Disclaimer
How to change engine oil and filter on DS DS 4 II – replacement guide
downloads:
7
Views:
76
Recommended replacement interval for the part category Oil filter : 12 month / 15000 km
Important!
This replacement procedure can be used for:
DS DS 4 II PureTech 225 (FP5GGT), DS DS 4 II PureTech 180 (F35GFT) … View more
The steps may slightly vary depending on the car design.
DS DS 4 II PureTech 225 (FP5GGT), DS DS 4 II PureTech 180 (F35GFT) … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Oil Filter for DS 4 II and other DS models
Alternative products

Wire brush
All-purpose cleaning spray
Torque wrench
Drive socket # 27
Torx bit T45
Ratchet wrench
Oil drain pan
Funnel
Flat Screwdriver
Fender cover
Replacement: engine oil and filter – DS DS 4 II. Tip from AUTODOC:
- Replace the oil filter every time when changing motor oil.
- Wear gloves to prevent contact with hot liquid.
- Please note: all work on the car – DS DS 4 II – should be done with the engine switched off.
Carry out replacement in the following order:
- Step 1Open the hood.Step 2Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.Step 3
Unscrew the oil filler plug. - Step 4Lift the car using a jack or place it over an inspection pit.Replacement: engine oil and filter – DS DS 4 II. Tip:The vehicle must be on even keel, and if it is at an angle, the drain plug must be at the lowest point.Step 5
Put a waste oil container with at least 5 l capacity under the drainage hole. - Step 6
Clean the area of the oil pan drainage hole. Use a wire brush. Use all-purpose cleaning spray. - Step 7
Unscrew the drain plug. Use Torx T45. Use a ratchet wrench. - Step 8
Drain the used oil.AUTODOC recommends:Caution! The oil may be hot.Wait until the oil has completely drained from the drainage hole. - Step 9
Remove the engine cover.AUTODOC recommends:Replacement: engine oil and filter – DS DS 4 II. Do not use excessive force when removing the part as this may damage it. - Step 10
Clean the oil filter housing cap. Use all-purpose cleaning spray. - Step 11
Unscrew the filter housing cap together with the old filter element. Use a drive socket #27. Use a ratchet wrench. - Step 12Prepare a container for the old oil filter. Put the old oil filter in the container.Replacement: engine oil and filter – DS DS 4 II. Professionals recommend:Move up the container. The oil starts to drain out of the drainage hole immediately after you have removed the oil filter.Step 13
Remove the oil filter cover O-ring. Use a flat screwdriver. - Step 14
Detach the oil filter from the filter cover. - Step 15
Clean the oil filter housing cap. Use all-purpose cleaning spray. - Step 16
Install a new O-ring to its mounting seat on the filter cover. - Step 17
Install the new oil filter to the mounting seat on the filter cover.Please note!Make sure to install the filter correctly. Don't mix up the sides of the part. - Step 18
Lubricate the rubber seal of the new filter with a little amount of fresh oil. - Step 19
Install a new oil filter housing cover and tighten it. Use a drive socket #27. Use a torque wrench. Tighten it to 25 Nm torque. - Step 20
Clean the area of the oil pan drainage hole.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the DS DS 4 II model
Popular maintenance tutorials for DS DS 4 II
Complete guides for changing the Oil filters on different DS DS 4 models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your DS DS 4 II
View more
The Ultimate Guide to Engine Bay Cleaning | AUTODOC
How to Fix P0401 ✅ error code Insufficient EGR flow
Top 5 possible reasons your car is shaking or vibrating
5 most common causes of oil leaks | AUTODOC tips
Most commonly replaced car parts on DS DS 4
Time to replace parts? Get even better deals in our Shop app.

SCAN ME





















