
Disclaimer
How to change front brake pads on MERCEDES-BENZ C-Class T-modell (S203) – replacement guide
downloads:
0
Views:
14

Recommended replacement interval for the part category Brake pad set : 30000 km
Important!
This replacement procedure can be used for:
MERCEDES-BENZ C-Class T-modell (S203) C 320 (203.264), MERCEDES-BENZ C-Class T-modell (S203) C 270 CDI (203.216), MERCEDES-BENZ C-Class T-modell (S203) C 240 (203.261), MERCEDES-BENZ C-Class T-modell (S203) C 240 4-matic (203.281), MERCEDES-BENZ C-Class T-modell (S203) C 320 4-matic (203.284), MERCEDES-BENZ C-Class T-modell (S203) C 230 Kompressor (203.240), MERCEDES-BENZ C-Class T-modell (S203) C 280 (203.254), MERCEDES-BENZ C-Class T-modell (S203) C 280 4-matic (203.292), MERCEDES-BENZ C-Class T-modell (S203) C 230 (203.252), MERCEDES-BENZ C-Class T-modell (S203) C 270 CDI (203.216) … View more
The steps may slightly vary depending on the car design.
MERCEDES-BENZ C-Class T-modell (S203) C 320 (203.264), MERCEDES-BENZ C-Class T-modell (S203) C 270 CDI (203.216), MERCEDES-BENZ C-Class T-modell (S203) C 240 (203.261), MERCEDES-BENZ C-Class T-modell (S203) C 240 4-matic (203.281), MERCEDES-BENZ C-Class T-modell (S203) C 320 4-matic (203.284), MERCEDES-BENZ C-Class T-modell (S203) C 230 Kompressor (203.240), MERCEDES-BENZ C-Class T-modell (S203) C 280 (203.254), MERCEDES-BENZ C-Class T-modell (S203) C 280 4-matic (203.292), MERCEDES-BENZ C-Class T-modell (S203) C 230 (203.252), MERCEDES-BENZ C-Class T-modell (S203) C 270 CDI (203.216) … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Brake Pads for C-Class T-modell (S203) and other MERCEDES-BENZ models
Brake pad set
Alternative products

Wire brush
Nylon cleaning brush
WD-40 spray
Brake cleaner
Anti-squeal paste
Copper grease
Torque wrench
Drive socket # 12
Wheel impact socket #17
Ratchet wrench
Brake caliper wind back tool
Crow bar
Round-nose pliers
Wheel chock
Replacement: brake pads – MERCEDES-BENZ C-CLASS T-Model (S203). AUTODOC experts recommend:
- Perform the replacement of brake pads in complete set for each axis. This provides effective braking.
- The replacement procedure is identical for all brake pads on the same axle.
- Warning! Shut down the engine before starting any work – MERCEDES-BENZ C-CLASS T-Model (S203).
Carry out replacement in the following order:
- Step 1Open the bonnet. Unscrew the brake fluid reservoir cap.Step 2Secure the wheels with chocks.
- Step 3Loosen the wheel mounting bolts. Use wheel impact socket #17.
- Step 4Raise the front of the car and secure on supports.Step 5Unscrew the wheel bolts.Replacement: brake pads – MERCEDES-BENZ C-CLASS T-Model (S203). Tip from AUTODOC:To avoid injury, hold up the wheel when unscrewing the bolts.
- Step 6Remove the wheel.
- Step 7Detach the connector of the brake pad wear sensor. Use round-nose pliers.
- Step 8Clean the brake caliper fasteners. Use a wire brush. Use WD-40 spray.
- Step 9Unscrew the brake caliper fastening. Use a drive socket #12. Use a ratchet wrench.
- Step 10Spread the brake pads. Use a crowbar.
- Step 11Remove the brake caliper.Replacement: brake pads – MERCEDES-BENZ C-CLASS T-Model (S203). Professionals recommend:Tie the caliper to the suspension or to the body with a wire without disconnecting from the brake hose to prevent depressurization of the brake system.Make sure that the brake caliper is not hanging on the brake hose.Don't press the brake pedal after the brake caliper has been removed. As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur. Check the brake caliper bracket, brake caliper guide pins and boots. Clean them. Replace, if necessary.
- Step 12Remove the brake pads.AUTODOC recommends:Measure the brake disc thickness. Upon reaching the wear limit the part must be replaced.
- Step 13Remove the retaining springs of the brake pads. Use a crowbar.
- Step 14Clean the brake caliper bracket from dirt and dust. Use a wire brush. Use a brake cleaner.AUTODOC recommends:Replacement: brake pads – MERCEDES-BENZ C-CLASS T-Model (S203). After applying the spray, wait a few minutes.
- Step 15Install the retaining springs of the brake pads.
- Step 16Treat the brake pads in the area where their surface comes into contact with the brake caliper bracket. Use anti-squeal paste.Replacement: brake pads – MERCEDES-BENZ C-CLASS T-Model (S203). Tip:Make sure the disc surface is clean before installing the pads.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the MERCEDES-BENZ C-Class T-modell (S203) model
Popular maintenance tutorials for Mercedes S203
Complete guides for changing the Brake pad set on different MERCEDES-BENZ C-CLASS models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your MERCEDES-BENZ C-Class T-modell (S203)
View more
- DIY alternator repair | AUTODOC tips
- Don’t Replace, Just Polish! Headlight Restoration with AUTODOC
- Revitalize Your Car Interior: DIY Steering Wheel Cover with AUTODOC Tips
- What to do if your car’s bonnet won’t open | AUTODOC tips
Most commonly replaced car parts on MERCEDES-BENZ C-CLASS
Time to replace parts? Get even better deals in our Shop app.

SCAN ME