Disclaimer
How to change engine oil and filter on AUDI 100 C3 Avant (44, 44Q) – replacement guide
downloads:
0
Views:
4
Recommended replacement interval for the part category Oil filter : 1 year / 15000 km
Important!
This replacement procedure can be used for:
AUDI 100 Avant (44, 44Q, C3) 1.8, AUDI 100 Avant (44, 44Q, C3) 1.8, AUDI 100 Avant (44, 44Q, C3) 1.8, AUDI 100 Avant (44, 44Q, C3) 2.0, AUDI 100 Avant (44, 44Q, C3) 2.0 E Cat, AUDI 100 Avant (44, 44Q, C3) 2.1, AUDI 100 Avant (44, 44Q, C3) 2.2, AUDI 100 Avant (44, 44Q, C3) 2.2, AUDI 100 Avant (44, 44Q, C3) 2.2 Turbo, AUDI 100 Avant (44, 44Q, C3) 2.3, AUDI 100 Avant (44, 44Q, C3) 2.3, AUDI 100 Avant (44, 44Q, C3) 2.2 quattro, AUDI 100 Avant (44, 44Q, C3) 2.2 Turbo quattro, AUDI 100 Avant (44, 44Q, C3) 2.3 E quattro, AUDI 100 Avant (44, 44Q, C3) 2.3 quattro, AUDI 100 Avant (44, 44Q, C3) 2.2 E quattro, AUDI 100 Avant (44, 44Q, C3) 1.9, AUDI 100 Avant (44, 44Q, C3) 1.8 quattro, AUDI 100 Avant (44, 44Q, C3) 1.8 Cat quattro, AUDI 100 Avant (44, 44Q, C3) 1.8 quattro, AUDI 100 Avant (44, 44Q, C3) 2.0 E, AUDI 100 Avant (44, 44Q, C3) 2.2 Cat, AUDI 100 Avant (44, 44Q, C3) 2.2 Cat quattro, AUDI 100 Avant (44, 44Q, C3) 1.8 Cat … View more
The steps may slightly vary depending on the car design.
AUDI 100 Avant (44, 44Q, C3) 1.8, AUDI 100 Avant (44, 44Q, C3) 1.8, AUDI 100 Avant (44, 44Q, C3) 1.8, AUDI 100 Avant (44, 44Q, C3) 2.0, AUDI 100 Avant (44, 44Q, C3) 2.0 E Cat, AUDI 100 Avant (44, 44Q, C3) 2.1, AUDI 100 Avant (44, 44Q, C3) 2.2, AUDI 100 Avant (44, 44Q, C3) 2.2, AUDI 100 Avant (44, 44Q, C3) 2.2 Turbo, AUDI 100 Avant (44, 44Q, C3) 2.3, AUDI 100 Avant (44, 44Q, C3) 2.3, AUDI 100 Avant (44, 44Q, C3) 2.2 quattro, AUDI 100 Avant (44, 44Q, C3) 2.2 Turbo quattro, AUDI 100 Avant (44, 44Q, C3) 2.3 E quattro, AUDI 100 Avant (44, 44Q, C3) 2.3 quattro, AUDI 100 Avant (44, 44Q, C3) 2.2 E quattro, AUDI 100 Avant (44, 44Q, C3) 1.9, AUDI 100 Avant (44, 44Q, C3) 1.8 quattro, AUDI 100 Avant (44, 44Q, C3) 1.8 Cat quattro, AUDI 100 Avant (44, 44Q, C3) 1.8 quattro, AUDI 100 Avant (44, 44Q, C3) 2.0 E, AUDI 100 Avant (44, 44Q, C3) 2.2 Cat, AUDI 100 Avant (44, 44Q, C3) 2.2 Cat quattro, AUDI 100 Avant (44, 44Q, C3) 1.8 Cat … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Oil Filter for 100 Avant (44, 44Q, C3) and other AUDI models
Alternative products

Wire brush
All-purpose cleaning spray
Torque wrench
Drive socket # 17
Oil filter cup socket 76/14-F
Ratchet wrench
Funnel
Oil drain pan
Fender cover
Replacement: engine oil and filter – AUDI 100 Avant (44, 44Q, C3). Tip from AUTODOC experts:
- Replace the oil filter every time when changing motor oil.
- Wear gloves to prevent contact with hot liquid.
- All work should be done with the engine stopped.
Replacement: engine oil and filter – AUDI 100 Avant (44, 44Q, C3). Recommended sequence of steps:
- Step 1Lift the car using a jack or place it over an inspection pit.AUTODOC recommends:The vehicle must be on even keel, and if it is at an angle, the drain plug must be at the lowest point.Unscrew the oil filler plug.Step 2Clean the area of the oil pan drainage hole. Use a wire brush. Use all-purpose cleaning spray.Step 3
Unscrew the drain plug. Use a drive socket #17. Use a ratchet wrench. - Step 4
Put a waste oil container with at least 4 l capacity under the drainage hole. - Step 5
Drain the used oil.Replacement: engine oil and filter – AUDI 100 Avant (44, 44Q, C3). AUTODOC recommends:Caution! The oil may be hot.Wait until the oil has completely drained from the drainage hole. - Step 6
Clean the area of the oil pan drainage hole. - Step 7
Screw in the new drainage plug and tighten it. Use a drive socket #17. Use a torque wrench. Tighten it to 30 nm torque. - Step 8
Clean the area of the oil pan drainage hole. Use all-purpose cleaning spray. - Step 9Lower the car.Step 10Open the hood.Step 11Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.Step 12
Unscrew the oil filter. Use the 76/14-F socket. Use a ratchet wrench. - Step 13
Put the old oil filter in the container. - Step 14Clean the oil filter seat. Use all-purpose cleaning spray.Step 15
Lubricate the rubber seal of the new filter with a little amount of fresh oil.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the AUDI 100 C3 Avant (44, 44Q) model
Popular maintenance tutorials for Audi 100 Avant C3
Complete guides for changing the Oil filters on different AUDI 100 models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your AUDI 100 Avant (44, 44Q, C3)
View more
TOP 5 mistakes when replacing shock absorbers | AUTODOC tips
Coolant comparison test | AUTODOC
5 mistakes made when washing the engine | AUTODOC tips
Motorcycle fuel tank restoration
Most commonly replaced car parts on AUDI 100
Time to replace parts? Get even better deals in our Shop app.

SCAN ME


























