
Disclaimer
How to change engine oil and filter on SEAT Cordoba I Vario Box Body / Estate (6K5) – replacement guide
downloads:
0
Views:
6

Recommended replacement interval for the part category Oil filter : 12 month / 15000 km
Important!
This replacement procedure can be used for:
SEAT Cordoba I Vario Box Body / Estate (6K5) 1.9 TDI … View more
The steps may slightly vary depending on the car design.
SEAT Cordoba I Vario Box Body / Estate (6K5) 1.9 TDI … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Oil Filter for Cordoba I Vario Box Body / Estate (6K5) and other SEAT models
Oil filter
Alternative products

Wire brush
All-purpose cleaning spray
Torque wrench
Drive socket # 19
Oil filter cup socket 76-14F
Ratchet wrench
Flat screwdriver
Oil drain pan
Funnel
Fender cover
Replacement: engine oil and filter – SEAT Cordoba I Vario Kasten / Kombi (6K5). Tip from AUTODOC:
- Replace the oil filter every time when changing motor oil.
- Wear gloves to prevent contact with hot liquid.
- Please note: all work on the car – SEAT Cordoba I Vario Kasten / Kombi (6K5) – should be done with the engine switched off.
Carry out replacement in the following order:
- Step 1Open the hood.Step 2Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.Step 3Unscrew the oil filler plug.
- Step 4Pull up the oil dipstick.
- Step 5Clean the oil filter housing cap. Use all-purpose cleaning spray.
- Step 6Unscrew the filter housing cap together with the old filter element. Use the 76-14F socket. Use a ratchet wrench.
- Step 7Take the oil filter out of its housing.
- Step 8Put the old oil filter in the container.
- Step 9Lift the car using a jack or place it over an inspection pit.Replacement: engine oil and filter – SEAT Cordoba I Vario Kasten / Kombi (6K5). AUTODOC recommends:The vehicle must be on even keel, and if it is at an angle, the drain plug must be at the lowest point.Step 10Put a waste oil container with at least 5 l capacity under the drainage hole.
- Step 11Clean the area of the oil pan drainage hole. Use a wire brush. Use all-purpose cleaning spray.
- Step 12Unscrew the drain plug. Use a drive socket #19. Use a ratchet wrench.
- Step 13Drain the used oil.Replacement: engine oil and filter – SEAT Cordoba I Vario Kasten / Kombi (6K5). Tip:Caution! The oil may be hot.
- Step 14Remove old o-rings from the oil filter cover. Use a flat screwdriver.
- Step 15Clean the oil filter housing cap. Use all-purpose cleaning spray.
- Step 16Install new O-rings and a new oil filter to their mounting seats on the filter cover.Please note!Make sure to install the filter correctly. Don't mix up the sides of the part.Wait until the oil has completely drained from the drainage hole.
- Step 17Clean the area of the oil pan drainage hole. Use all-purpose cleaning spray.
- Step 18Screw in the new drainage plug and tighten it. Use a drive socket #19. Use a torque wrench. Tighten it to 28 Nm torque.
- Step 19Clean the area of the oil pan drainage hole. Use all-purpose cleaning spray.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the SEAT Cordoba I Vario Box Body / Estate (6K5) model
Popular maintenance tutorials for SEAT Cordoba I Vario Kasten / Kombi (6K5)
Complete guides for changing the Oil filters on different SEAT CORDOBA models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your SEAT Cordoba I Vario Box Body / Estate (6K5)
View more
- Top 5 car noises you shouldn't ignore
- DIY alternator repair | AUTODOC tips
- Regain Your Confidence on the Road: Easy Headlight Restoration Tips
- The Ultimate Guide to Engine Bay Cleaning | AUTODOC
Most commonly replaced car parts on SEAT CORDOBA
Time to replace parts? Get even better deals in our Shop app.

SCAN ME