When to replace the Brake Pads on your BMW 5 SERIES
Recommended replacement interval for the part category Brake pad set : 30000 km
Important!
This replacement procedure can be used for:
BMW 5 Touring (E34) 520i, BMW 5 Touring (E34) 525i, BMW 5 Touring (E34) 525ix, BMW 5 Touring (E34) 525tds, BMW 5 Touring (E34) 530i, BMW 5 Touring (E34) 540i, BMW 5 Touring (E34) 518g, BMW 5 Touring (E34) 525td, BMW 5 Touring (E34) 518i, BMW 5 Touring (E34) 518i View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Brake Pads for 5 Touring (E34) and other BMW models
Alternative products
How to change Brake pad set on BMW E34 Touring 525tds – step-by-step instructions for straightforward car repair Brake pad set
Tools
Replacement: brake pads – BMW 5 Touring (E34). Tools you'll need:
Wire brush
WD-40 spray
Brake cleaner
Copper grease
Anti-squeal paste
HEX bit No.H7.
Wheel impact socket #17
Ratchet wrench
Torque wrench
Brake caliper wind back tool
Crow bar
Wheel chock
Replacement: brake pads – BMW 5 Touring (E34). AUTODOC recommends:
  • Perform the replacement of brake pads in complete set for each axis. This provides effective braking.
  • The replacement procedure is identical for all brake pads on the same axle.
  • All work should be done with the engine stopped.
Replacement: brake pads – BMW 5 Touring (E34). Take the following steps:
  1. Step 1
    Open the bonnet. Unscrew the brake fluid reservoir cap.
    Step 2
    How to change Brake Pads on BMW E34 Touring 1991 - free PDF and video manuals
    Secure the wheels with chocks.
  2. Step 3
    How to replace BMW 5 Touring (E34) 525tds 1992 Brake Pads - step-by-step manuals and video guides
    Loosen the wheel mounting bolts. Use wheel impact socket #17.
  3. Step 4
    Raise the rear of the car and secure on supports.
    Step 5
    BMW E34 Touring 525i 1993 Brake Pads replacement: free workshop manuals
    Unscrew the wheel bolts.
    AUTODOC recommends:
    Important! Hold the wheel while unscrewing the fastening bolts. BMW 5 Touring (E34)
  4. Step 6
    Changing Brake Pads on BMW 5 Touring (E34) 540i 1994 by yourself
    Remove the wheel.
  5. Step 7
    How to remove BMW 5 SERIES 530i 1995 Brake Pads - online easy-to-follow instructions
    Spread the brake pads. Use a crowbar.
  6. Step 8
    How to replace Brake Pads on BMW 5 Touring (E34) 1996: download PDF manuals and video instructions
    Remove the dust boot caps of the brake caliper guide pins. Use a crowbar.
  7. Step 9
    How hard is it to do yourself: Brake Pads replacement on BMW E34 Touring 518i 1997 - download illustrated guide
    Unscrew the brake caliper fastening. Use HEX No.H7. Use a ratchet wrench.
  8. Step 10
    Need to know how to renew Brake Pads on BMW 5 SERIES 1991? This free workshop manual will help you to do it yourself
    Detach the brake caliper retaining spring. Use a crowbar.
  9. Step 11
    Changing of Brake Pads on BMW E34 Touring 1992 won't be an issue if you follow this illustrated step-by-step guide
    Remove the brake caliper.
    Replacement: brake pads – BMW 5 Touring (E34). Professionals recommend:
    Tie the caliper to the suspension or to the body with a wire without disconnecting from the brake hose to prevent depressurization of the brake system.Make sure that the brake caliper is not hanging on the brake hose.Don't press the brake pedal after the brake caliper has been removed. As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur.
  10. Step 12
    BMW 5 SERIES M5 Brake Pads replacement: online guides and video tutorials
    Remove the brake pads. Use a crowbar.
  11. Step 13
    Replacing Brake Pads on BMW E34 Touring 1994 525tds by yourself
    Disconnect the brake pads wear sensor. Use a crowbar.
    Please note!
    Some cars are not equipped with the brake pad wear sensor.
  12. Step 14
    5 Touring (E34) 530i 1995 Brake Pads DIY replacement workshop manual
    Treat the brake caliper piston. Use a brake cleaner.
    AUTODOC recommends:
    Replacement: brake pads – BMW 5 Touring (E34). After applying the spray, wait a few minutes.
  13. Step 15
    How to change Brake Pads on BMW 5 Touring (E34) 1996 - tips and tricks
    Press in the brake caliper piston. Use brake caliper wind back tool.
  14. Step 16
    Step-by-step recommendations for DIY replacement BMW E34 Touring 1997 530i Brake Pads
    Treat the back side of the new brake pads. Use anti-squeal paste.
    AUTODOC recommends:
    Make sure the disc surface is clean before installing the pads.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?

Find out which tyre and wheel sizes are compatible with the BMW 5 Touring (E34) model

Unlock your car maintenance assistant!

Track expenses, manage logs, schedule replacements, and more.

DIY BMW 5 Touring (E34) Brake Pads replacement - online guide
Tips & tricks for your BMW 5 Touring (E34)
View more
  • How to change Brake pad set on BMW 5 Touring (E34) 520i - replacement tricks
    Top 5 mistakes when replacing spark plugs | AUTODOC tips
  • Changing Disc pads BMW E34 Touring 525tds - Replacement Tips
    Prevent Breakdowns: Key Car Checks After Winter | AUTODOC Guide
  • Maintenance Hacks - BMW 5 Touring (E34) 525i Brake pad kit replacement guide
    How to choose the right engine oil for your car | AUTODOC
  • Replace Disc brake pads on BMW E34 Touring - free video tips
    Easy Steps to Fix Minor Scratches on Your Vehicle | AUTODOC tips
Autodoc CLUB App icon
Time to replace parts? Get even better deals in our Shop app.
BMW 5 Touring (E34) Brake Pads replace by yourself - Scan QR-code and download AUTODOC CLUB app
SCAN ME