Recommended replacement interval for the part category Oil filter : 12 month / 15000 km

Important!

This replacement procedure can be used for:
ALPINE V6 I TURBO, ALPINE V6 I TURBO … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

Alternative products

Oil filter

Replacement: engine oil and filter – ALPINE V6. Tools you might need:

                      Wire brush
                    
                      All-purpose cleaning spray
                    
                      Torque wrench
                    
                      Oil filter cup socket 76-14F
                    
                      Square oil drain plug socket No.8
                    
                      Ratchet wrench
                    
                      Oil drain pan
                    
                      Funnel
                    
                      Fender cover

Buy tools

Replacement: engine oil and filter – ALPINE V6. AUTODOC recommends:

Replace the oil filter every time when changing motor oil.
Wear gloves to prevent contact with hot liquid.
All work should be done with the engine stopped.

Replacement: engine oil and filter – ALPINE V6. Use the following procedure:

Step 1

Open the hood.

Step 2

Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.

Step 3

Unscrew the oil filler plug.
Step 4

Lift the car using a jack or place it over an inspection pit.

Replacement: engine oil and filter – ALPINE V6. AUTODOC experts recommend:
The vehicle must be on even keel, and if it is at an angle, the drain plug must be at the lowest point.
Step 5

Put a waste oil container with at least 5 l capacity under the drainage hole.
Step 6

Clean the area of the oil pan drainage hole. Use a wire brush. Use all-purpose cleaning spray.
Step 7

Unscrew the drain plug. Use square oil drain plug socket No.8 Use a ratchet wrench.
Step 8

Drain the used oil.

Replacement: engine oil and filter – ALPINE V6. Tip from AUTODOC:
Caution! The oil may be hot.
Step 9

Disconnect the air intake pipe from the air filter housing.
Step 10

Unscrew the oil filter. Use the 76-14F socket. Use a ratchet wrench.
Step 11

Remove the oil filter.
Step 12

Put the old oil filter in the container.

Replacement: engine oil and filter – ALPINE V6. Tip:
Move up the container. The oil starts to drain out of the drainage hole immediately after you have removed the oil filter.
Step 13

Lubricate the rubber seal of the new filter with a little amount of fresh oil.
Step 14

Clean the oil filter seat.
Step 15

Install a new oil filter.
Step 16

Screw the new filter into its place. Use the 76-14F socket. Use a torque wrench. Tighten it to 25 Nm torque.
Step 17

Connect the air intake pipe to the air filter housing.

Replacement: engine oil and filter – ALPINE V6. Tip from AUTODOC experts:
Wait until the oil has completely drained from the drainage hole.
Step 18

Clean the area of the oil pan drainage hole.
Step 19

Screw in the new drainage plug and tighten it. Use square oil drain plug socket No.8 Use a torque wrench. Tighten it to 20 nm torque.
Step 20

Clean the area of the oil pan drainage hole. Use all-purpose cleaning spray.
Step 21

Lower the car.

Step 22

Remove the oil filler cap.
Step 23

Insert the funnel.
Step 24

Pour new oil into the engine in the amount recommended by the car manufacturer.

Replacement: engine oil and filter – ALPINE V6. Tip from AUTODOC:
Use the oil recommended by the manufacturer.
Step 25

Check the oil level using the dipstick. Top up oil if necessary.

Please note!
The oil level should be between the Min and Max marks.
Step 26

Install the oil filler cap.

Step 27

Tighten the oil filler cap.
Step 28

Run the engine for a few minutes. After the oil pressure warning light goes out, stop the engine.

Step 29

Check the oil level 5 minutes after the stop of the engine operation using a dipstick and add oil if necessary.

Please note!
The oil level should be between the Min and Max marks.Make sure that the oil filler cap is properly tightened.Check the threaded plug of the drainage hole and the oil filter seal for tightness. If necessary, carefully tighten them up.
Step 30

Remove the fender protection cover.

Step 31

Close the hood.

Replacement: engine oil and filter – ALPINE V6. Tip from AUTODOC experts:
Note that oil pressure warning light, which indicates insufficient pressure in the lubrication system, may be on for a longer time than usual. After a few seconds, the oil will fill all the channels, and the light will go out. To protect the environment from pollution, be sure to dispose of the used filters at special collection points.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

Need New Tyres?

Find out which tyre and wheel sizes are compatible with the ALPINE V6 I model

ALPINE V6 tyre size

How to change engine oil and filter on ALPINE V6 I – replacement guide

Free download PDF
1.61 MB
How to change engine oil and filter on ALPINE A310 Coupe – replacement guide

Free download PDF
1.17 MB
How to change fuel filter on ALPINE A110 II – replacement guide

Free download PDF
808.96 KB
How to change engine oil and filter on ALPINE A110 II – replacement guide

Free download PDF
1.47 MB

How to change engine oil and filter on a car – replacement tutorial

Universal

Free download PDF
2.82 MB
How to change engine oil and filter on ALPINE A310 Coupe – replacement guide

Free download PDF
1.17 MB
How to change engine oil and filter on ALPINE A110 II – replacement guide

Free download PDF
1.47 MB
How to change engine oil and filter on VW Polo 9N – replacement guide

Free download PDF
2.34 MB
How to change engine oil and filter on Nissan Qashqai J10 – replacement guide

Free download PDF
2.86 MB
How to change engine oil and filter on Mercedes W204 – replacement guide

Free download PDF
1.84 MB

Unlock your car maintenance assistant!

Track expenses, manage logs, schedule replacements, and more.

Top Automatic Transmission Blunders You Must Dodge | AUTODOC Insights

7K views

Published on: 26/01/2021
How to tell if a tie rod is faulty

7K views

Published on: 24/07/2025
#DIY Wheel Rim Restoration: Revive Scratches and Chips Easily!

7K views

Published on: 18/07/2024
5 most common causes of oil leaks | AUTODOC tips

69K views

Published on: 30/03/2023