Disclaimer
How to change rear engine mounts on SKODA Fabia II Combi (545) – replacement guide
downloads:
1
Views:
25
Important!
This replacement procedure can be used for:
SKODA Fabia II Combi (545) 1.2 LPG, SKODA Fabia II Combi (545) 1.2 LPG, SKODA Fabia II Combi (545) 1.2, SKODA Fabia II Combi (545) 1.2, SKODA Fabia II Combi (545) 1.2 12V … View more
The steps may slightly vary depending on the car design.
SKODA Fabia II Combi (545) 1.2 LPG, SKODA Fabia II Combi (545) 1.2 LPG, SKODA Fabia II Combi (545) 1.2, SKODA Fabia II Combi (545) 1.2, SKODA Fabia II Combi (545) 1.2 12V … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Engine Mount for Fabia II Combi (545) and other SKODA models
Alternative products

Wire brush
WD-40 spray
Copper grease
Drive socket # 12
Drive socket # 16
Ratchet wrench
Torque wrench
Phillips screwdriver
Fender cover
Replacement: engine mounts – SKODA FABIA Combi. AUTODOC recommends:
- All work should be done with the engine stopped.
Replacement: engine mounts – SKODA FABIA Combi. Use the following procedure:
- Step 1Open the bonnet.Step 2Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.Step 3Lift the car using a jack or place it over an inspection pit.Replacement: engine mounts – SKODA FABIA Combi. Tip:The vehicle must be on even keel, and if it is at an angle, the drain plug must be at the lowest point.Step 4
Unscrew the fasteners of the lower sound insulation. Use a drive socket #12. Use a Phillips screwdriver. - Step 5
Remove the lower sound insulation. - Step 6
Clean the engine mount fasteners. Use a wire brush. Use WD-40 spray. - Step 7
Unscrew the fastener connecting the engine mount to the gearbox housing. Use a drive socket #16. Use a ratchet wrench. - Step 8
Unscrew the engine mount fastener that connects it to the subframe. Use a drive socket #16. Use a ratchet wrench. - Step 9
Remove the engine mount.Replacement: engine mounts – SKODA FABIA Combi. AUTODOC experts recommend:Carefully check the other engine mounts and replace them if necessary. - Step 10
Install the engine mount to its mounting seat. - Step 11
Screw in the engine mount fastener that connects it to the subframe. Use a drive socket #16.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the SKODA Fabia II Combi (545) model
Popular maintenance tutorials for SKODA FABIA Combi
Complete guides for changing the Engine mounts on different SKODA FABIA models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your SKODA Fabia II Combi (545)
View more
Don’t Replace, Just Polish! Headlight Restoration with AUTODOC
Top 5 Car Interior Cleaning Mistakes You Should Avoid | AUTODOC Tips
How to Make a DIY Foam Sprayer | AUTODOC tips
DIY vehicle AC compressor restoration
Most commonly replaced car parts on SKODA FABIA
Time to replace parts? Get even better deals in our Shop app.

SCAN ME























