Disclaimer
How to change engine oil and filter on RENAULT CLIO IV Box – replacement guide
downloads:
3
Views:
136
Recommended replacement interval for the part category Oil filter : 2 year / 30000 km
Important!
This replacement procedure can be used for:
RENAULT CLIO IV Box 1.2 16V LPG (BHMG), RENAULT CLIO IV Box 1.2 16V (BHMK), RENAULT CLIO IV Box 1.2 16V … View more
The steps may slightly vary depending on the car design.
RENAULT CLIO IV Box 1.2 16V LPG (BHMG), RENAULT CLIO IV Box 1.2 16V (BHMK), RENAULT CLIO IV Box 1.2 16V … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Oil Filter for CLIO IV Box and other RENAULT models
Alternative products

Wire brush
All-purpose cleaning spray
Square oil drain plug socket No.8
Oil filter cup socket 76-14F
Ratchet wrench
Torque wrench
Oil drain pan
Funnel
Microfibre towel
Fender cover
Replacement: engine oil and filter – RENAULT CLIO IV Box AUTODOC recommends:
- Replace the oil filter every time when changing motor oil.
- Wear gloves to prevent contact with hot liquid.
- Use only new O-rings during installation.
- All work should be done with the engine stopped.
Replacement: engine oil and filter – RENAULT CLIO IV Box. Take the following steps:
- Step 1Open the hood.Step 2Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.Step 3
Unscrew the oil filler plug. - Step 4Lift the car using a jack or place it over an inspection pit.Replacement: engine oil and filter – RENAULT CLIO IV Box Tip from AUTODOC:The vehicle must be on even keel, and if it is at an angle, the drain plug must be at the lowest point.All work should be done with the engine stopped.Step 5
Put a waste oil container with at least 4 l capacity under the drainage hole. - Step 6
Clean the area of the oil pan drainage hole. Use a wire brush. - Step 7
Unscrew the drain plug. Use square oil drain plug socket No.8 Use a ratchet wrench. - Step 8
Drain the used oil.Replacement: engine oil and filter – RENAULT CLIO IV Box Tip from AUTODOC experts:Caution! The oil may be hot.Wait until the oil has completely drained from the drainage hole. - Step 9
Move the container under the oil filter. - Step 10
Unscrew the oil filter. - Step 11
Prepare a container for the old oil filter. Put the old oil filter in the container.Replacement: engine oil and filter – RENAULT CLIO IV Box. AUTODOC experts recommend:Move up the container. The oil starts to drain out of the drainage hole immediately after you have removed the oil filter. - Step 12
Clean the oil filter seat. - Step 13
Lubricate the rubber seal of the new filter with a little amount of fresh oil. - Step 14
Screw the new filter into its place. Use the 76/14-F socket. Use a torque wrench. Tighten it to 19 nm torque.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the RENAULT Clio IV Van model
Popular maintenance tutorials for RENAULT CLIO IV Box
Complete guides for changing the Oil filters on different RENAULT CLIO models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your RENAULT CLIO IV Box
View more
Unveiling the secrets: Detecting vacuum leaks with a Smoke Machine | AUTODOC
TOP 8 mistakes car owners make | AUTODOC tips
Top 5 brake repair mistakes | AUTODOC tips
#DIY Guide: How to Fix a Cracked Windscreen Without a Garage Visit
Most commonly replaced car parts on RENAULT CLIO
Time to replace parts? Get even better deals in our Shop app.

SCAN ME



























