Disclaimer
How to change fuel filter on BMW Z3 Roadster (E36) – replacement guide
downloads:
12
Views:
285
Recommended replacement interval for the part category Fuel filter : 12 month / 15000 km
Important!
This replacement procedure can be used for:
BMW Z3 Roadster (E36) 1.9i, BMW Z3 Roadster (E36) 1.8i, BMW Z3 Roadster (E36) 2.8i, BMW Z3 Roadster (E36) M3.2, BMW Z3 Roadster (E36) 1.9i, BMW Z3 Roadster (E36) 2.0i, BMW Z3 Roadster (E36) 1.9i, BMW Z3 Roadster (E36) M3.2, BMW Z3 Roadster (E36) 2.8i … View more
The steps may slightly vary depending on the car design.
BMW Z3 Roadster (E36) 1.9i, BMW Z3 Roadster (E36) 1.8i, BMW Z3 Roadster (E36) 2.8i, BMW Z3 Roadster (E36) M3.2, BMW Z3 Roadster (E36) 1.9i, BMW Z3 Roadster (E36) 2.0i, BMW Z3 Roadster (E36) 1.9i, BMW Z3 Roadster (E36) M3.2, BMW Z3 Roadster (E36) 2.8i … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Fuel Filter for Z3 Roadster (E36) and other BMW models
Alternative products

Wire brush
All-purpose cleaning spray
Fluid container
Drive socket # 5.5
Drive socket # 8
Drive socket # 10
HEX bit No.H5.
Ratchet wrench
Clip removal tool
Fender cover
Replacement: fuel filter – BMW Z3 (E36). Tip from AUTODOC experts:
- Ensure adequate ventilation of the workplace. Fuel vapors are poisonous.
- Please note: all work on the car – BMW Z3 (E36) – should be done with the engine switched off.
Carry out replacement in the following order:
- Step 1Open the fuel door.Step 2Unscrew the fuel filler cap.Step 3Open the bonnet.Step 4Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.Step 5
Lift the car using a jack or place it over an inspection pit. - Step 6
Unscrew the fasteners of the underbody cover panel. Use a drive socket #10. Use a drive socket #8. Use a ratchet wrench. - Step 7
Remove the clips of the underbody cover panel. Use a clip removal tool. - Step 8
Remove the underbody cover panel.Replacement: fuel filter – BMW Z3 (E36). Tip:Do not apply excessive force when removing the part. Otherwise you may damage it. - Step 9
Clean the fasteners of the fuel supply lines. Use a nylon cleaning brush. Use all-purpose cleaning spray. - Step 10
Prepare a container for fluids. - Step 11
Unscrew the fastener attaching the fuel supply line to the fuel filter housing. Use a drive socket #5.5. Use a ratchet wrench. - Step 12
Disconnect the fuel supply lines from the fuel filter. - Step 13
Clean the fuel filter mounting bracket. Use WD-40 spray. - Step 14
Loosen the fuel filter mounting. Use HEX No.H5. Use a ratchet wrench. - Step 15
Remove the fuel filter. - Step 16
Install a new fuel filter.Replacement: fuel filter – BMW Z3 (E36). Tip from AUTODOC:Remember, it is important not to mix up the input and output of the filter. Arrows on the filter indicate the direction of fuel flow.During installation, take care to prevent dust and dirt from getting into the fuel filter housing.BMW Z3 (E36) – It's important to only use high-quality filters. - Step 17
Connect the fuel supply lines to the fuel filter.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the BMW Z3 Roadster (E36) model
Popular maintenance tutorials for BMW Z3 Roadster
Complete guides for changing the Fuel filters on different BMW Z3 models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your BMW Z3 Roadster (E36)
View more
How to fix your car with AUTODOC CLUB
DIY manual gearbox restoration | Drivetrain restoration – Part 3
How to choose the right engine oil for your car | AUTODOC
What to do if your check engine light is on | AUTODOC tips
Most commonly replaced car parts on BMW Z3
Time to replace parts? Get even better deals in our Shop app.

SCAN ME


























