Recommended replacement interval for the part category Oil filter : 12 month / 15000 km

Important!

This replacement procedure can be used for:
BMW 5 Touring (E34) 518i, BMW 5 Touring (E34) 518g … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

Alternative products

Oil filter

Replacement: engine oil and filter – BMW 5 Touring (E34). Tools you need:

                      All-purpose cleaning spray
                    
                      Drive socket # 17 
                    
                      Oil filter cup socket 86/16 F
                    
                      Ratchet wrench
                    
                      Torque wrench
                    
                      Flat Screwdriver
                    
                      Phillips screwdriver
                    
                      Oil drain pan
                    
                      Funnel
                    
                      Fender cover

Buy tools

Replacement: engine oil and filter – BMW 5 Touring (E34). AUTODOC experts recommend:

Replace the oil filter every time when changing motor oil.
Wear gloves to prevent contact with hot liquid.
Please note: all work on the car – BMW 5 Touring (E34) – should be done with the engine switched off.

Carry out replacement in the following order:

Step 1

Lift the car using a jack or place it over an inspection pit.

Replacement: engine oil and filter – BMW 5 Touring (E34). Tip:
The vehicle must be on even keel, and if it is at an angle, the drain plug must be at the lowest point.
Step 2

Undo the fasteners of the oil pan lower cover. Use a Phillips screwdriver.
Step 3

Remove the oil pan cover.

Step 4

Put a waste oil container with at least 5 l capacity under the drainage hole.

Step 5

Clean the area of the oil pan drainage hole. Use all-purpose cleaning spray.
Step 6

Unscrew the drain plug. Use a drive socket #17. Use a ratchet wrench.
Step 7

Drain the used oil.

Replacement: engine oil and filter – BMW 5 Touring (E34). Tip from AUTODOC:
Caution! The oil may be hot.Wait until the oil has completely drained from the drainage hole.
Step 8

Clean the area of the oil pan drainage hole.

Step 9

Screw in the new drainage plug and tighten it. Use a drive socket #17. Use a torque wrench. Tighten it to 27 Nm torque.
Step 10

Clean the area of the oil pan drainage hole. Use all-purpose cleaning spray.

Step 11

Reinstall the oil pan lower cover.
Step 12

Tighten the fasteners of the oil pan lower cover. Use a Phillips screwdriver.
Step 13

Lower the car.

Step 14

Open the hood.

Step 15

Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.

Step 16

Unscrew the oil filler plug.
Step 17

Unscrew the oil filter. Use the 86/16 F socket. Use a ratchet wrench.
Step 18

Put the old oil filter in the container.
Step 19

Remove the filter element from the filter housing.
Step 20

Remove old o-rings from the oil filter cover. Use a flat screwdriver.
Step 21

Clean the oil filter housing cap. Use all-purpose cleaning spray.

Step 22

Install new O-rings and a new oil filter to their mounting seats on the filter cover. Use a flat screwdriver.

Please note!
Make sure to install the filter correctly. Don't mix up the sides of the part.
Step 23

Clean the oil filter seat.

Step 24

Lubricate the rubber seal of the new filter with a little amount of fresh oil.
Step 25

Screw the new filter into its place. Use the 86/16 F socket. Use a torque wrench. Tighten it to 23 Nm torque.
Step 26

Remove the oil filler cap.
Step 27

Insert the funnel.

Step 28

Pour new oil into the engine in the amount recommended by the car manufacturer.

Replacement: engine oil and filter – BMW 5 Touring (E34). Professionals recommend:
Use the oil recommended by the manufacturer.
Step 29

Check the oil level using the dipstick. Top up oil if necessary.

Please note!
The oil level should be between the Min and Max marks.
Step 30

Install the oil filler cap.
Step 31

Tighten the oil filler cap.

Step 32

Run the engine for a few minutes. After the oil pressure warning light goes out, stop the engine.

Step 33

Check the oil level 5 minutes after the stop of the engine operation using a dipstick and add oil if necessary.

Please note!
The oil level should be between the Min and Max marks.Make sure that the oil filler cap is properly tightened.Check the threaded plug of the drainage hole and the oil filter seal for tightness. If necessary, carefully tighten them up.
Step 34

Remove the fender protection cover. Close the hood.

Replacement: engine oil and filter – BMW 5 Touring (E34). AUTODOC experts recommend:
Note that oil pressure warning light, which indicates insufficient pressure in the lubrication system, may be on for a longer time than usual. After a few seconds, the oil will fill all the channels, and the light will go out. To protect the environment from pollution, be sure to dispose of the used filters at special collection points.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

Need New Tyres?

Find out which tyre and wheel sizes are compatible with the BMW 5 Touring (E34) model

BMW E34 Touring tyre size

How to change fuel filter on BMW 5 Touring (E34) – replacement guide

Free download PDF
2.13 MB
How to change rear brake pads on BMW 5 Touring (E34) – replacement guide

Free download PDF
1.86 MB
How to change front wheel bearing on BMW 5 Touring (E34) – replacement guide

Free download PDF
2.07 MB
How to change serpentine belt on BMW 5 Touring (E34) – replacement guide

Free download PDF
870.4 KB
How to change spark plugs on BMW 5 Touring (E34) – replacement guide

Free download PDF
2.58 MB
How to change front windshield wipers on BMW 5 Touring (E34) – replacement guide

Free download PDF
1.44 MB

How to change engine oil and filter on BMW 5 Saloon (F10) – replacement guide

Free download PDF
1.63 MB
How to change engine oil and filter on BMW E39 – replacement guide

Free download PDF
1.96 MB
How to change engine oil and filter on BMW E60 – replacement guide

Free download PDF
2.15 MB
How to change engine oil and filter on BMW 5 Touring (F11) – replacement guide

Free download PDF
1.63 MB
How to change engine oil and filter on BMW 5 Touring (E61) – replacement guide

Free download PDF
2.25 MB
How to change engine oil and filter on BMW 5 GT (F07) – replacement guide

Free download PDF
1.62 MB

Unlock your car maintenance assistant!

Track expenses, manage logs, schedule replacements, and more.

Unveiling the secrets: Detecting vacuum leaks with a Smoke Machine | AUTODOC

19K views

Published on: 23/07/2020
TOP 6 WD-40 lifehacks | AUTODOC tips

13K views

Published on: 15/07/2021
How I started restoring a driveshaft | Drivetrain restoration – Part 1

8K views

Published on: 17/10/2024
5 possible reasons why your car heater isn't working

7K views

Published on: 21/11/2024