Recommended replacement interval for the part category Brake pad set : 30000 km

Important!

This replacement procedure can be used for:
CITROËN C3 II (SC_) 1.1 BiFuel, CITROËN C3 II (SC_) 1.1 i, CITROËN C3 II (SC_) 1.4, CITROËN C3 II (SC_) 1.4 VTi, CITROËN C3 II (SC_) 1.6 VTi, CITROËN C3 II (SC_) 1.6 HDi, CITROËN C3 II (SC_) 1.6 HDi, CITROËN C3 II (SC_) 1.6 HDi, CITROËN C3 II (SC_) 1.4 HDi (SC8HZC, SC8HR0, SC8HP4), CITROËN C3 II (SC_) 1.4 LPG, CITROËN C3 II (SC_) 1.0 VTi, CITROËN C3 II (SC_) 1.2 VTi, CITROËN C3 II (SC_) 1.6 HDi, CITROËN C3 II (SC_) 1.2 THP, CITROËN C3 II (SC_) 1.6 BlueHDi, CITROËN C3 II (SC_) 1.6 BlueHDi, CITROËN C3 II (SC_) 1.4 VTi, CITROËN C3 II (SC_) 1.4 LPG … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Brake Pads for C3 II (SC_) and other CITROËN models

Alternative products

Brake pad set

Replacement: brake pads – CITROËN C3 II. List of the tools you'll need:

                      Wire brush
                    
                      WD-40 spray
                    
                      Brake cleaner 
                    
                      Anti-squeal paste
                    
                      Copper grease 
                    
                      Combination spanner #13
                    
                      Combination spanner #15
                    
                      Wheel impact socket #19
                    
                      Torque wrench
                    
                      Brake caliper wind back tool
                    
                      Crow bar
                    
                      Wheel chock

Buy tools

Replacement: brake pads – CITROËN C3 II. Tip:

Perform the replacement of brake pads in complete set for each axis. This provides effective braking.
The replacement procedure is identical for all brake pads on the same axle.
All work should be done with the engine stopped.

Replacement: brake pads – CITROËN C3 II. Use the following procedure:

Step 1

Open the bonnet. Unscrew the brake fluid reservoir cap.

Step 2

Secure the wheels with chocks.
Step 3

Loosen the wheel mounting bolts. Use wheel impact socket #19.
Step 4

Raise the front of the car and secure on supports.

Step 5

Unscrew the wheel bolts.

AUTODOC recommends:
Important! Hold the wheel while unscrewing the fastening bolts. CITROËN C3 II
Step 6

Remove the wheel.
Step 7

Clean the brake caliper fasteners. Use a wire brush. Use WD-40 spray.
Step 8

Unscrew the brake caliper fastening. Use a combination spanner #13. Use a combination spanner #15.
Step 9

Spread the brake pads. Use a crowbar.
Step 10

Remove the brake caliper.

Replacement: brake pads – CITROËN C3 II. AUTODOC recommends:
Tie the caliper to the suspension or to the body with a wire without disconnecting from the brake hose to prevent depressurization of the brake system.Make sure that the brake caliper is not hanging on the brake hose.Don't press the brake pedal after the brake caliper has been removed. As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur. Check the brake caliper bracket, brake caliper guide pins and boots. Clean them. Replace, if necessary.
Step 11

Remove the brake pads.

Replacement: brake pads – CITROËN C3 II. AUTODOC experts recommend:
Measure the brake disc thickness. Upon reaching the wear limit the part must be replaced.
Step 12

Treat the brake caliper piston. Use a brake cleaner.

AUTODOC recommends:
Replacement: brake pads – CITROËN C3 II. After applying the spray, wait a few minutes.
Step 13

Press in the brake caliper piston. Use brake caliper wind back tool.
Step 14

Clean the brake caliper bracket from dirt and dust. Use a wire brush. Use a brake cleaner.

