing motor oil.
- Use only new O-rings during installation.
- Wear gloves to prevent contact with hot liquid.
- All work should be done with the engine stopped.
Replacement: engine oil and filter – VW ILTIS (183). Take the following steps:
- Step 1Open the hood.Step 2Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.Step 3
Unscrew the oil filler plug. - Step 4Lift the car using a jack or place it over an inspection pit.Replacement: engine oil and filter – VW ILTIS (183). AUTODOC recommends:The vehicle must be on even keel, and if it is at an angle, the drain plug must be at the lowest point.Step 5
Undo the fasteners of the oil pan lower cover. Use Torx T20. Use a ratchet wrench. - Step 6
Remove the oil pan cover. - Step 7
Put a waste oil container with at least 5 l capacity under the drainage hole. - Step 8
Clean the area of the oil pan drainage hole. Use a wire brush. Use all-purpose cleaning spray. - Step 9
Unscrew the drain plug. Use a combination spanner #19. - Step 10
Drain the used oil.Replacement: engine oil and filter – VW ILTIS (183). Tip from AUTODOC:Caution! The oil may be hot. - Step 11
Clean the oil filter seat. Use all-purpose cleaning spray. - Step 12Prepare a container for the old oil filter.Step 13
Unscrew the oil filter. Use the 76-14F socket. Use a ratchet wrench. - Step 14
Put the old oil filter in the container.Replacement: engine oil and filter – VW ILTIS (183). Tip from AUTODOC experts:Move up the container. The oil starts to drain out of the drainage hole immediately after you have removed the oil filter. - Step 15
Clean the oil filter seat. - Step 16
Lubricate the rubber seal of the new filter with a little amount of fresh oil. - Step 17
Screw the new filter into its place. Use the 76-14F socket. Use a torque wrench. Tighten it to 18 Nm torque.Replacement: engine oil and filter – VW ILTIS (183). Professionals recommend:Wait until the oil has completely drained from the drainage hole. - Step 18
Clean the area of the oil pan drainage hole.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the VW Iltis (183) model
Popular maintenance tutorials for VW ILTIS (183)
Complete guides for changing the Oil filters on different VW ILTIS models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your VW ILTIS (183)
View more
Coolant comparison test | AUTODOC
How to restore a steering wheel | AUTODOC tips
2 ways to clean the EGR valve – which one is better?
#DIY Guide: How to Fix a Cracked Windscreen Without a Garage Visit
Most commonly replaced car parts on VW ILTIS
Time to replace parts? Get even better deals in our Shop app.

SCAN ME































