Recommended replacement interval for the part category V-Ribbed Belt Set : 5 year / 120000 km

Important!

This replacement procedure can be used for:
VAUXHALL Movano Mk I (A) Van (X70) 2.5 CDTI (FD), VAUXHALL Movano Mk I (A) Van (X70) 2.5 CDTI (FD), VAUXHALL Movano Mk I (A) Van (X70) 2.5 CDTI (FD) … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

Alternative products

V-Ribbed Belt Set

Replacement: serpentine belt – VAUXHALL MOVANO Mk I (A) Van (FD). Tools you need:

                      Wire brush
                    
                      WD-40 spray
                    
                      All-purpose cleaning spray
                    
                      Ceramic grease
                    
                      Torque wrench
                    
                      13 mm offset ring spanner
                    
                      10 mm socket
                    
                      13 mm socket
                    
                      T30 Torx screwdriver
                    
                      19 mm wheel impact socket
                    
                      Ratchet wrench or power tool for removal/installation of threaded fasteners
                    
                      Tommy bar
                    
                      Clip removal tool
                    
                      Long nose pliers
                    
                      Car lift or jack with jack stands, and wheel chocks

Buy tools

Replacement: serpentine belt – VAUXHALL MOVANO Mk I (A) Van (FD). AUTODOC recommends:

All the work should be carried out with the ignition switched off.

Replacement: serpentine belt – VAUXHALL MOVANO Mk I (A) Van (FD). Recommended sequence of steps:

Step 1

Secure the wheels with chocks.
Step 2

Loosen the wheel fasteners. Use a 19 mm wheel impact socket. Use a tommy bar.
Step 3

Raise the vehicle.

Replacement: serpentine belt – VAUXHALL MOVANO Mk I (A) Van (FD). Tip from AUTODOC:
If you are using a jack, make sure the car is parked on a hard, flat surface.Make sure to additionally secure the car with jack stands.
Step 4

Unscrew the wheel fasteners.

Caution!
To avoid injury, hold up the wheel when unscrewing the fasteners.
Step 5

Remove the wheel.
Step 6

Unscrew the fasteners of the front part of the wheel arch liner. Use a T30 Torx screwdriver.
Step 7

Remove the clips from the front part of the wheel arch liner. Use a clip removal tool.
Step 8

Remove the front part of the wheel arch liner.
Step 9

Move the belt tensioner pulley away from the V-ribbed belt. Use a 13 mm offset ring spanner.
Step 10

Remove the V-ribbed belt.
Step 11

Unscrew the idler pulley fastener. Use a 13 mm offset ring spanner.
Step 12

Remove the fastening bolt.
Step 13

Remove the idler pulley.
Step 14

Clean the tensioner fasteners. Use a wire brush. Use WD-40 spray.
Step 15

Unscrew the tensioner fasteners. Use a 10 mm socket. Use a ratchet wrench.
Step 16

Remove the fastening bolts.
Step 17

Remove the tensioner.
Step 18

Clean the tensioner mounting seats. Use a wire brush. Use an all-purpose cleaning spray.
Step 19

Install a new tensioner.
Step 20

Install the fastening bolts.
Step 21

Tighten the tensioner fasteners. Use a 10 mm socket. Use a torque wrench. Tightening torque: 21 N·m.
Step 22

Install a new idler pulley.
Step 23

Install the fastening bolt.
Step 24

Tighten the idler pulley fastener. Use a 13 mm socket. Use a torque wrench. Tightening torque: 30 N·m.
Step 25

Install a new V-ribbed belt.

Replacement: serpentine belt – VAUXHALL MOVANO Mk I (A) Van (FD). Professionals recommend:
Make sure that the belt fits snugly around all pulleys.
Step 26

Tension the V-ribbed belt by removing the locking pin from the new tensioner. Use a 13 mm offset ring spanner. Use long nose pliers.
Step 27

Run the engine for a few minutes. This is necessary to ensure that the component works properly.
Step 28

Switch off the engine.

Step 29

Reinstall the front part of the wheel arch liner.
Step 30

Install the clips of the front part of the wheel arch liner.
Step 31

Tighten the fasteners of the front part of the wheel arch liner. Use a T30 Torx screwdriver.
Step 32

Clean the wheel rim mounting seat. Use a wire brush. Use an all-purpose cleaning spray.
Step 33

Treat the brake disc surface that contacts the wheel rim. Use ceramic grease.
Step 34

Install the wheel.

Replacement: serpentine belt – VAUXHALL MOVANO Mk I (A) Van (FD). AUTODOC experts recommend:
To avoid injury, hold up the wheel when screwing in the fasteners.
Step 35

Screw in the wheel fasteners. Use a 19 mm wheel impact socket. Use a ratchet wrench.
Step 36

Lower the car and tighten the wheel fasteners in a criss-cross pattern. Use a 19 mm wheel impact socket. Use a torque wrench. Tightening torque: 142 N·m.
Step 37

Remove the jack and wheel chocks.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

Need New Tyres?

Find out which tyre and wheel sizes are compatible with the VAUXHALL Movano Mk1 (A) Van (X70) model

VAUXHALL MOVANO Mk I (A) Van (FD) tyre size

How to change crankshaft position sensor on VAUXHALL Movano Mk1 (A) Van (X70) – replacement guide

Free download PDF 901.12 KB
How to change engine thermostat on VAUXHALL Movano Mk1 (A) Van (X70) – replacement guide

Free download PDF 4.51 MB
How to change engine oil and filter on VAUXHALL Movano Mk1 (A) Van (X70) – replacement guide

Free download PDF 1.6 MB
How to change headlight bulb on VAUXHALL Movano Mk I (A) Van (X70) – replacement guide

Free download PDF 1.31 MB
How to change fuel filter on VAUXHALL Movano Mk1 (A) Van (X70) – replacement guide

Free download PDF 1.31 MB
How to change fog lights on VAUXHALL Movano Mk1 (A) Van (X70) – replacement guide

Free download PDF 1.24 MB

How to change serpentine belt on VAUXHALL Movano Mk1 (A) Combi (X70) – replacement guide

Free download PDF 2.03 MB
How to change serpentine belt on VAUXHALL Movano Mk1 (A) Platform / Chassis (X70) – replacement guide

Free download PDF 2.04 MB
How to change serpentine belt on a car – replacement tutorial

Universal

Free download PDF 1.51 MB
How to change serpentine belt on VAUXHALL Astra Mk IV (G) Convertible (T98) – replacement guide

Free download PDF 686.08 KB
How to change serpentine belt on VAUXHALL Astra Mk IV (G) Coupe (T98) – replacement guide

Free download PDF 686.08 KB
How to change serpentine belt on VAUXHALL Meriva Mk II (B) (S10) – replacement guide

Free download PDF 1.43 MB

Unlock your car maintenance assistant!

Track expenses, manage logs, schedule replacements, and more.

WD-40 for cars: 5 tricks that actually work

55K views

Published on: 14/05/2026
#DIY Wheel Rim Restoration: Revive Scratches and Chips Easily!

7K views

Published on: 18/07/2024
2 ways to clean the EGR valve – which one is better?

182K views

Published on: 04/09/2025
How to Swap an M50 Engine in a BMW E30 Turbo | AUTODOC Project

2K views

Published on: 15/02/2021