Disclaimer
How to change engine oil and filter on BMW 3 Convertible (E93) – replacement guide
downloads:
16
Views:
239
Recommended replacement interval for the part category Oil filter : 12 month / 15000 km
Important!
This replacement procedure can be used for:
BMW 3 Convertible (E93) 320 i, BMW 3 Convertible (E93) 320 i, BMW 3 Convertible (E93) 320i, BMW 3 Convertible (E93) 318 i … View more
The steps may slightly vary depending on the car design.
BMW 3 Convertible (E93) 320 i, BMW 3 Convertible (E93) 320 i, BMW 3 Convertible (E93) 320i, BMW 3 Convertible (E93) 318 i … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Oil Filter for 3 Convertible (E93) and other BMW models
Alternative products

All-purpose cleaning spray
Oil filter cup socket 86/16 F
Drive socket # 17
Ratchet wrench
Torque wrench
Flat Screwdriver
Funnel
Oil drain pan
Microfibre towel
Fender cover
AUTODOC recommends:
- Replace the oil filter every time when changing motor oil.
- Please note: all work on the car – BMW 3 Convertible (E93) convertible – should be done with the engine switched off.
- Wear gloves to prevent contact with hot liquid.
Carry out replacement in the following order:
- Step 1Open the hood.Step 2Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.Step 3
Unscrew the oil filler plug. - Step 4Lift the car using a jack or place it over an inspection pit.Replacement: engine oil and filter – BMW 3 Convertible (E93) convertible. Tip:The vehicle must be on even keel, and if it is at an angle, the drain plug must be at the lowest point.Step 5
Put a waste oil container with at least 6 l capacity under the drainage hole. - Step 6
Unscrew the drain plug. Use a drive socket #17. Use a ratchet wrench. - Step 7
Drain the used oil.Replacement: engine oil and filter – BMW 3 Convertible (E93) convertible. Tip from AUTODOC:Caution! The oil may be hot. - Step 8
Unscrew the oil filter. Use the 86/16 F socket. - Step 9
Remove the oil filter. - Step 10
Prepare a container for the old oil filter. Put the old oil filter in the container.Replacement: engine oil and filter – BMW 3 Convertible (E93) convertible. AUTODOC experts recommend:Move up the container. The oil starts to drain out of the drainage hole immediately after you have removed the oil filter. - Step 11
Cover the oil filter housing with a microfibre towel to prevent dirt and foreign objects from getting into the system. - Step 12
Detach the oil filter from the filter cover. - Step 13
Remove old o-rings from the oil filter cover. Use a flat screwdriver. - Step 14
Clean the oil filter housing cap. Use all-purpose cleaning spray. - Step 15
Install new O-rings and a new oil filter to their mounting seats on the filter cover.Please note!Make sure to install the filter correctly. Don't mix up the sides of the part. - Step 16
Remove the microfibre towel from the oil filter housing. - Step 17
Clean the oil filter seat. - Step 18
Lubricate the rubber seal of the new filter with a little amount of fresh oil. - Step 19
Screw the new filter into its place.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the BMW 3 Convertible (E93) model
Popular maintenance tutorials for BMW E93
Complete guides for changing the Oil filters on different BMW 3 SERIES models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your BMW 3 Convertible (E93)
View more
Fuse Replacement Made Simple: Step-by-Step Guide | AUTODOC
Top 7 signs of a bad starter
5 Essential Tips for beginner drivers: Avoid Common Mistakes
Transform Your Car's Look: 6 Simple Accessories You Need to Try!
Most commonly replaced car parts on BMW 3 SERIES
Time to replace parts? Get even better deals in our Shop app.

SCAN ME





























