When to replace the Oil Filter on your CITROËN RELAY
Recommended replacement interval for the part category Oil filter : 1 year / 30000 km
Important!
This replacement procedure can be used for:
CITROËN JUMPER Bus (244, Z_) 2.0 bivalent, CITROËN JUMPER Bus (244, Z_) 2.2 HDi, CITROËN JUMPER Bus (244, Z_) 2.0 HDi, CITROËN JUMPER Bus (244, Z_) 2.0 View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Oil Filter for JUMPER Bus (244, Z_) and other CITROËN models
Alternative products
How to change Oil filter on CITROËN JUMPER Bus (244, Z_) 2.8 HDi – step-by-step instructions for straightforward car repair Oil filter
Tools
Replacement: engine oil and filter – CITROËN JUMPER Bus (244, Z_). List of the tools you'll need:
Wire brush
All-purpose cleaning spray
Oil filter cup socket 74/76-15F
Drive socket # 21
Ratchet wrench
Torque wrench
Oil drain pan
Funnel
Fender cover
Replacement: engine oil and filter – CITROËN JUMPER Bus (244, Z_). Tip from AUTODOC:
  • Replace the oil filter every time when changing motor oil.
  • All work should be done with the engine stopped.
  • Wear gloves to prevent contact with hot liquid.
Replacement: engine oil and filter – CITROËN JUMPER Bus (244, Z_). Recommended sequence of steps:
  1. Step 1
    Open the hood.
    Step 2
    Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.
    Step 3
    How to change Oil Filter on CITROËN JUMPER Bus (244, Z_) 2002 - free PDF and video manuals
    Unscrew the oil filler plug.
  2. Step 4
    How to replace CITROËN JUMPER Bus (244, Z_) 2.8 HDi 2003 Oil Filter - step-by-step manuals and video guides
    Unscrew the oil filter. Use the 74/76-15F socket.
  3. Step 5
    Prepare a container for the old oil filter. Put the old oil filter in the container.
    Replacement: engine oil and filter – CITROËN JUMPER Bus (244, Z_). AUTODOC experts recommend:
    Move up the container. The oil starts to drain out of the drainage hole immediately after you have removed the oil filter.
    Step 6
    Lift the car using a jack or place it over an inspection pit.
    Replacement: engine oil and filter – CITROËN JUMPER Bus (244, Z_). AUTODOC recommends:
    The vehicle must be on even keel, and if it is at an angle, the drain plug must be at the lowest point.All work should be done with the engine stopped.
    Step 7
    CITROËN JUMPER Bus (244, Z_) 2.0 HDi 2004 Oil Filter replacement: free workshop manuals
    Put a waste oil container with at least 5 l capacity under the drainage hole.
  4. Step 8
    Changing Oil Filter on CITROËN JUMPER Bus (244, Z_) 2.0 2005 by yourself
    Clean the area of the oil pan drainage hole. Use a wire brush. Use all-purpose cleaning spray.
  5. Step 9
    How to remove CITROËN RELAY 2.0 bivalent 2006 Oil Filter - online easy-to-follow instructions
    Unscrew the drain plug. Use a drive socket #21. Use a ratchet wrench.
  6. Step 10
    How to replace Oil Filter on CITROËN JUMPER Bus (244, Z_) 2007: download PDF manuals and video instructions
    Drain the used oil.
    Replacement: engine oil and filter – CITROËN JUMPER Bus (244, Z_). Professionals recommend:
    Caution! The oil may be hot.
  7. Step 11
    Wait until the oil has completely drained from the drainage hole.
    Step 12
    How hard is it to do yourself: Oil Filter replacement on CITROËN JUMPER Bus (244, Z_) 2.8 HDi Allrad 2008 - download illustrated guide
    Clean the area of the oil pan drainage hole.
  8. Step 13
    Need to know how to renew Oil Filter on CITROËN RELAY 2009? This free workshop manual will help you to do it yourself
    Screw in the new drainage plug and tighten it. Use a drive socket #21. Use a torque wrench. Tighten it to 34 Nm torque.
  9. Step 14
    Changing of Oil Filter on CITROËN JUMPER Bus (244, Z_) 2010 won't be an issue if you follow this illustrated step-by-step guide
    Clean the area of the oil pan drainage hole. Use all-purpose cleaning spray.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?

Find out which tyre and wheel sizes are compatible with the CITROËN Relay I Minibus (244) model

Unlock your car maintenance assistant!

Track expenses, manage logs, schedule replacements, and more.

DIY CITROËN JUMPER Bus (244, Z_) Oil Filter replacement - online guide
Tips & tricks for your CITROËN JUMPER Bus (244, Z_)
View more
  • How to change Oil filters on CITROËN JUMPER Bus (244, Z_) 2.2 HDi - replacement tricks
    #TPMS Explained: Why Your Light is On and How to Respond Safely
  • Changing Engine oil filter CITROËN JUMPER Bus (244, Z_) 2.8 HDi - Replacement Tips
    The Fast and Easy Way to Fix a Broken Wheel Stud | AUTODOC tips
  • Maintenance Hacks - CITROËN JUMPER Bus (244, Z_) 2.0 HDi Oil filters replacement guide
    How to choose the right engine oil for your car | AUTODOC
  • Replace Engine oil filter on CITROËN JUMPER Bus (244, Z_) - free video tips
    Reviving Your Car: How to Start After Extended Idle Time | AUTODOC Tips
Autodoc CLUB App icon
Time to replace parts? Get even better deals in our Shop app.
CITROËN JUMPER Bus (244, Z_) Oil Filter replace by yourself - Scan QR-code and download AUTODOC CLUB app
SCAN ME