How to carry out replacement: Brake Pad Wear Sensor CLK 200 1.8 Kompressor (209.442) Mercedes A209
Disclaimer
Change Mercedes A209 CLK 500 5.0 (209.475) Brake Pad Wear Sensor yourself – manuals and video tutorials

How to change rear brake pad wear sensor on MERCEDES-BENZ CLK Convertible (A209) – replacement guide

downloads: 2
Views: 11
Download your free tutorial and fix MERCEDES-BENZ CLK Convertible (A209) CLK 500 5.5 (209.472) problems yourself Download for free 2.09 MB Brake Pad Wear Sensor for Mercedes A209 Shop now
Leave a comment Open in a new tab
When to replace the Brake Pad Wear Sensor on your MERCEDES-BENZ CLK
Recommended replacement interval for the part category Brake pad wear sensor : 30000 km
Important!
This replacement procedure can be used for:
MERCEDES-BENZ CLK Convertible (A209) CLK 200 Kompressor (209.442), MERCEDES-BENZ CLK Convertible (A209) CLK 200 CGI (209.343), MERCEDES-BENZ CLK Convertible (A209) CLK 240 (209.461), MERCEDES-BENZ CLK Convertible (A209) CLK 320 (209.465), MERCEDES-BENZ CLK Convertible (A209) CLK 500 (209.475), MERCEDES-BENZ CLK Convertible (A209) CLK 55 AMG (209.476), MERCEDES-BENZ CLK Convertible (A209) CLK 350 (209.456), MERCEDES-BENZ CLK Convertible (A209) CLK 280 (209.454), MERCEDES-BENZ CLK Convertible (A209) CLK 63 AMG (209.477), MERCEDES-BENZ CLK Convertible (A209) CLK 320 CDI (209.420), MERCEDES-BENZ CLK Convertible (A209) CLK 200 Kompressor (209.441), MERCEDES-BENZ CLK Convertible (A209) CLK 500 (209.472), MERCEDES-BENZ CLK Convertible (A209) CLK AMG DTM (209.476) … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Brake Pad Wear Sensor for CLK Convertible (A209) and other MERCEDES-BENZ models
Alternative products
How to change Brake pad wear sensor on Mercedes A209 CLK 200 1.8 Kompressor (209.442) – step-by-step instructions for straightforward car repair Brake pad wear sensor
Tools
Replacement: brake pad wear sensor – MERCEDES-BENZ CLK Convertible (A209). Tools you need:
Wire brush
Nylon cleaning brush
WD-40 spray
Electronic spray
Brake cleaner
Anti-squeal paste
Ceramic grease
Torque wrench
Torx bit E10
HEX bit no.H7
Wheel impact socket #17
Ratchet wrench
Long nose pliers
Brake caliper wind back tool
Crow bar
Wheel chock
Buy tools
Replacement: brake pad wear sensor – MERCEDES-BENZ CLK Convertible (A209). AUTODOC recommends:
  • The replacement procedure is identical for both brake pad wear sensors on the same axle.
  • The wear sensors should be replaced together with the brake pads.
  • Please note: all work on the car – MERCEDES-BENZ CLK Convertible (A209) – should be done with the engine switched off.
Carry out replacement in the following order:
  1. Step 1
    Open the bonnet. Unscrew the brake fluid reservoir cap.
    Step 2
    Secure the wheels with chocks.
    Step 3
    How to change Brake Pad Wear Sensor on Mercedes A209 2003 - free PDF and video manuals
    Loosen the wheel mounting bolts. Use wheel impact socket #17.
  2. Step 4
    Raise the car.
    Replacement: brake pad wear sensor – MERCEDES-BENZ CLK Convertible (A209). Tip from AUTODOC:
    If you are using a jack, make sure it rests on a flat surface without any unevenness.Be sure to additionally secure the car with jack stands.
    Step 5
    How to replace MERCEDES-BENZ CLK Convertible (A209) CLK 200 1.8 Kompressor (209.442) 2004 Brake Pad Wear Sensor - step-by-step manuals and video guides
    Unscrew the wheel bolts.
    AUTODOC recommends:
    Warning! To avoid injury, hold the wheel while unscrewing the fastening bolts. MERCEDES-BENZ CLK Convertible (A209)
  3. Step 6
    Mercedes A209 CLK 320 3.2 (209.465) 2005 Brake Pad Wear Sensor replacement: free workshop manuals
    Remove the wheel.
  4. Step 7
    Changing Brake Pad Wear Sensor on MERCEDES-BENZ CLK Convertible (A209) CLK 320 CDI 3.0 (209.420) 2006 by yourself
    Detach the connector of the brake pad wear sensor. Use long nose pliers.
  5. Step 8
    How to remove MERCEDES-BENZ CLK CLK 280 3.0 (209.454) 2007 Brake Pad Wear Sensor - online easy-to-follow instructions
    Clean the fasteners of the brake pad wear sensor wiring harness. Use a wire brush. Use WD-40 spray.
  6. Step 9
    How to replace Brake Pad Wear Sensor on MERCEDES-BENZ CLK Convertible (A209) 2008: download PDF manuals and video instructions
    Unscrew the fasteners of the brake pad wear sensor wiring harness. Use Torx E10. Use a ratchet wrench.
  7. Step 10
    How hard is it to do yourself: Brake Pad Wear Sensor replacement on Mercedes A209 CLK 350 3.5 (209.456) 2009 - download illustrated guide
    Remove the fastening bolt.
  8. Step 11
    Need to know how to renew Brake Pad Wear Sensor on MERCEDES-BENZ CLK 2010? This free workshop manual will help you to do it yourself
    Detach the brake pad wear sensor wiring harness.
  9. Step 12
    Changing of Brake Pad Wear Sensor on Mercedes A209 2003 won't be an issue if you follow this illustrated step-by-step guide
    Detach the brake caliper retaining spring. Use a crowbar.
  10. Step 13
    MERCEDES-BENZ CLK CLK 500 5.0 (209.475) Brake Pad Wear Sensor replacement: online guides and video tutorials
    Remove the dust boot caps of the brake caliper guide pins. Use a crowbar.
  11. Step 14
    Replacing Brake Pad Wear Sensor on Mercedes A209 2005 CLK 200 1.8 Kompressor (209.442) by yourself
    Unscrew the brake caliper fasteners. Use HEX No.H7. Use a ratchet wrench.
  12. Step 15
    CLK Convertible (A209) CLK 280 3.0 (209.454) 2006 Brake Pad Wear Sensor DIY replacement workshop manual
    Spread the brake pads. Use a crowbar.
  13. Step 16
    How to change Brake Pad Wear Sensor on MERCEDES-BENZ CLK Convertible (A209) 2007 - tips and tricks
    Remove the brake caliper.
    Replacement: brake pad wear sensor – MERCEDES-BENZ CLK Convertible (A209). Tip:
    Tie the caliper to the suspension or to the body with a wire without disconnecting from the brake hose to prevent depressurization of the brake system.Make sure that the brake caliper is not hanging on the brake hose.Don't press the brake pedal after the brake caliper has been removed. As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur.
  14. Step 17
    Step-by-step recommendations for DIY replacement Mercedes A209 2008 CLK 280 3.0 (209.454) Brake Pad Wear Sensor
    Remove the brake pads.
  15. Step 18
    DIY replacement of Brake Pad Wear Sensor on MERCEDES-BENZ CLK Convertible (A209) CLK 200 1.8 Kompressor (209.441) 2009 is not an issue anymore with our step-by-step tutorial
    Clean the brake caliper bracket from dirt and dust. Use a wire brush. Use a brake cleaner.
    AUTODOC recommends:
    After applying the spray, wait a few minutes.Check the brake caliper bracket, brake caliper guide pins and boots. Clean them. Replace, if necessary.
  16. Step 19
    How to change Brake Pad Wear Sensor on Mercedes A209 2003 - free PDF and video manuals
    Treat the brake caliper piston. Use a nylon cleaning brush. Use a brake cleaner.
    AUTODOC recommends:
    Replacement: brake pad wear sensor – MERCEDES-BENZ CLK Convertible (A209). After applying the spray, wait a few minutes.Check the brake caliper bracket, brake caliper guide pins and boots. Clean them. Replace, if necessary.
  17. Step 20
    How to replace MERCEDES-BENZ CLK Convertible (A209) CLK 200 1.8 Kompressor (209.442) 2004 Brake Pad Wear Sensor - step-by-step manuals and video guides
    Press in the brake caliper piston. Use brake caliper wind back tool.
  18. Step 21
    Mercedes A209 CLK 320 3.2 (209.465) 2005 Brake Pad Wear Sensor replacement: free workshop manuals
    Attach the new wear sensor to the new pad.
  19. Step 22
    Changing Brake Pad Wear Sensor on MERCEDES-BENZ CLK Convertible (A209) CLK 320 CDI 3.0 (209.420) 2006 by yourself
    Treat the brake pads in the area where their surface comes into contact with the brake caliper bracket. Use anti-squeal paste.
    AUTODOC recommends:
    Make sure the disc surface is clean before installing the pads.
  20. Step 23
    How to remove MERCEDES-BENZ CLK CLK 280 3.0 (209.454) 2007 Brake Pad Wear Sensor - online easy-to-follow instructions
    Install the brake pads.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?

