Disclaimer
How to change rocker cover gasket on BMW 5 Touring (E34) – replacement guide
downloads:
2
Views:
56
Important!
This replacement procedure can be used for:
BMW 5 Touring (E34) 520i … View more
The steps may slightly vary depending on the car design.
BMW 5 Touring (E34) 520i … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Rocker Cover Gasket for 5 Touring (E34) and other BMW models
Alternative products

All-purpose cleaning spray
Electronic spray
Sealant
Torque wrench
Drive socket # 8
Drive socket # 10
Ratchet wrench
Seal scraper
Flat screwdriver
Crow bar
Fender cover
Replacement: rocker cover gasket – BMW 5 Touring (E34). AUTODOC experts recommend:
- Replace the gasket every time the valve cover is removed.
- All work should be done with the engine stopped.
Replacement: rocker cover gasket – BMW 5 Touring (E34). Use the following procedure:
- Step 1Open the hood.Step 2Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.Step 3
Unscrew the engine cover fastener. Use a drive socket #10. Use a ratchet wrench. - Step 4
Remove the engine cover.AUTODOC recommends:Replacement: rocker cover gasket – BMW 5 Touring (E34). Do not use excessive force when removing the part as this may damage it. - Step 5
Unscrew the engine cover fastener. Use a drive socket #10. Use a ratchet wrench. Use a flat screwdriver. - Step 6
Unscrew the oil filler plug. - Step 7
Remove the oil filler cap. - Step 8
Remove the engine cover.AUTODOC recommends:Replacement: rocker cover gasket – BMW 5 Touring (E34). To avoid damaging the part when removing it, do not use excessive force. - Step 9
Install the oil filler cap. - Step 10
Tighten the oil filler cap. - Step 11
Unplug the connectors from the ignition coils. Use a crowbar. - Step 12
Unscrew the fasteners of the ignition coils. Use a drive socket #10. Use a ratchet wrench. - Step 13
Take out the ignition coils from the spark plug wells.Replacement: rocker cover gasket – BMW 5 Touring (E34). Tip from AUTODOC:Remember the sequence of steps for ignition coil demounting. - Step 14
Unscrew the fastener of the chassis (ground) terminal of the ignition coils. Use a drive socket #8. Use a ratchet wrench. - Step 15
Raise a little the wiring of the ignition coils and move it aside. Use a flat screwdriver. - Step 16
Clean dirt, dust and debris from inside the spark plug wells. - Step 17
Remove the crankcase ventilation hose. - Step 18
Unscrew the fastener of the chassis (ground) terminal of the ignition coils. Use a drive socket #8. Use a ratchet wrench. - Step 19
Unscrew the engine valve cover fasteners. Use a drive socket #10. Use a ratchet wrench. - Step 20
Remove the engine valve cover.AUTODOC recommends:Replacement: rocker cover gasket – BMW 5 Touring (E34). Do not use excessive force when removing the part as this may damage it.Be careful to prevent dust and dirt getting into the engine. - Step 21
Remove the valve cover gasket. Use a seal scraper. - Step 22
Clean the engine valve cover mounting seat. Use a seal scraper. Use all-purpose cleaning spray.Replacement: rocker cover gasket – BMW 5 Touring (E34). Tip:Be careful to prevent dust and dirt getting into the engine. - Step 23
Install the engine valve cover gasket. - Step 24
Treat the engine valve cover mounting seat. Use a sealant. - Step 25
Install the engine valve cover.AUTODOC recommends:Replacement: rocker cover gasket – BMW 5 Touring (E34). To avoid damaging the part during installation, do not use excessive force. - Step 26
Clean the valve cover fasteners. Use all-purpose cleaning spray. - Step 27
Tighten the engine valve cover fasteners. Use a drive socket #10. Use a torque wrench. Tighten it to 15 Nm torque.Replacement: rocker cover gasket – BMW 5 Touring (E34). AUTODOC experts recommend:Tighten the fasteners in the order shown in the diagram in the manufacturer's instructions. - Step 28
Tighten the chassis (ground) terminal of the ignition coils. Use a drive socket #8. Use a ratchet wrench.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the BMW 5 Touring (E34) model
Popular maintenance tutorials for BMW E34 Touring
Complete guides for changing the Rocker gasket on different BMW 5 SERIES models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your BMW 5 Touring (E34)
View more
Revitalize Your Car Interior: DIY Steering Wheel Cover with AUTODOC Tips
3 essential tips for choosing summer tyres | Get ready for warmer weather
#DIY guide: Changing your car's color with a spray can | AUTODOC tips
What to do if your check engine light is on | AUTODOC tips
Most commonly replaced car parts on BMW 5 SERIES
Time to replace parts? Get even better deals in our Shop app.

SCAN ME






























