
Disclaimer
How to change lambda sensor on OPEL ASTRA J Saloon – replacement guide
downloads:
14
Views:
299

Recommended replacement interval for the part category Lambda sensor : 100000 km
Important!
This replacement procedure can be used for:
OPEL ASTRA J Saloon 1.4, OPEL ASTRA J Saloon 1.4 LPG (69), OPEL ASTRA J Saloon 1.4 Turbo (69), OPEL ASTRA J Saloon 1.4 Turbo (69), OPEL ASTRA J Saloon 1.4 (69) … View more
The steps may slightly vary depending on the car design.
OPEL ASTRA J Saloon 1.4, OPEL ASTRA J Saloon 1.4 LPG (69), OPEL ASTRA J Saloon 1.4 Turbo (69), OPEL ASTRA J Saloon 1.4 Turbo (69), OPEL ASTRA J Saloon 1.4 (69) … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Lambda Sensor for ASTRA J Saloon and other OPEL models
Lambda sensor
Alternative products

Wire brush
WD-40 spray
Electronic spray
High-temperature ceramic grease
Torque wrench
Combination spanner #22
Flare nut wrench #22
Ratchet wrench
Thread tap
Fender cover
Replacement: lambda sensor – OPEL ASTRA J Saloon. AUTODOC experts recommend:
- After replacing the oxygen sensor, clear the trouble code from the electronic control unit and let the ECU adapt itself to the new sensor.
- Before getting down to work, start the engine and let it warm up to operating temperature.
- Please note: all work on the car – OPEL ASTRA J Saloon – should be done with the engine switched off.
Carry out replacement in the following order:
- Step 1Open the hood.Step 2Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.Step 3Lift the car using a jack or place it over an inspection pit.Step 4Clean the oxygen sensor fastener. Use a wire brush. Use WD-40 spray.
- Step 5Detach the oxygen sensor connector.
- Step 6Unscrew the oxygen sensor fastener. Use a flare nut spanner #22.
- Step 7Remove the oxygen sensor.
- Step 8Cut the thread for the new oxygen sensor. Use a thread tap. Use a ratchet wrench.
- Step 9Treat the oxygen sensor. Use high-temperature ceramic grease.Step 10Install the new oxygen sensor.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the OPEL Astra J Saloon (P10) model
Popular maintenance tutorials for Opel Astra J Saloon
Complete guides for changing the Oxygen sensor on different OPEL ASTRA models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your OPEL ASTRA J Saloon
View more
- How to tighten cylinder head bolts
- How to Fix a Squealing Belt: Causes & Solutions | AUTODOC Expert Tips
- Top 5 reasons why the suspension knocks | AUTODOC tips
- Understanding Airbag Light Warnings | Essential Tips for Car Safety
Most commonly replaced car parts on OPEL ASTRA
Time to replace parts? Get even better deals in our Shop app.

SCAN ME