Disclaimer
How to change engine oil and filter on NISSAN INTERSTAR Box (X70) – replacement guide
downloads:
12
Views:
289
Recommended replacement interval for the part category Oil filter : 2 year / 40000 km
Important!
This replacement procedure can be used for:
NISSAN INTERSTAR Box (X70) dCi 80 … View more
The steps may slightly vary depending on the car design.
NISSAN INTERSTAR Box (X70) dCi 80 … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Oil Filter for INTERSTAR Box (X70) and other NISSAN models
Alternative products

Wire brush
All-purpose cleaning spray
Torque wrench
Oil filter cup socket 76-14F
Square oil drain plug socket No.8
Ratchet wrench
Oil drain pan
Funnel
Fender cover
Replacement: engine oil and filter – NISSAN INTERSTAR Box (X70). AUTODOC recommends:
- Replace the oil filter every time when changing motor oil.
- Wear gloves to prevent contact with hot liquid.
- All work should be done with the engine stopped.
Replacement: engine oil and filter – NISSAN INTERSTAR Box (X70). Use the following procedure:
- Step 1Open the hood.Step 2Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.Step 3
Unscrew the oil filler plug. - Step 4Lift the car using a jack or place it over an inspection pit.Replacement: engine oil and filter – NISSAN INTERSTAR Box (X70). AUTODOC experts recommend:The vehicle must be on even keel, and if it is at an angle, the drain plug must be at the lowest point.Step 5
Put a waste oil container with at least 5 l capacity under the drainage hole. - Step 6
Clean the area of the oil pan drainage hole. Use a wire brush. Use all-purpose cleaning spray. - Step 7
Unscrew the drain plug. Use square oil drain plug socket No.8 Use a ratchet wrench. - Step 8
Drain the used oil.Replacement: engine oil and filter – NISSAN INTERSTAR Box (X70). Tip from AUTODOC:Caution! The oil may be hot. - Step 9
Disconnect the air intake pipe from the air filter housing. - Step 10
Unscrew the oil filter. Use the 76-14F socket. Use a ratchet wrench. - Step 11
Remove the oil filter. - Step 12
Put the old oil filter in the container.Replacement: engine oil and filter – NISSAN INTERSTAR Box (X70). Tip:Move up the container. The oil starts to drain out of the drainage hole immediately after you have removed the oil filter. - Step 13
Lubricate the rubber seal of the new filter with a little amount of fresh oil. - Step 14
Clean the oil filter seat. - Step 15
Install a new oil filter. - Step 16
Screw the new filter into its place. Use the 76-14F socket. Use a torque wrench. Tighten it to 25 Nm torque. - Step 17
Connect the air intake pipe to the air filter housing.Replacement: engine oil and filter – NISSAN INTERSTAR Box (X70). Tip from AUTODOC experts:Wait until the oil has completely drained from the drainage hole. - Step 18
Clean the area of the oil pan drainage hole.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the NISSAN Interstar Van (X70) model
Popular maintenance tutorials for Nissan Interstar Van
Complete guides for changing the Oil filters on different NISSAN INTERSTAR models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your NISSAN INTERSTAR Box (X70)
View more
Top 5 Mistakes to Avoid for Safe Engine Bay Repairs | AUTODOC Tips
5 Ways You’re Scrubbing Your Car Wrong | AUTODOC Tips
Extend your engine's life: Avoid these 3 damaging factors | AUTODOC tips
How to align the timing marks correctly on an EA888 engine
Most commonly replaced car parts on NISSAN INTERSTAR
Time to replace parts? Get even better deals in our Shop app.

SCAN ME






































