Recommended replacement interval for the part category Brake pad set : 30000 km

Important!

This replacement procedure can be used for:
BMW 3 Convertible (E93) 318 i, BMW 3 Convertible (E93) 325 d, BMW 3 Convertible (E93) 320 i, BMW 3 Convertible (E93) 325 i, BMW 3 Convertible (E93) 330 i, BMW 3 Convertible (E93) 330 d, BMW 3 Convertible (E93) 325 i, BMW 3 Convertible (E93) 325 d, BMW 3 Convertible (E93) 320 d, BMW 3 Convertible (E93) 330 d, BMW 3 Convertible (E93) 320 d, BMW 3 Convertible (E93) 320 i … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Brake Pads for 3 Convertible (E93) and other BMW models

Brake pad set

        Brake pad set for 3 Convertible (E93) Petrol (143 hp)
      
        Brake pad set for 3 Convertible (E93) Diesel (204 hp)
      
        Brake pad set for 3 Convertible (E93) Petrol (170 hp)
      
        Brake pad set for 3 Convertible (E93) Petrol (218 hp)
      
        Brake pad set for 3 Convertible (E93) Petrol (272 hp)
      
        Brake pad set for 3 Convertible (E93) Diesel (231 hp)
      
        Brake pad set for 3 Convertible (E93) Petrol (218 hp)
      
        Brake pad set for 3 Convertible (E93) Diesel (197 hp)
      
        Brake pad set for 3 Convertible (E93) Diesel (177 hp)

Replacement: brake pads – BMW 3 Convertible (E93). Tools you might need:

                        Wire brush
                      
                        Brake cleaner 
                      
                        Anti-squeal paste
                      
                        Copper grease 
                      
                        HEX bit No.H7.
                      
                        Wheel impact socket #17
                      
                        Brake caliper wind back tool
                      
                        Ratchet wrench
                      
                        Torque wrench
                      
                        Crow bar
                      
                        Fender cover
                      
                        Wheel chock

Buy tools

Replacement: brake pads – BMW 3 Convertible (E93). AUTODOC experts recommend:

Perform the replacement of brake pads in complete set for each axis. This provides effective braking.
The replacement procedure is identical for all brake pads on the same axle.
All work should be done with the engine stopped.

Replacement: brake pads – BMW 3 Convertible (E93). Recommended sequence of steps:

Step 1

Open the hood.

Step 2

Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.

Step 3

Remove the wiper arm cover.
Step 4

Unscrew the brake fluid reservoir cap.
Step 5

Secure the wheels with chocks.

Step 6

Loosen the wheel mounting bolts. Use wheel impact socket #17.
Step 7

Raise the front of the car and secure on supports.

Step 8

Unscrew the wheel bolts.

AUTODOC recommends:
Warning! To avoid injury, hold the wheel while unscrewing the fastening bolts. BMW 3 Convertible (E93)
Step 9

Remove the wheel.
Step 10

Remove the dust boot caps of the brake caliper guide pins. Use a crowbar.
Step 11

Unscrew the brake caliper fastening. Use HEX No.H7. Use a ratchet wrench.
Step 12

Spread the brake pads. Use a crowbar.
Step 13

Detach the brake caliper retaining spring. Use a crowbar.
Step 14

Remove the brake caliper.

Replacement: brake pads – BMW 3 Convertible (E93). AUTODOC recommends:
Tie the caliper to the suspension or to the body with a wire without disconnecting from the brake hose to prevent depressurization of the brake system.Make sure that the brake caliper is not hanging on the brake hose.Don't press the brake pedal after the brake caliper has been removed. As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur. Check the brake caliper bracket, brake caliper guide pins and boots. Clean them. Replace, if necessary.
Step 15

Remove the brake pads.

Replacement: brake pads – BMW 3 Convertible (E93). Tip:
Measure the brake disc thickness. Upon reaching the wear limit the part must be replaced.
Step 16

Treat the brake caliper piston. Use a brake cleaner.

AUTODOC recommends:
Replacement: brake pads – BMW 3 Convertible (E93). After applying the spray, wait a few minutes.
Step 17

Press in the brake caliper piston. Use brake caliper wind back tool.
Step 18

Clean the brake caliper bracket from dirt and dust. Use a wire brush. Use a brake cleaner.