Find out which tyre and wheel sizes are compatible with the MERCEDES-BENZ CLK Convertible (A209) model

Mercedes A209 tyre size

Popular maintenance tutorials for Mercedes A209

More manuals for Mercedes A209

Complete guides for changing the Brake pad wear indicator on different MERCEDES-BENZ CLK models

Unlock your car maintenance assistant!

Track expenses, manage logs, schedule replacements, and more.

DIY MERCEDES-BENZ CLK Convertible (A209) Brake Pad Wear Sensor replacement - online guide
Tips & tricks for your MERCEDES-BENZ CLK Convertible (A209)
View more
  • How to change Brake pad wear indicator on MERCEDES-BENZ CLK Convertible (A209) CLK 200 1.8 Kompressor (209.441) - replacement tricks
    DIY brake caliper restoration | AUTODOC tips
    817K views
    Published on: 02/06/2022
  • Changing Brake pad sensor Mercedes A209 CLK 200 1.8 Kompressor (209.442) - Replacement Tips
    Revive Your Tyres: Expert Tips for a Lasting Shine | AUTODOC Guide
    4K views
    Published on: 07/04/2022
  • Maintenance Hacks - MERCEDES-BENZ CLK Convertible (A209) CLK 320 3.2 (209.465) Brake wear indicator replacement guide
    5 mistakes made when washing the engine | AUTODOC tips
    32K views
    Published on: 22/04/2021
  • Replace Brake wear sensor on Mercedes A209 - free video tips
    #DIY Guide: How to Fix a Cracked Windscreen Without a Garage Visit
    9K views
    Published on: 14/12/2023

Most commonly replaced car parts on MERCEDES-BENZ CLK

Professional manuals for the most common MERCEDES-BENZ models

ОЕ number
Autodoc CLUB App icon
Time to replace parts? Get even better deals in our Shop app.
MERCEDES-BENZ CLK Convertible (A209) Brake Pad Wear Sensor replace by yourself - Scan QR-code and download AUTODOC CLUB app
SCAN ME