Recommended replacement interval for the part category Oil filter : 1 year / 22500 km

Important!

This replacement procedure can be used for:
VW LT 28-46 II Platform / Chassis (2DC, 2DF, 2DG, 2DL, 2DM) 2.5 TDI, VW LT 28-46 II Platform / Chassis (2DC, 2DF, 2DG, 2DL, 2DM) 2.5 TDI, VW LT 28-46 II Platform / Chassis (2DC, 2DF, 2DG, 2DL, 2DM) 2.5 TDI, VW LT 28-46 II Platform / Chassis (2DC, 2DF, 2DG, 2DL, 2DM) 2.5 TDI, VW LT 28-46 II Platform / Chassis (2DC, 2DF, 2DG, 2DL, 2DM) 2.5 TDI, VW LT 28-46 II Platform / Chassis (2DC, 2DF, 2DG, 2DL, 2DM) 2.5 SDI … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Oil Filter for LT 28-46 II Platform / Chassis (2DC, 2DF, 2DG, 2DL, 2DM) and other VW models

Oil filter

        Oil filter for LT 28-46 II Platform / Chassis (2DC, 2DF, 2DG, 2DL, 2DM) Diesel (75 hp)
      
        Oil filter for LT 28-46 II Platform / Chassis (2DC, 2DF, 2DG, 2DL, 2DM) Diesel (102 hp)
      
        Oil filter for LT 28-46 II Platform / Chassis (2DC, 2DF, 2DG, 2DL, 2DM) Diesel (90 hp)
      
        Oil filter for LT 28-46 II Platform / Chassis (2DC, 2DF, 2DG, 2DL, 2DM) Diesel (109 hp)
      
        Oil filter for LT 28-46 II Platform / Chassis (2DC, 2DF, 2DG, 2DL, 2DM) Diesel (83 hp)
      
        Oil filter for LT 28-46 II Platform / Chassis (2DC, 2DF, 2DG, 2DL, 2DM) Diesel (95 hp)

Replacement: engine oil and filter – VW LT 28-46 II Platform/Chassis (2DC, 2DF, 2DG, 2DL, 2DM). Tools you might need:

                        Wire brush
                      
                        All-purpose cleaning spray
                      
                        Torque wrench
                      
                        Drive socket # 19
                      
                        Oil filter cup socket 76-14F
                      
                        Ratchet wrench
                      
                        Flat screwdriver
                      
                        Oil drain pan
                      
                        Funnel
                      
                        Fender cover

Buy tools

Replacement: engine oil and filter – VW LT 28-46 II Platform/Chassis (2DC, 2DF, 2DG, 2DL, 2DM). Tip from AUTODOC:

Replace the oil filter every time when changing motor oil.
Wear gloves to prevent contact with hot liquid.
Please note: all work on the car – VW LT 28-46 II Platform/Chassis (2DC, 2DF, 2DG, 2DL, 2DM) – should be done with the engine switched off.

Carry out replacement in the following order:

Step 1

Open the hood.

Step 2

Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.

Step 3

Unscrew the oil filler plug.
Step 4

Pull up the oil dipstick.
Step 5

Clean the oil filter housing cap. Use all-purpose cleaning spray.
Step 6

Unscrew the filter housing cap together with the old filter element. Use the 76-14F socket. Use a ratchet wrench.
Step 7

Take the oil filter out of its housing.
Step 8

Put the old oil filter in the container.
Step 9

Lift the car using a jack or place it over an inspection pit.

Replacement: engine oil and filter – VW LT 28-46 II Platform/Chassis (2DC, 2DF, 2DG, 2DL, 2DM). AUTODOC recommends:
The vehicle must be on even keel, and if it is at an angle, the drain plug must be at the lowest point.
Step 10

Put a waste oil container with at least 5 l capacity under the drainage hole.
Step 11

Clean the area of the oil pan drainage hole. Use a wire brush. Use all-purpose cleaning spray.
Step 12

Unscrew the drain plug. Use a drive socket #19. Use a ratchet wrench.
Step 13

Drain the used oil.

Replacement: engine oil and filter – VW LT 28-46 II Platform/Chassis (2DC, 2DF, 2DG, 2DL, 2DM). Tip:
Caution! The oil may be hot.
Step 14

Remove old o-rings from the oil filter cover. Use a flat screwdriver.
Step 15

Clean the oil filter housing cap. Use all-purpose cleaning spray.
Step 16

Install new O-rings and a new oil filter to their mounting seats on the filter cover.