Replacement: brake pads – BMW 3 Convertible (E93). Tip from AUTODOC:
After applying the spray, wait a few minutes.
Step 19

Treat the brake pads in the area where their surface comes into contact with the brake caliper bracket. Use anti-squeal paste.

Replacement: brake pads – BMW 3 Convertible (E93). Professionals recommend:
Make sure the disc surface is clean before installing the pads.
Step 20

Install new brake pads.

Replacement: brake pads – BMW 3 Convertible (E93). Tip from AUTODOC experts:
Make sure the pads are installed with linings facing the disc.
Step 21

Install the brake caliper and fix it. Use HEX No.H7. Use a torque wrench. Tighten it to 30 Nm torque.
Step 22

Install the dust boot caps of the brake caliper guide pins.
Step 23

Install the brake caliper retaining spring.
Step 24

Treat the surface where the brake disc contacts the wheel rim. Use copper grease.
Step 25

Clean the brake disk surface. Use a brake cleaner.

AUTODOC recommends:
Replacement: brake pads – BMW 3 Convertible (E93). After applying the spray, wait a few minutes.
Step 26

Install the wheel.

Replacement: brake pads – BMW 3 Convertible (E93). AUTODOC recommends:
To avoid injury, hold up the wheel when screwing in the fastening bolts.
Step 27

Screw in the wheel bolts. Use wheel impact socket #17.
Step 28

Lower the car and working in a cross order, tighten the wheel bolts. Use a torque wrench. Tighten it to 120 Nm torque.
Step 29

Remove the jacks and chocks.

AUTODOC recommends:
Important! Replacement: brake pads – BMW 3 Convertible (E93). Check the brake fluid level in the reservoir and top up if necessary.
Step 30

Tighten the brake fluid reservoir cap.

AUTODOC recommends:
BMW 3 Convertible (E93) – Press the brake pedal several times with the engine shut down until you feel the resistance built up.
Step 31

Install the wiper arm cover.

Step 32

Remove the fender protection cover.

Step 33

Close the hood.

Replacement: brake pads – BMW 3 Convertible (E93). AUTODOC experts recommend:
Slow down smoothly for first 150-200 km after the brake pads replacement. Avoid unneccessary and sharp braking to a stop.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

Searching for the right tyres?

Find out which tyre and wheel sizes are compatible with the BMW 3 Convertible (E93) model.

Browse tyres

How to change rear brake discs on BMW 3 Convertible (E93) – replacement guide

Free download PDF
2.18 MB
How to change rear brake pad wear sensor on BMW 3 Convertible (E93) – replacement guide

Free download PDF
1.2 MB
How to change front brake pad wear sensor on BMW 3 Convertible (E93) – replacement guide

Free download PDF
1.29 MB
How to change front ABS sensor on BMW 3 Convertible (E93) – replacement guide

Free download PDF
1.38 MB
How to change front brake discs on BMW 3 Convertible (E93) – replacement guide

Free download PDF
1.95 MB
How to change rear brake pads on BMW 3 Convertible (E93) – replacement guide

Free download PDF
1.53 MB

How to change front brake pads on BMW E90 – replacement guide

Free download PDF
1.7 MB
How to change rear brake pads on BMW E90 – replacement guide

Free download PDF
1.58 MB
How to change rear brake pads on BMW 3 Saloon (F30, F80) – replacement guide

Free download PDF
1.91 MB
How to change rear brake pads on BMW 3 Saloon (E46) – replacement guide

Free download PDF
1.79 MB
How to change front brake pads on BMW 3 Saloon (E46) – replacement guide

Free download PDF
1.62 MB
How to change front brake pads on BMW E92 – replacement guide

Free download PDF
1.89 MB

Your profile is your personal assistant.

It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents

Install the AUTODOC CLUB app!

Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.

Scan

To download the app:

- scan the QR code
- download from App Store
- download from Google Play

DIY valve cover restoration | AUTODOC tips

6K views

Published on: 29/06/2023
Top 5 reasons why the suspension knocks | AUTODOC tips

1M views

Published on: 09/09/2022
What to do if the belt squeals | AUTODOC tips

4K views

Published on: 04/03/2021
What to do if your car heater isn't working | AUTODOC tips

4K views

Published on: 11/02/2021