Important!

This replacement procedure can be used for:
VAUXHALL ZAFIRA Mk III (P12) 1.8 (75) … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Shock Absorber for ZAFIRA Mk III (P12) and other VAUXHALL models

Alternative products

Shock absorber

Replacement: suspension strut – VAUXHALL ZAFIRA Mk III (P12). List of the tools you'll need:

                      Wire brush
                    
                      WD-40 spray
                    
                      Brake cleaner 
                    
                      Copper grease 
                    
                      Torque wrench
                    
                      Combination spanner #17
                    
                      Combination spanner #18
                    
                      Drive socket # 18
                    
                      Drive socket # 21
                    
                      HEX bit No.H6
                    
                      HEX bit No.H7
                    
                      Wheel impact socket #17
                    
                      Ratchet wrench
                    
                      Hammer
                    
                      Pliers
                    
                      Water pump pliers
                    
                      Flat Screwdriver
                    
                      Hydraulic strut spring compressor
                    
                      Hydraulic transmission jack
                    
                      Fender cover
                    
                      Wheel chock

Buy tools

Replacement: suspension strut – VAUXHALL ZAFIRA Mk III (P12). AUTODOC recommends:

Both shock struts of the front suspension should be replaced simultaneously.
The replacement procedure is identical for the left and right shock struts of the front suspension.
Please note: all work on the car – VAUXHALL ZAFIRA Mk III (P12) – should be done with the engine switched off.

Carry out replacement in the following order:

Step 1

Open the bonnet.

Step 2

Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.

Step 3

Secure the wheels with chocks.

Step 4

Loosen the wheel mounting bolts. Use wheel impact socket #17.
Step 5

Raise the front of the car and secure on supports.

Step 6

Unscrew the wheel bolts.

AUTODOC recommends:
Warning! To avoid injury, hold the wheel while unscrewing the fastening bolts. VAUXHALL ZAFIRA Mk III (P12)
Step 7

Remove the wheel.
Step 8

Clean the stabiliser link fasteners. Use a wire brush. Use WD-40 spray.
Step 9

Unscrew the fastener connecting the stabilizer link to the shock strut. Use a combination spanner #17. Use a drive socket #18. Use a ratchet wrench.
Step 10

Remove the stabilizer rod.
Step 11

Clean the fasteners connecting the brake hose to the shock strut. Use a wire brush. Use WD-40 spray.
Step 12

Remove the fastener attaching the brake hose to the shock strut. Use pliers.
Step 13

Detach the brake hose from the shock strut.
Step 14

Disconnect the ABS sensor wiring.
Step 15

Clean the fasteners connecting the shock strut to the steering knuckle. Use a wire brush. Use WD-40 spray.
Step 16

Unscrew the fasteners connecting the suspension strut to the steering knuckle. Use a combination spanner #18. Use a drive socket #18. Use a ratchet wrench.
Step 17

Prop up the steering knuckle. Use a hydraulic transmission jack.
Step 18

Remove the shock strut mount cap.
Step 19

Remove the retainer of the shock strut upper mount. Use a flat screwdriver.
Step 20

Remove the fastening bolts.
Step 21

Disconnect the steering knuckle from the shock absorber strut.
Step 22

Remove the suspension strut.
Step 23

Set the shock absorber strut on the spring compressor tool.

Replacement: suspension strut – VAUXHALL ZAFIRA Mk III (P12). Tip from AUTODOC:
Note that when using a spring compressor, spring coils need to be securely gripped, compressing the spring on the opposite sides.Ensure the correct position of the spring in the retainer.Make sure that the spring coils tightly entered the lock handles.
Step 24

Compress the spring.
Step 25

Treat the shock strut rod. Use a wire brush. Use WD-40 spray.
Step 26

Remove the strut piston rod nut. Use HEX No.H7. Use a drive socket #21. Use a ratchet wrench.
Step 27

Remove the top strut mount.

AUTODOC recommends:
Replacement: suspension strut – VAUXHALL ZAFIRA Mk III (P12). Carefully inspect the mount, the boot, and the bump stop of the shock absorber. Replace if necessary.
Step 28

Remove the shock absorber dust cap and the bump stop.
Step 29

Release the coil spring.
Step 30

Remove the spring.
Step 31

Remove the old shock absorber from the hydraulic coil spring compressor.

Replacement: suspension strut – VAUXHALL ZAFIRA Mk III (P12). AUTODOC experts recommend:
Before installing a new shock absorber you should pump it manually 3-5 times.
Step 32

Install the new shock absorber on the hydraulic coil spring compressor.
Step 33

Install the spring on the shock absorber.
Step 34

Compress the spring.
Step 35

Install the mount, boot and bump stop onto a new shock absorber.
Step 36

Tighten the shock strut piston rod nut. Use HEX No.H6. Use a drive socket #21. Use a torque wrench. Tighten it to 65 Nm torque.

