
Disclaimer
How to change rear brake shoes on OPEL COMBO (71_) – replacement guide
downloads:
3
Views:
21

Recommended replacement interval for the part category Brake Shoe Set : 100000 km
Important!
This replacement procedure can be used for:
OPEL COMBO (71_) 1.4 16V … View more
The steps may slightly vary depending on the car design.
OPEL COMBO (71_) 1.4 16V … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Brake Shoes for COMBO (71_) and other OPEL models
Brake Shoe Set
Alternative products

Wire brush
All-purpose cleaning spray
Copper grease
Drive socket # 27
Wheel impact socket #17
Torque wrench
Tap wrench
Hammer
Round-nose pliers
Pliers
Flat screwdriver
Wheel chock
Replacement: brake shoes – OPEL COMBO (71_). AUTODOC experts recommend:
- Perform the replacement of brake pads in complete set for each axis. This provides effective braking.
- The replacement procedure is identical for all brake pads on the same axle.
- Please note: all work on the car – OPEL COMBO (71_) – should be done with the engine switched off.
Carry out replacement in the following order:
- Step 1Open the bonnet. Unscrew the brake fluid reservoir cap.Step 2Secure the wheels with chocks.Step 3Loosen the wheel mounting bolts. Use wheel impact socket #17.Step 4Raise the rear of the car and secure on supports.Step 5Unscrew the wheel bolts.AUTODOC recommends:Warning! To avoid injury, hold the wheel while unscrewing the fastening bolts. OPEL COMBO (71_)
- Step 6Remove the wheel.
- Step 7Fully lower the parking brake lever.Step 8Clean the brake drum. Use a wire brush. Use all-purpose cleaning spray.Step 9Remove the hub bearing protection cap. Use a flat screwdriver. Use a hammer.Replacement: brake shoes – OPEL COMBO (71_). Tip:Some cars are not equipped with wheel hub caps.
- Step 10Unscrew the wheel hub axle nut. Use a drive socket #27. Use a tap wrench.
- Step 11Remove the brake drum assembled with the wheel hub bearing.
- Step 12Disconnect the parking brake cable from the parking brake lever. Use round-nose pliers. Use a flat screwdriver.
- Step 13Take out brake pad retainer springs from the holes. Use pliers.
- Step 14Remove the brake pads retaining clips. Use pliers. Use round-nose pliers.
- Step 15Remove the brake pads.Replacement: brake shoes – OPEL COMBO (71_). AUTODOC experts recommend:Don't press the brake pedal after removing the rear brake drum shoes. This will cause the piston to fall out of the brake cylinder, leakage of brake fluid and depressurization of the system. Examine the brake drum. Replace it if necessary.
- Step 16Remove the brake shoe adjuster. Use round-nose pliers.
- Step 17Insert the brake shoes adjusting mechanism. Use round-nose pliers.
- Step 18Install new brake pads.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the OPEL Combo B Van model
Popular maintenance tutorials for Opel Combo B
Complete guides for changing the Brake shoe set on different OPEL COMBO models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your OPEL COMBO (71_)
View more
- The most common problems when buying a used car | AUTODOC
- #DIY Guide: How to Fix a Cracked Windscreen Without a Garage Visit
- What to do if the ABS light comes on: DIY Diagnostics Tips
- Transform Your Engine Bay: Affordable Valve Cover Restoration with AUTODOC
Most commonly replaced car parts on OPEL COMBO
Time to replace parts? Get even better deals in our Shop app.

SCAN ME