Disclaimer
How to change rear shock absorbers on BMW 1 Hatchback (E87) – replacement guide
downloads:
11
Views:
98
Important!
This replacement procedure can be used for:
BMW 1 Hatchback (E87) 116i, BMW 1 Hatchback (E87) 116i, BMW 1 Hatchback (E87) 116 i, BMW 1 Hatchback (E87) 118 i, BMW 1 Hatchback (E87) 118 i, BMW 1 Hatchback (E87) 118 i, BMW 1 Hatchback (E87) 120i, BMW 1 Hatchback (E87) 120i, BMW 1 Hatchback (E87) 120i, BMW 1 Hatchback (E87) 120i, BMW 1 Hatchback (E87) 130i, BMW 1 Hatchback (E87) 130i, BMW 1 Hatchback (E87) 116d, BMW 1 Hatchback (E87) 118d, BMW 1 Hatchback (E87) 118d, BMW 1 Hatchback (E87) 118d, BMW 1 Hatchback (E87) 120d, BMW 1 Hatchback (E87) 120d, BMW 1 Hatchback (E87) 123d, BMW 1 Hatchback (E87) 116 d, BMW 1 Hatchback (E87) 118 i … View more
The steps may slightly vary depending on the car design.
BMW 1 Hatchback (E87) 116i, BMW 1 Hatchback (E87) 116i, BMW 1 Hatchback (E87) 116 i, BMW 1 Hatchback (E87) 118 i, BMW 1 Hatchback (E87) 118 i, BMW 1 Hatchback (E87) 118 i, BMW 1 Hatchback (E87) 120i, BMW 1 Hatchback (E87) 120i, BMW 1 Hatchback (E87) 120i, BMW 1 Hatchback (E87) 120i, BMW 1 Hatchback (E87) 130i, BMW 1 Hatchback (E87) 130i, BMW 1 Hatchback (E87) 116d, BMW 1 Hatchback (E87) 118d, BMW 1 Hatchback (E87) 118d, BMW 1 Hatchback (E87) 118d, BMW 1 Hatchback (E87) 120d, BMW 1 Hatchback (E87) 120d, BMW 1 Hatchback (E87) 123d, BMW 1 Hatchback (E87) 116 d, BMW 1 Hatchback (E87) 118 i … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Shock Absorber for 1 Hatchback (E87) and other BMW models
Alternative products

Wire brush
WD-40 spray
Brake cleaner
Copper grease
Combination spanner #16
Drive socket # 16
Drive socket # 17
Torx bit T25
Wheel impact socket #17
Ratchet wrench
Flat Screwdriver
Phillips screwdriver
Adjustable wrench
Crow bar
Hydraulic transmission jack
Wheel chock
Replacement: shock absorbers – BMW 1 (E87). Tip from AUTODOC:
- Both shock absorbers of the rear suspension should be replaced simultaneously.
- The replacement procedure is identical for the left and right shock absorbers of the rear suspension.
- Please note: all work on the car – BMW 1 (E87) – should be done with the engine switched off.
Carry out replacement in the following order:
- Step 1
Secure the wheels with chocks. - Step 2
Loosen the wheel mounting bolts. Use wheel impact socket #17. - Step 3Raise the rear of the car and secure on supports.Step 4
Unscrew the wheel bolts.AUTODOC recommends:Warning! To avoid injury, hold the wheel while unscrewing the fastening bolts. BMW 1 (E87) - Step 5
Remove the wheel. - Step 6
Support the stub axle. Use a hydraulic transmission jack. - Step 7Clean the shock absorber fasteners. Use a wire brush. Use WD-40 spray.Step 8
Unscrew the lower fastener of the shock absorber. Use a drive socket #17. Use a ratchet wrench. - Step 9Remove the fastening bolt.Step 10
Remove the support from under the stub axle.AUTODOC recommends:BMW 1 (E87) – Do not lower the transmission jack sharply to avoid damaging components and mechanisms of the car. - Step 11
Detach the lower part of the shock absorber. Use a crowbar. - Step 12Lower the car.Step 13Open the boot lid.Step 14
Remove the boot front lower lining. - Step 15
Remove the clips from the plastic boot sill guard. Use flat screwdrivers (2 pieces). - Step 16
Unscrew the fasteners of the plastic boot sill guard. Use a Phillips screwdriver. - Step 17
Remove the plastic door sill plate. - Step 18
Remove the cover of the boot side lining. - Step 19
Remove the clips of the boot side lining. Use a flat screwdriver. - Step 20
Unscrew the fastener of the boot side lining. Use Torx T25. Use a ratchet wrench. - Step 21
Remove the boot side lining. - Step 22
Remove the protective cap of the shock absorber mount. Use a flat screwdriver. - Step 23Clean the fasteners of the shock absorber upper mount. Use a wire brush. Use WD-40 spray.Step 24
Unscrew the upper fastener of the shock absorber. Use a combination spanner #16. Use an adjustable wrench.AUTODOC recommends:Important! Hold the shock absorber while unscrewing the fastening bolts. BMW 1 (E87) - Step 25
Remove the shock absorber. - Step 26Remove the shock absorber upper mount.Step 27
Remove the shock absorber dust cap and the bump stop.AUTODOC recommends:Replacement: shock absorbers – BMW 1 (E87). Carefully inspect the mount, the boot, and the bump stop of the shock absorber. Replace if necessary.Before installing a new shock absorber you should pump it manually 3-5 times. - Step 28
Install the dust sleeve and the bump stop on the new shock absorber. - Step 29Install the shock absorber upper mount.Step 30
Clean the shock absorber mounting seats. Use a wire brush. Use WD-40 spray. - Step 31
Place the shock absorber in the wheel arch and secure it.AUTODOC recommends:Important! Hold the shock absorber while screwing in the fastening bolts. BMW 1 (E87) - Step 32
Tighten the top shock absorber fastening. Use a combination spanner #16. Use a drive socket #16. Use a torque wrench. Tighten it to 27 Nm torque.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the BMW 1 Hatchback (E87) model
Popular maintenance tutorials for BMW E87
Complete guides for changing the Shock absorbers on different BMW 1 SERIES models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your BMW 1 Hatchback (E87)
View more
Why Is the Windscreen Washer Not Spraying? Solution
#DIY Guide: How to Fix a Cracked Windscreen Without a Garage Visit
Cold starts | 5 mistakes that wreck your car
Top 7 signs of a bad starter
Most commonly replaced car parts on BMW 1 SERIES
Time to replace parts? Get even better deals in our Shop app.

SCAN ME



































