Recommended replacement interval for the part category Brake disc : 50000 km

Important!

This replacement procedure can be used for:
SKODA Scala Hatchback 1.0 TSI, SKODA Scala Hatchback 1.5 TSI, SKODA Scala Hatchback 1.6 TDI, SKODA Scala Hatchback 1.0 TSI, SKODA Scala Hatchback 1.0 TGI CNG, SKODA Scala Hatchback 1.0 TSI, SKODA Scala Hatchback 1.6 TDI, SKODA Scala Hatchback 1.6 SRE … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Brake Discs for Scala Hatchback and other SKODA models

Alternative products

Brake disc

GCH20007 goCORE Brake disc

9,01 GBP

Shop

C4W000ABE ABE Brake disc

11,74 GBP

Shop

SKAD-2002 STARK Brake disc

12,66 GBP

Shop

82B0003 RIDEX Brake disc

12,66 GBP

Shop

A1441P LPR Brake disc

12,79 GBP

Shop

BDC4753 QUINTON HAZELL Brake disc

13,33 GBP

Shop

BAR09123 Barum Brake disc

14,06 GBP

Shop

0 986 478 868 BOSCH Brake disc

16,57 GBP

Shop

08.7165.11 BREMBO Brake disc

17,63 GBP

Shop

BR 001 SA100 BRECK Brake disc

19,07 GBP

Shop

Replacement: brake discs – SKODA Scala Schrägheck. Tools you'll need:

                      Wire brush
                    
                      Nylon cleaning brush
                    
                      WD-40 spray
                    
                      Brake cleaner
                    
                      Anti-squeal paste
                    
                      Ceramic grease
                    
                      Torque wrench
                    
                      Drive socket # 13
                    
                      Combination spanner #13
                    
                      Combination spanner #15
                    
                      HEX bit No.H8
                    
                      Wheel impact socket #17
                    
                      Ratchet wrench
                    
                      Brake caliper wind back tool
                    
                      Crow bar
                    
                      Tap wrench
                    
                      Impact screwdriver
                    
                      Hammer
                    
                      Phillips screwdriver
                    
                      Wheel chock

Buy tools

Replacement: brake discs – SKODA Scala Schrägheck. AUTODOC recommends:

Replace the brake disks on the car SKODA Scala Schrägheck in complete set for each axis. Regardless of the state of components. This will ensure even braking.
The replacement procedure is identical for both brake disks on the same axle.
When changing the brake discs, always replace the brake pads.
All work should be done with the engine stopped.

Carry out replacement in the following order:

Step 1

Open the bonnet.

Step 2

Unscrew the brake fluid reservoir cap.

Step 3

Secure the wheels with chocks.

Step 4

Loosen the wheel bolts. Use wheel impact socket #17. Use a tap wrench.
Step 5

Raise the car.

Replacement: brake discs – SKODA Scala Schrägheck. Tip:
If you are using a jack, make sure it rests on a flat surface without any unevenness.Be sure to additionally secure the car with jack stands.
Step 6

Unscrew the wheel bolts.

AUTODOC recommends:
Important! Hold the wheel while unscrewing the fastening bolts. SKODA Scala Schrägheck
Step 7

Remove the wheel.
Step 8

Clean the brake caliper fasteners. Use a wire brush. Use WD-40 spray.
Step 9

Unscrew the brake caliper fasteners. Use a combination spanner #13. Use a combination spanner #15.
Step 10

Remove the fastening bolts.
Step 11

Remove the brake caliper. Use a crowbar.

AUTODOC recommends:
Tie the caliper to the suspension or to the body with a wire without disconnecting from the brake hose to prevent depressurization of the brake system.Make sure that the brake caliper is not hanging on the brake hose.Don't press the brake pedal after the brake caliper has been removed. As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur.
Step 12

Remove the brake pads.
Step 13

Clean the brake caliper bracket fasteners. Use a wire brush. Use WD-40 spray.
Step 14

Unscrew the brake caliper bracket fasteners. Use HEX No.H8. Use a ratchet wrench.
Step 15

Remove the fastening bolts.
Step 16

Remove the brake caliper bracket.
Step 17

Clean the brake disc fastener. Use a wire brush. Use WD-40 spray.
Step 18

Unscrew the brake disc fasteners. Use an impact screwdriver. Use a hammer.
Step 19

Remove the fastening bolt.
Step 20

Remove the brake disc.
Step 21

Clean the wheel hub. Use a wire brush.
Step 22

Treat the contacting surface. Use ceramic grease.
Step 23

Install a new brake disc.
Step 24

Install the fastening bolt.
Step 25

Tighten the brake disc fasteners. Use a Phillips screwdriver. Use a torque wrench. Tighten it to 4 Nm torque.
Step 26

Clean the brake caliper bracket of dirt and dust. Use a wire brush. Use a brake cleaner.

Replacement: brake discs – SKODA Scala Schrägheck. AUTODOC experts recommend:
Check the brake caliper bracket, brake caliper guide pins and boots. Clean them. Replace, if necessary.
Step 27

Install the brake caliper bracket.
Step 28

Install the fastening bolts.
Step 29

Tighten the brake caliper bracket fasteners. Use HEX No.H8. Use a torque wrench. Tighten it to 65 Nm torque.
Step 30

Treat the brake caliper piston. Use a nylon cleaning brush. Use a brake cleaner.
Step 31

Press in the brake caliper piston. Use brake caliper wind back tool.
Step 32

Treat the brake pads in the area where their surface comes into contact with the brake caliper bracket. Use anti-squeal paste.
Step 33

Install the brake pads.
Step 34

Install the brake caliper.
Step 35

Install the fastening bolts.
Step 36

Tighten the brake caliper fasteners. Use a drive socket #13. Use a torque wrench. Tighten it to 35 Nm torque.
Step 37

Treat the surface where the brake disc contacts the wheel rim. Use ceramic grease.
Step 38

Clean the brake disk surface. Use a brake cleaner.
Step 39

Install the wheel.

AUTODOC recommends:
To avoid injury, hold up the wheel when screwing in the fastening bolts.
Step 40

Screw in the wheel bolts. Use wheel impact socket #17. Use a ratchet wrench.
Step 41

Lower the car and working in a cross order, tighten the wheel bolts. Use wheel impact socket #17. Use a torque wrench. Tighten it to 120 Nm torque.
Step 42

Remove the jacks and chocks.

AUTODOC recommends:
Without starting the engine, press the brake pedal several times until you feel significant resistance.Important! Replacement: brake discs – SKODA Scala Schrägheck. Check the brake fluid level in the reservoir and top up if necessary.
Step 43

Tighten the brake fluid reservoir cap.

Step 44

Close the bonnet.