Disclaimer
How to change engine thermostat on VAUXHALL Corsa Mk II (C) Hatchback (X01) – replacement guide
downloads:
18
Views:
772
Recommended replacement interval for the part category Thermostat : 50000 km
Important!
This replacement procedure can be used for:
VAUXHALL Corsa Mk II (C) Hatchback (X01) 1.4 16V (F08, F68) … View more
The steps may slightly vary depending on the car design.
VAUXHALL Corsa Mk II (C) Hatchback (X01) 1.4 16V (F08, F68) … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Thermostat for Corsa Mk II (C) Hatchback (X01) and other VAUXHALL models
Alternative products

All-purpose cleaning spray
Torque wrench
Drive socket # E8
Torx bit T20
Torx bit T30
Ratchet wrench
Clic-R collar pliers
Seal scraper
Flat Screwdriver
Funnel
Fluid container
Microfibre towel
Fender cover
Replacement: engine thermostat – VAUXHALL CORSA Mk II (C) (W5L, F08). AUTODOC recommends:
- Check the condition of the coolant every time you replace the thermostat. Change the coolant if necessary.
- Please note: all work on the car – VAUXHALL CORSA Mk II (C) (W5L, F08) – should be done with the engine switched off.
Carry out replacement in the following order:
- Step 1Open the bonnet.Step 2Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.Step 3
Unscrew the fasteners of the air distribution housing assembly. Use Torx T20. - Step 4
Remove the air distribution housing assembly. - Step 5
Unscrew the engine cover fastener. Use Torx T30. Use a ratchet wrench. - Step 6
Unscrew the oil filler plug. - Step 7Remove the oil filler cap.Step 8
Cover the oil filler opening with a microfibre towel to prevent dirt and foreign objects from getting into the system. - Step 9
Remove the engine cover.AUTODOC recommends:Replacement: engine thermostat – VAUXHALL CORSA Mk II (C) (W5L, F08). Do not use excessive force when removing the part as this may damage it. - Step 10
Remove the microfibre towel from the oil filler opening. - Step 11
Install the oil filler cap. - Step 12
Unscrew the coolant reservoir cap. - Step 13Lift the car using a jack or place it over an inspection pit.Step 14
Clean the coolant drain plug. Use all-purpose cleaning spray. - Step 15
Prepare a container for fluids. - Step 16
Open the coolant drain tap. Use a flat screwdriver. - Step 17
Drain the coolant from the engine.Replacement: engine thermostat – VAUXHALL CORSA Mk II (C) (W5L, F08). Tip from AUTODOC experts:Caution! The coolant can be very hot.Wear gloves to prevent contact with hot liquid.All work should be done with the engine stopped. - Step 18Wait until the coolant has completely flowed out of the drain hole.Step 19
Close the coolant drain tap. Use a flat screwdriver. - Step 20Lower the car.Step 21
Loosen the coolant hose clamp. Use clic-R collar pliers. - Step 22
Detach the coolant hose. Use a flat screwdriver.Replacement: engine thermostat – VAUXHALL CORSA Mk II (C) (W5L, F08). Tip from AUTODOC:Caution! Coolant may leak out of the coolant lines and thermostat housing. - Step 23
Loosen the coolant hose clamp. Use clic-R collar pliers. - Step 24
Detach the coolant hose.Replacement: engine thermostat – VAUXHALL CORSA Mk II (C) (W5L, F08). AUTODOC recommends:Caution! Coolant may leak out of the coolant lines and thermostat housing. - Step 25
Cover the open end of the coolant hose with a microfibre cloth to prevent dirt and foreign objects from entering the system. - Step 26
Unscrew the thermostat housing fasteners. Use a drive socket #Е8. Use a ratchet wrench. - Step 27
Remove the thermostat housing. - Step 28
Remove the rubber strip. - Step 29
Cover the mounting seat of the thermostat housing with a microfibre cloth to prevent dirt and foreign objects from entering the system. - Step 30
Clean the mounting seats of the thermostat housing. Use a seal scraper. Use all-purpose cleaning spray. - Step 31
Remove the microfibre cloth from the mounting seat of the thermostat housing. - Step 32
Install the rubber strip. - Step 33
Install a new thermostat housing. - Step 34
Screw in the thermostat housing fasteners. Use a drive socket #Е8. Use a ratchet wrench.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the VAUXHALL Corsa Mk2 (C) Hatchback (X01) model
Popular maintenance tutorials for Opel Corsa B
Complete guides for changing the Thermostat housing on different VAUXHALL CORSA models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your VAUXHALL Corsa Mk II (C) Hatchback (X01)
View more
How to restore a steering wheel | AUTODOC tips
Why Checking Your Oil is Crucial for Engine Performance
BMW E30 Turbo Suspension Swap: Boost Your Handling | AUTODOC project
How to Order Car Parts Online: Avoid These 5 Common Pitfalls
Most commonly replaced car parts on VAUXHALL CORSA
Time to replace parts? Get even better deals in our Shop app.

SCAN ME




































