Disclaimer
How to change rear coil springs on SEAT Leon Hatchback (1M1) – replacement guide
downloads:
11
Views:
497
Important!
This replacement procedure can be used for:
SEAT Leon Hatchback (1M1) 1.6, SEAT Leon Hatchback (1M1) 1.8 20V, SEAT Leon Hatchback (1M1) 1.9 TDI, SEAT Leon Hatchback (1M1) 1.9 TDI, SEAT Leon Hatchback (1M1) 1.4 16V, SEAT Leon Hatchback (1M1) 1.8 20V T, SEAT Leon Hatchback (1M1) 1.9 SDI, SEAT Leon Hatchback (1M1) 1.8 20V T 4, SEAT Leon Hatchback (1M1) 1.6 16 V, SEAT Leon Hatchback (1M1) 2.8 Cupra 4, SEAT Leon Hatchback (1M1) 1.9 TDI, SEAT Leon Hatchback (1M1) 1.8 T Cupra R, SEAT Leon Hatchback (1M1) 1.8 T Cupra R, SEAT Leon Hatchback (1M1) 1.9 TDI Syncro, SEAT Leon Hatchback (1M1) 1.9 TDI, SEAT Leon Hatchback (1M1) 1.9 TDI, SEAT Leon Hatchback (1M1) 2.8, SEAT Leon Hatchback (1M1) 1.6 … View more
The steps may slightly vary depending on the car design.
SEAT Leon Hatchback (1M1) 1.6, SEAT Leon Hatchback (1M1) 1.8 20V, SEAT Leon Hatchback (1M1) 1.9 TDI, SEAT Leon Hatchback (1M1) 1.9 TDI, SEAT Leon Hatchback (1M1) 1.4 16V, SEAT Leon Hatchback (1M1) 1.8 20V T, SEAT Leon Hatchback (1M1) 1.9 SDI, SEAT Leon Hatchback (1M1) 1.8 20V T 4, SEAT Leon Hatchback (1M1) 1.6 16 V, SEAT Leon Hatchback (1M1) 2.8 Cupra 4, SEAT Leon Hatchback (1M1) 1.9 TDI, SEAT Leon Hatchback (1M1) 1.8 T Cupra R, SEAT Leon Hatchback (1M1) 1.8 T Cupra R, SEAT Leon Hatchback (1M1) 1.9 TDI Syncro, SEAT Leon Hatchback (1M1) 1.9 TDI, SEAT Leon Hatchback (1M1) 1.9 TDI, SEAT Leon Hatchback (1M1) 2.8, SEAT Leon Hatchback (1M1) 1.6 … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Springs for Leon Hatchback (1M1) and other SEAT models
Alternative products

Wire brush
WD-40 spray
Copper grease
Combination spanner #16
Drive socket # 16
Wheel impact socket #17
Ratchet wrench
Torque wrench
Tap wrench
Crow bar
Hydraulic transmission jack
Wheel chock
Replacement: coil springs – SEAT LEON (1M1). Tip from AUTODOC experts:
- Both coil springs of the rear suspension should be replaced simultaneously.
- The replacement procedure is identical for the left and right coil springs of the rear suspension.
- All work should be done with the engine stopped.
Replacement: coil springs – SEAT LEON (1M1). Take the following steps:
- Step 1
Secure the wheels with chocks. - Step 2
Loosen the wheel mounting bolts. Use wheel impact socket #17. - Step 3Raise the rear of the car and secure on supports.Step 4
Unscrew the wheel bolts.Replacement: coil springs – SEAT LEON (1M1). Tip:To avoid injury, hold up the wheel when unscrewing the bolts. - Step 5
Remove the wheel. - Step 6
Disconnect the ABS sensor wiring. Use a crowbar. - Step 7
Clean the shock absorber fasteners. Use a wire brush. Use WD-40 spray. - Step 8
Unscrew the lower fastener of the shock absorber. Use a combination spanner #16. Use a drive socket #16. Use a tap wrench. - Step 9
Support the rear suspension beam. Use a hydraulic transmission jack. - Step 10
Remove the fastening bolt. Use a combination spanner #16. Use a drive socket #16. Use a ratchet wrench. - Step 11
Remove the mounting from under the rear axle beam.AUTODOC recommends:Replacement: coil springs – SEAT LEON (1M1). Lower the transmission jack smoothly, without jerks, to avoid damaging components and mechanisms. - Step 12Support the rear suspension beam. Use a hydraulic transmission jack.Step 13Unscrew the lower fastener of the shock absorber. Use a combination spanner #16. Use a drive socket #16. Use a tap wrench.Step 14
Remove the fastening bolt. Use a combination spanner #16. Use a drive socket #16. Use a ratchet wrench. - Step 15
Remove the mounting from under the rear axle beam.AUTODOC recommends:SEAT LEON (1M1) – Do not lower the transmission jack sharply to avoid damaging components and mechanisms of the car. - Step 16
Take out the spring.Replacement: coil springs – SEAT LEON (1M1). AUTODOC recommends:Inspect the rubber mounts of the suspension spring. Replace if necessary. - Step 17
Remove the rubber spring spacer. - Step 18
Clean the coil spring mounting seats. Use a wire brush. Use WD-40 spray. - Step 19
Install the rubber spacer on the new coil spring. - Step 20
Install the coil spring together with the rubber mounts into the mounting seats. - Step 21Support the rear suspension beam. Use a hydraulic transmission jack.Step 22
Install the fastening bolt. - Step 23
Screw in the lower fastener of the shock absorber. Use a combination spanner #16. Use a drive socket #16. Use a ratchet wrench.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 1
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the SEAT Leon I Hatchback (1M1) model
Popular maintenance tutorials for Seat Leon 1m1
Complete guides for changing the Springs on different SEAT LEON models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your SEAT Leon Hatchback (1M1)
View more
How to Fix P0401 ✅ error code Insufficient EGR flow
#DIY guide: Changing your car's color with a spray can | AUTODOC tips
Easy Steps to Paint Brake Calipers Without Special Skills or High Costs
How to Fix a Squealing Belt: Causes & Solutions | AUTODOC Expert Tips
Most commonly replaced car parts on SEAT LEON
Time to replace parts? Get even better deals in our Shop app.

SCAN ME

































