
How to change rear ABS sensor on VAUXHALL Vivaro Van (X83) – replacement guide
VAUXHALL Vivaro Van (X83) 2.0 CDTI, VAUXHALL Vivaro Van (X83) 2.0 CDTI, VAUXHALL Vivaro Van (X83) 2.5 CDTI, VAUXHALL Vivaro Van (X83) 2.0 ECOTEC … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle

- All the work should be carried out with the ignition switched off.
- Step 1
Raise the vehicle or place it over an inspection pit.
Warning!If you are using a jack, make sure the car is parked on a hard, flat surface.Make sure to additionally secure the car with jack stands.
Step 2
Clean the ABS sensor fastener. Use a wire brush. Use WD-40 spray.
- Step 3

Unscrew the ABS sensor fastener. Use a T30 Torx bit. Use a ratchet wrench.
- Step 4

Remove the fastening bolt.
- Step 5

Remove the ABS sensor. Use a mounting lever.
- Step 6.1

Detach the ABS sensor wiring.
Step 6.2
Detach the vehicle connector from the ABS sensor connector.
Step 6.3
Remove the ABS sensor connector from its mounting seat on the vehicle. Use a slotted screwdriver.
- Step 7

Clean the ABS sensor mounting seat. Use a wire brush. Use an all-purpose cleaning spray. Use a wire bore brush drill attachment.
- Step 8

Treat the vehicle connector of the ABS sensor. Use an electronic spray.
Find out which tyre and wheel sizes are compatible with the VAUXHALL Vivaro Van (X83) model
Popular maintenance tutorials for Vauxhall Vivaro Van
Complete guides for changing the Wheel speed sensor on different VAUXHALL VIVARO models
Track expenses, manage logs, schedule replacements, and more.
Extend your engine's life: Avoid these 3 damaging factors | AUTODOC tips
What causes engine misfire? | AUTODOC
Top 7 Manual Transmission Mistakes to Avoid | AUTODOC Tips
DIY restoration of an old impact wrench
Most commonly replaced car parts on VAUXHALL VIVARO
