Please note!
Make sure to install the filter correctly. Don't mix up the sides of the part.Wait until the oil has completely drained from the drainage hole.
Step 17

Clean the area of the oil pan drainage hole. Use all-purpose cleaning spray.
Step 18

Screw in the new drainage plug and tighten it. Use a drive socket #19. Use a torque wrench. Tighten it to 28 Nm torque.
Step 19

Clean the area of the oil pan drainage hole. Use all-purpose cleaning spray.
Step 20

Lubricate the rubber seal of the new filter with a little amount of fresh oil.
Step 21

Install a new oil filter housing cover and tighten it. Use the 76-14F socket. Use a torque wrench. Tighten it to 24 Nm torque.
Step 22

Lower the car.

Step 23

Remove the oil filler cap.
Step 24

Insert the funnel.
Step 25

Pour new oil into the engine in the amount recommended by the car manufacturer.

AUTODOC recommends:
Use the oil recommended by the manufacturer.
Step 26

Check the oil level using the dipstick. Top up oil if necessary.

Please note!
The oil level should be between the Min and Max marks.
Step 27

Install the oil filler cap.
Step 28

Tighten the oil filler cap.
Step 29

Run the engine for a few minutes. After the oil pressure warning light goes out, stop the engine.

AUTODOC recommends:
Note that oil pressure warning light, which indicates insufficient pressure in the lubrication system, may be on for a longer time than usual. After a few seconds, the oil will fill all the channels, and the light will go out.
Step 30

Check the oil level 5 minutes after the stop of the engine operation using a dipstick and add oil if necessary.

Please note!
The oil level should be between the Min and Max marks.Make sure that the oil filler cap is properly tightened.Check the threaded plug of the drainage hole and the oil filter seal for tightness. If necessary, carefully tighten them up.
Step 31

Remove the fender protection cover.

Step 32

Close the hood.

AUTODOC recommends:
To protect the environment from pollution, be sure to dispose of the used filters at special collection points.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

Searching for the right tyres?

Find out which tyre and wheel sizes are compatible with the VW LT 28-46 II Platform / Chassis (2DC, 2DF, 2DG, 2DL, 2DM) model.

Browse tyres

How to change fuel filter on VW LT 28-46 II Platform / Chassis (2DC, 2DF, 2DG, 2DL, 2DM) – replacement guide

Free download PDF
1.32 MB
How to change air filter on VW LT 28-46 II Platform / Chassis (2DC, 2DF, 2DG, 2DL, 2DM) – replacement guide

Free download PDF
1003.52 KB
How to change spark plugs on VW LT 28-46 II Platform / Chassis (2DC, 2DF, 2DG, 2DL, 2DM) – replacement guide

Free download PDF
1.81 MB
How to change front windshield wipers on VW LT 28-46 II Platform / Chassis (2DC, 2DF, 2DG, 2DL, 2DM) – replacement guide

Free download PDF
1.57 MB
How to change manual gearbox oil on VW LT 28-46 II Platform / Chassis (2DC, 2DF, 2DG, 2DL, 2DM) – replacement guide

Free download PDF
1.66 MB
How to change engine thermostat on VW Passat B7 saloon – replacement guide

Free download PDF
4.1 MB

How to change engine oil and filter on VW LT 28-35 I Minibus – replacement guide

Free download PDF
2.12 MB
How to change engine oil and filter on VW LT 28-46 II Van (2DA, 2DD, 2DH) – replacement guide

Free download PDF
1.63 MB
How to change engine oil and filter on VW LT 28-35 I Van (281-363) – replacement guide

Free download PDF
2.13 MB
How to change engine oil and filter on VW LT 28-35 II Bus (2DB, 2DE, 2DK) – replacement guide

Free download PDF
1.46 MB
How to change engine oil and filter on VW LT 28-35 I Platform / Chassis (281-363) – replacement guide

Free download PDF
2.13 MB
How to change engine oil and filter on VW LT 40-55 I Van (291-512) – replacement guide

Free download PDF
2.13 MB

Your profile is your personal assistant.

It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents

Install the AUTODOC CLUB app!

Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.

Scan

To download the app:

- scan the QR code
- download from App Store
- download from Google Play

How to swap the engine on a BMW E30 Turbo | SUPERCAR AUTODOC

2K views

Published on: 15/02/2021
Top 5 mistakes when working in the engine bay | AUTODOC tips

7K views

Published on: 04/08/2023
Headlight Restoration | AUTODOC tips

8K views

Published on: 13/01/2021
3 things that cause engine damage | AUTODOC tips

9K views

Published on: 07/10/2021