Recommended replacement interval for the part category Oil filter : 1 year / 20000 km

Important!

This replacement procedure can be used for:
CITROËN C3 II (SC_) 1.0 VTi 68, CITROËN C3 II (SC_) 1.2 VTi 82, CITROËN C3 II (SC_) 1.2 THP 110 … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Oil Filter for C3 II (SC_) and other CITROËN models

Oil filter

        Oil filter for CITROËN C3 II (SC_) 1.0 VTi 68 Petrol (68 hp)
      
        Oil filter for CITROËN C3 II (SC_) 1.2 VTi 82 Petrol (82 hp)
      
        Oil filter for CITROËN C3 II (SC_) 1.2 THP 110 Petrol (110 hp)

Replacement: engine oil and filter – CITROËN C3 II. List of the tools you'll need:

                        Wire brush
                      
                        All-purpose cleaning spray
                      
                        Oil filter cup socket 74/76-15F
                      
                        Drive socket # 21 
                      
                        Ratchet wrench
                      
                        Torque wrench
                      
                        Oil drain pan
                      
                        Funnel
                      
                        Fender cover

Buy tools

Replacement: engine oil and filter – CITROËN C3 II. Tip from AUTODOC:

Replace the oil filter every time when changing motor oil.
All work should be done with the engine stopped.
Wear gloves to prevent contact with hot liquid.

Replacement: engine oil and filter – CITROËN C3 II. Recommended sequence of steps:

Step 1

Open the hood.

Step 2

Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.

Step 3

Unscrew the oil filler plug.
Step 4

Unscrew the oil filter. Use the 74/76-15F socket.
Step 5

Prepare a container for the old oil filter. Put the old oil filter in the container.

Replacement: engine oil and filter – CITROËN C3 II. AUTODOC experts recommend:
Move up the container. The oil starts to drain out of the drainage hole immediately after you have removed the oil filter.
Step 6

Lift the car using a jack or place it over an inspection pit.

Replacement: engine oil and filter – CITROËN C3 II. AUTODOC recommends:
The vehicle must be on even keel, and if it is at an angle, the drain plug must be at the lowest point.All work should be done with the engine stopped.
Step 7

Put a waste oil container with at least 5 l capacity under the drainage hole.
Step 8

Clean the area of the oil pan drainage hole. Use a wire brush. Use all-purpose cleaning spray.
Step 9

Unscrew the drain plug. Use a drive socket #21. Use a ratchet wrench.
Step 10

Drain the used oil.

Replacement: engine oil and filter – CITROËN C3 II. Professionals recommend:
Caution! The oil may be hot.
Step 11

Wait until the oil has completely drained from the drainage hole.

Step 12

Clean the area of the oil pan drainage hole.
Step 13

Screw in the new drainage plug and tighten it. Use a drive socket #21. Use a torque wrench. Tighten it to 34 Nm torque.
Step 14

Clean the area of the oil pan drainage hole. Use all-purpose cleaning spray.
Step 15

Lower the car.

Step 16

Lubricate the rubber seal of the new filter with a little amount of fresh oil.
Step 17

Screw the new filter into its place. Use the 74/76-15F socket. Use a torque wrench. Tighten it to 25 Nm torque.
Step 18

Remove the oil filler cap. Insert the funnel.
Step 19

Pour new oil into the engine in the amount recommended by the car manufacturer.

Replacement: engine oil and filter – CITROËN C3 II. Tip:
Use the oil recommended by the manufacturer.
Step 20

Check the oil level using the dipstick. Top up oil if necessary.

Please note!
The oil level should be between the Min and Max marks.
Step 21

Install the oil filler cap.

Step 22

Tighten the oil filler cap.
Step 23

Run the engine for a few minutes. After the oil pressure warning light goes out, stop the engine.
Step 24

Check the oil level 5 minutes after the stop of the engine operation using a dipstick and add oil if necessary.

Please note!
The oil level should be between the Min and Max marks.Make sure that the oil filler cap is properly tightened.Check the threaded plug of the drainage hole and the oil filter seal for tightness. If necessary, carefully tighten them up.
Step 25

Remove the fender protection cover.

Step 26

Close the hood.

Replacement: engine oil and filter – CITROËN C3 II. Tip from AUTODOC experts:
Note that oil pressure warning light, which indicates insufficient pressure in the lubrication system, may be on for a longer time than usual. After a few seconds, the oil will fill all the channels, and the light will go out. To protect the environment from pollution, be sure to dispose of the used filters at special collection points.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

How to change fuel filter on CITROËN C3 II (SC_) – replacement guide

Free download PDF
942.08 KB
How to change air filter on CITROËN C3 II (SC_) – replacement guide

Free download PDF
1.12 MB
How to change pollen filter on CITROËN C3 II (SC_) – replacement guide

Free download PDF
737.28 KB
How to change front brake pads on CITROËN C3 II (SC_) – replacement guide

Free download PDF
1.28 MB
How to change rear brake pads on CITROËN C3 II (SC_) – replacement guide

Free download PDF
1.59 MB
How to change rear brake discs on CITROËN C3 II (SC_) – replacement guide

Free download PDF
2.31 MB

How to change engine oil and filter on CITROËN C3 Picasso – replacement guide

Free download PDF
1.17 MB
How to change engine oil and filter on Citroen C3 1 – replacement guide

Free download PDF
1.65 MB
How to change engine oil and filter on CITROËN C3 Pluriel (HB_) – replacement guide

Free download PDF
1.29 MB
How to change engine oil and filter on CITROËN C3 III (SX) – replacement guide

Free download PDF
1.18 MB
How to change engine oil and filter on CITROËN C4 AIRCROSS – replacement guide

Free download PDF
1.52 MB
How to change engine oil and filter on CITROËN C3 Aircross II (2R_, 2C_) – replacement guide

Free download PDF
1.18 MB

Your profile is your personal assistant.

It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents

Install the AUTODOC CLUB app!

Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.

Scan

To download the app:

- scan the QR code
- download from App Store
- download from Google Play

How to replace a wheel stud | AUTODOC tips

8K views

Published on: 08/12/2020
DIY brake caliper restoration | AUTODOC tips

547K views

Published on: 02/06/2022
How to restore wheel rims | AUTODOC tips

6K views

Published on: 13/05/2021
How to remove scratches from car plastic | AUTODOC tips

97K views

Published on: 15/12/2022