Disclaimer
How to change rear shock absorbers on SEAT AROSA (6H) – replacement guide
downloads:
1
Views:
22
Important!
This replacement procedure can be used for:
SEAT AROSA (6H) 1.0, SEAT AROSA (6H) 1.4, SEAT AROSA (6H) 1.7 SDI, SEAT AROSA (6H) 1.4 16V, SEAT AROSA (6H) 1.4 TDI, SEAT AROSA (6H) 1.0 … View more
The steps may slightly vary depending on the car design.
SEAT AROSA (6H) 1.0, SEAT AROSA (6H) 1.4, SEAT AROSA (6H) 1.7 SDI, SEAT AROSA (6H) 1.4 16V, SEAT AROSA (6H) 1.4 TDI, SEAT AROSA (6H) 1.0 … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Shock Absorber for AROSA (6H) and other SEAT models
Alternative products

Wire brush
WD-40 spray
Copper grease
Torque wrench
Combination spanner #16
Drive socket # 16
Drive socket # 17
Torx bit T25
Shock absorber socket #DD6
Wheel impact socket #17
Ratchet wrench
Hydraulic transmission jack
Wheel chock
Replacement: shock absorbers – SEAT AROSA (6H). AUTODOC experts recommend:
- Both shock absorbers of the rear suspension should be replaced simultaneously.
- The replacement procedure is identical for the left and right shock absorbers of the rear suspension.
- Please note: all work on the car – SEAT AROSA (6H) – should be done with the engine switched off.
Carry out replacement in the following order:
- Step 1Open the boot lid.Step 2
Detach the parcel shelf. - Step 3
Remove the rubber strip. - Step 4
Unscrew the fasteners of the boot sill panel. - Step 5
Detach the boot sill panel. - Step 6
Unscrew the fasteners of the boot side panel. Use Torx T25. - Step 7
Fold down the backrests of the rear seats. - Step 8
Detach the boot side lining. - Step 9
Remove the protective cap of the shock absorber mount. - Step 10
Clean the shock absorber fasteners. Use a wire brush. Use WD-40 spray. - Step 11
Loosen the upper fastener of the shock absorber. Use a drive socket #17. Use a shock absorber socket DD№6 Use a ratchet wrench.Replacement: shock absorbers – SEAT AROSA (6H). Professionals recommend:Do not completely unscrew the upper fasteners as they may hold also other suspension components. - Step 12Secure the wheels with chocks.Step 13
Loosen the wheel mounting bolts. Use wheel impact socket #17. - Step 14Raise the car.Replacement: shock absorbers – SEAT AROSA (6H). AUTODOC recommends:If you are using a jack, make sure it rests on a flat surface without any unevenness.Be sure to additionally secure the car with jack stands.Step 15
Unscrew the wheel bolts.AUTODOC recommends:Warning! To avoid injury, hold the wheel while unscrewing the fastening bolts. SEAT AROSA (6H) - Step 16
Remove the wheel. - Step 17
Support the rear suspension beam. Use a hydraulic transmission jack. - Step 18
Clean the shock absorber fasteners. Use a wire brush. Use WD-40 spray. - Step 19
Unscrew the lower fastener of the shock absorber. Use a combination spanner #16. Use a drive socket #16. Use a ratchet wrench.AUTODOC recommends:Important! Hold the shock absorber while unscrewing the fastening bolts. SEAT AROSA (6H) - Step 20
Unscrew the upper fastener of the shock absorber.AUTODOC recommends:SEAT AROSA (6H) – To avoid injury, hold the shock absorber while unscrewing the fastening bolts. - Step 21
Remove the shock absorber upper mount. - Step 22
Remove the fastening bolt. - Step 23
Remove the shock absorber. - Step 24
Remove the shock absorber dust cap and the bump stop.AUTODOC recommends:Replacement: shock absorbers – SEAT AROSA (6H). Carefully inspect the mount, the boot, and the bump stop of the shock absorber. Replace if necessary.Before installing a new shock absorber you should pump it manually 3-5 times. - Step 25
Install the dust sleeve and the bump stop on the new shock absorber. - Step 26
Clean the shock absorber mounting seats. Use a wire brush. Use WD-40 spray. - Step 27
Place the shock absorber in the wheel arch and fasten it. - Step 28
Install the fastening bolt. - Step 29Screw in the lower fastener of the shock absorber. Use a combination spanner #16. Use a drive socket #16. Use a ratchet wrench.AUTODOC recommends:SEAT AROSA (6H) – To avoid injury, hold the shock absorber while screwing in the fastening bolts.Step 30
Install the shock absorber upper mount.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the SEAT Arosa (6H) model
Popular maintenance tutorials for Seat Arosa 6h
Complete guides for changing the Shock absorbers on different SEAT AROSA models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your SEAT AROSA (6H)
View more
DIY jack restoration | AUTODOC tips
Understanding Airbag Light Warnings | Essential Tips for Car Safety
K2 ROTON wheel cleaner overview
Easy Steps to Paint Brake Calipers Without Special Skills or High Costs
Most commonly replaced car parts on SEAT AROSA
Time to replace parts? Get even better deals in our Shop app.

SCAN ME



