AUTODOC recommends:
Check to make sure the spring is positioned correctly. Avoid its misalignment.
Step 37

Treat the shock strut rod. Use copper grease.
Step 38

Decompress the spring.
Step 39

Remove the assembled shock strut.
Step 40

Clean the mounting seats of the shock strut. Use a wire brush. Use WD-40 spray.
Step 41

Install the shock strut into the wheel arch.
Step 42

Fix the shock absorber strut on the steering knuckle.

AUTODOC recommends:
VAUXHALL ZAFIRA Mk III (P12) – To avoid injury, hold the suspension strut while screwing in the fastening bolts.
Step 43

Install the fastening bolts.
Step 44

Install the retainer of the shock strut upper mount. Use water pump pliers.
Step 45

Install the shock strut mount cap.
Step 46

Remove the support from under the steering knuckle.

AUTODOC recommends:
Replacement: suspension strut – VAUXHALL ZAFIRA Mk III (P12). Lower the transmission jack smoothly, without jerks, to avoid damaging components and mechanisms.
Step 47

Tighten the lower fasteners connecting the shock strut to the steering knuckle. Use a combination spanner #18. Use a drive socket #18. Use a torque wrench. Tighten it to 120 Nm torque.
Step 48

Connect the ABS sensor wiring.
Step 49

Fasten the brake hose on the strut.
Step 50

Install the brake hose retaining clip. Use a hammer.
Step 51

Ιnstall the transverse stabilizer link.
Step 52

Tighten the fastener connecting the stabilizer link to the shock strut. Use a combination spanner #17. Use a drive socket #18. Use a torque wrench. Tighten it to 55 Nm torque.
Step 53

Treat the fasteners of the shock strut mount. Treat the steering knuckle fasteners. Use copper grease.
Step 54

Clean the wheel rim mounting seat. Use a wire brush.
Step 55

Treat the surface where the brake disc contacts the wheel rim. Use copper grease.
Step 56

Clean the brake disk surface. Use a brake cleaner.

AUTODOC recommends:
Replacement: suspension strut – VAUXHALL ZAFIRA Mk III (P12). After applying the spray, wait a few minutes.
Step 57

Install the wheel.

AUTODOC recommends:
Warning! To avoid injury, hold the wheel while screwing in the fastening bolts on the car. VAUXHALL ZAFIRA Mk III (P12)
Step 58

Screw in the wheel bolts. Use wheel impact socket #17.
Step 59

Lower the car and working in a cross order, tighten the wheel bolts. Use wheel impact socket #17. Use a torque wrench. Tighten it to 110 Nm torque.
Step 60

Remove the jacks and chocks.

Step 61

Remove the fender protection cover.

Step 62

Close the hood.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

Need New Tyres?

Find out which tyre and wheel sizes are compatible with the VAUXHALL Zafira Tourer Mk3 (C) (P12) model

Zafira C P12 tyre size

How to change rear shock absorbers on VAUXHALL ZAFIRA Mk III (P12) – replacement guide

Free download PDF
1.55 MB
How to change spark plugs on VAUXHALL ZAFIRA Mk III (P12) – replacement guide

Free download PDF
1.08 MB
How to change front anti roll bar links on VAUXHALL ZAFIRA Mk III (P12) – replacement guide

Free download PDF
1.39 MB
How to change engine oil and filter on VAUXHALL ZAFIRA Mk III (P12) – replacement guide

Free download PDF
1.53 MB
How to change air filter on VAUXHALL ZAFIRA Mk III (P12) – replacement guide

Free download PDF
849.92 KB
How to change headlight bulb on VAUXHALL ZAFIRA Mk III (P12) – replacement guide

Free download PDF
1.32 MB

How to change rear shock absorbers on VAUXHALL Zafira Mk II (B) (A05) – replacement guide

Free download PDF
1.56 MB
How to change front suspension strut on VAUXHALL Zafira Mk II (B) (A05) – replacement guide

Free download PDF
2.91 MB
How to change rear shock absorbers on VAUXHALL ZAFIRA Mk III (P12) – replacement guide

Free download PDF
1.55 MB
How to change front suspension strut on VAUXHALL Zafira Mk I (A) (T98) – replacement guide

Free download PDF
2.49 MB
How to change rear shock absorbers on VAUXHALL Zafira Mk I (A) (T98) – replacement guide

Free download PDF
1.6 MB
How to change suspension strut on a car – replacement tutorial

Universal

Free download PDF
1.53 MB

Unlock your car maintenance assistant!

Track expenses, manage logs, schedule replacements, and more.

The most common problems when buying a used car | AUTODOC

4K views

Published on: 10/11/2022
DIY rear axle restoration | Drivetrain restoration – Part 2

6K views

Published on: 07/11/2024
Don’t Replace, Restore: Fixing Damaged Threads at Home

8K views

Published on: 04/05/2023
7 signs of faulty fuel injectors | AUTODOC tips

9K views

Published on: 09/01/2025