Replacement: brake pads – CITROËN C3 II. Professionals recommend:
After applying the spray, wait a few minutes.
Step 15

Treat the brake pads in the area where their surface comes into contact with the brake caliper bracket. Use anti-squeal paste.

AUTODOC recommends:
Make sure the disc surface is clean before installing the pads.
Step 16

Install new brake pads.

Replacement: brake pads – CITROËN C3 II. Tip from AUTODOC experts:
Make sure the pads are installed with linings facing the disc.
Step 17

Install the brake caliper and fix it. Use a combination spanner #13. Use a combination spanner #15. Use a torque wrench. Tighten it to 27 Nm torque.
Step 18

Treat the surface where the brake disc contacts the wheel rim. Use copper grease.
Step 19

Clean the brake disk surface. Use a brake cleaner.

AUTODOC recommends:
Replacement: brake pads – CITROËN C3 II. After applying the spray, wait a few minutes.
Step 20

Install the wheel.

Replacement: brake pads – CITROËN C3 II. AUTODOC recommends:
To avoid injury, hold up the wheel when screwing in the fastening bolts.
Step 21

Screw in the wheel bolts. Use wheel impact socket #19.
Step 22

Lower the car and working in a cross order, tighten the wheel bolts. Use a torque wrench. Tighten it to 100 Nm torque.

AUTODOC recommends:
Important! Replacement: brake pads – CITROËN C3 II. Check the brake fluid level in the reservoir and top up if necessary.
Step 23

Tighten the brake fluid reservoir cap. Close the hood.

Replacement: brake pads – CITROËN C3 II. Professionals recommend:
Without starting the engine, press the brake pedal several times until you feel significant resistance.
Step 24

Remove the jacks and chocks.

AUTODOC recommends:
Slow down smoothly for first 150-200 km after the brake pads replacement. Avoid unneccessary and sharp braking to a stop.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

Need New Tyres?

Find out which tyre and wheel sizes are compatible with the CITROËN C3 II (SC) model

Citroën C3 II tyre size

How to change rear brake discs on CITROËN C3 II (SC_) – replacement guide

Free download PDF
2.31 MB
How to change front brake discs on CITROËN C3 II (SC_) – replacement guide

Free download PDF
1.89 MB
How to change rear brake pads on CITROËN C3 II (SC_) – replacement guide

Free download PDF
1.59 MB
How to change front brake discs on CITROËN C3 II (SC) – replacement guide

Free download PDF
3.03 MB
How to change front wheel bearing on CITROËN C3 II (SC_) – replacement guide

Free download PDF
5.02 MB
How to change rear wheel bearing on CITROËN C3 II (SC_) – replacement guide

Free download PDF
2.15 MB

How to change rear brake pads on CITROËN C3 Picasso – replacement guide

Free download PDF
1.59 MB
How to change front brake pads on CITROËN C3 Picasso – replacement guide

Free download PDF
1.28 MB
How to change rear brake pads on CITROËN C3 II (SC_) – replacement guide

Free download PDF
1.59 MB
How to change front brake pads on Citroen C3 1 – replacement guide

Free download PDF
1.42 MB
How to change rear brake pads on CITROËN C3 I Hatchback (FC_, FN_) – replacement guide

Free download PDF
1.58 MB
How to change front brake pads on CITROËN C3 III (SX) – replacement guide

Free download PDF
1.28 MB

Unlock your car maintenance assistant!

Track expenses, manage logs, schedule replacements, and more.

Don’t Replace, Just Polish! Headlight Restoration with AUTODOC

9K views

Published on: 13/01/2021
How to choose the right engine oil for your car | AUTODOC

12K views

Published on: 01/07/2020
Revive Your Tyres: Expert Tips for a Lasting Shine | AUTODOC Guide

4K views

Published on: 07/04/2022
DIY manual gearbox restoration | Drivetrain restoration – Part 3

13K views

Published on: 14/11/2024